It is required to design a knuckle joint to connect circular shafts subjected to an axial force of 50 kN. The rods are coaxial and a small amount of angular movement between their axes is permissible. Design the joint and specify the dimensions of its components. The allowable tensile, compressive and shear stress in the rod. and pin material is limited to 80MPa, 100 MPa and 40MPa respectively.

It is required to design a knuckle joint to connect circular shafts subjected to an axial force of 50 kN. The rods are coaxial and a small amount of angular movement between their axes is permissible. Design the joint and specify the dimensions of its components. The allowable tensile, compressive and shear stress in the rod. and pin material is limited to 80MPa, 100 MPa and 40MPa respectively.

Practical Management Science

6th Edition

ISBN:9781337406659

Author:WINSTON, Wayne L.

Publisher:WINSTON, Wayne L.

Chapter10: Introduction To Simulation Modeling

Section: Chapter Questions

Problem 41P: At the beginning of each week, a machine is in one of four conditions: 1 = excellent; 2 = good; 3 =...

See similar textbooks