422% @29:01* Asiacell li.HOMEWORK3.pdfHOMEWORKSQ1 Answer by True or False the follawing statement1- Kirchhoff's current law states that the current flowing into a node (or a junction)must be equal to the current flowing out of it.2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery.The total current for this circuit is 4 amperes.3- A junction where two (or) more than two network elements meet is known as anode+ The algebraic sum of voltages around any closed path in a network is equal toone5- The basic laws for analyzing an electric circuit are Newtons laws6- Relation between currents according to KCL for a node with two input current(Ih & ljand two outputs (l & la) is l-lztl+le07- A3-ohm and 6-ohm resistor are connected in parallel, and a 10-ohm resistor isin series with the combination. When 36 volts is applied to the three resistors,the total current in the circuit is 2 amps.8- KCL and KVL is limited to write two equations for a particular circuit.9. When assigning branch currents, you need not be concerned with the directionyou choose.10- For the cireuit shown below (Fig. ) the value of resistance is 17.5 otims5 ohm2A70 vohmR?Fig.1Q2/ For the cireuit shown in Fig.2 find l, Is, Is using KCL. and KVLR-222 aR.=560 2V-15 voltsV-27 voltsV-18 voltsFig 2

Since you have asked multiple questions in a single request, we will be answering only the first…

HOMEWORKS Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction) must be equal to the current flowing out of it. 2 A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery. The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as a node

HOMEWORKS Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction) must be equal to the current flowing out of it. 2 A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery. The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as a node

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Part 1 After using the UT33B multimeter to check the voltage of the batteries and the resistance of, light bulb and resistors, these are the results: - Voltage of the battery is measured to be 1608 mV, The scale used to measure voltage is 2000mV on the UT33B multimeter - Resistance of the bulb is measured to be 0.24 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter - Resistance of the resistor1 (R1) is measured to be 15.2 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter - Resistance of the resistor2 (R2) is measured to be 27.2 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter Part 2 After connecting a circuit to find the resistance of the light bulb and resistors experimentally using a circuit, these are the results: LIGHT BULB - Resistance of the light bulb and resistors could not be measured on the UT33B multimeter, so the voltage and current were measured and the resistance was found using ohms law.…
if the resistor R1 and R2 terminals are connected across each and R3 is connected along single terminal. If the R1=5 R2=10 and R3=15 ohms, what will be the Rtotal?
Please answer the "required" portion. Show full solutions with brief explanation. Required: - total resistance in the picture - type of circuit (either parallel-series or series-parallel) between terminals - AC - BC
3
Solve only 6 and 7:
In the circuit, Determine: a. the total resistance (R7) of the circuit in kl. (. . places for the final answer) b. the current flowing in mA for each of the resistors, R1, R2, R3 and R4 ( use 2 decimal places for the 12V final answer) c. the voltage in V across each of the resistors, R1, R2, R3 and R4 ( use 2 decimal places for the ; use 2 decimal R = 3000 R3 = 4000 R2 = 1000 R4 = 1ka %3! final answer)
Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction) must be equal to the current flowing out of it. 2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery. The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as a node 4- The algebraic sum of voltages around any closed path in a network is equal to one 5- The basic laws for analyzing an electric circuit are Newtons laws 6- Relation between currents according to KCL for a node with two input current (I1 & I2)and two outputs (I3 & l4) is I1-12+l3+l4=0 7- A 3-ohm and 6-ohm resistor are connected in parallel, and a 10-ohm resistor is in series with the combination. When 36 volts is applied to the three resistors, the total current in the circuit is 2 amps. 8- KCL and KVL is limited to write two equations for a particular circuit. 9- When assigning branch…
Based upon the following assumptions: V1 = 13V, V2 = 19V, R1 = 0.9kQ, R2 = 9300, R3 = 3kQ, R4 = 3.4kQ, R5 = 1.2k2. If R5 is the load resistor find VTH Answer in volts with 3 significant digits, only enter the number, don't enter the units. V1 V2
Step 5: Calculate the voltage across resistor R6 (VR6) [mV]. Use the resistance values from step 3 as follow R5 = 211.51ohm andR6 = 1420.86ohm. For the calculation of VR5 close Switch 1 and leave Switch 2 open. For the calculation of VR6 close Switch 2 and leave Switch 1 open. Use the circuit diagram of figure 1. Step 6: Calculate the maximum power absorbed by resistor R5 (PR5)[μW] and the maximum power absorbed by resistor R6 (PR6) [μW]. Use the resistance values from step 3 as follow R5= RTh(a,b) and R6 = RTh(b,c). Vs = 1.5V R1 = 4700ohm R2 = 2200ohm R3 = 6800ohm R4 = 2700ohm VR2 = 0.253V VR4 = 0.311V VR5 = 254mV
part a and b table too
1.5 Use KCL to find the values of , & for the circuit of following Figure, in which i=4, *=3. Which elements are connected in series in this circuit? A B "e FD