Q1 Answer by True or False the following statement1- Kirchhoff's current law states that the current flowing into a node (or a junction)must be equal to the current flowing out of it.2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery.The total current for this circuit is 4 amperes.3- A junction where two (or) more than two network elements meet is known as anode4- The algebraic sum of voltages around any closed path in a network is equal toone5- The basic laws for analyzing an electric circuit are Newtons laws6- Relation between currents according to KCL for a node with two input current(Ii & 12 )and two outputs (I3 & L4) is I-12+ls+1-07- A 3-ohm and 6-ohm resistor are connected in parallel, and a 10-ohm resistor isin series with the combination. When 36 volts is applied to the three resistors,the total current in the circuit is 2 amps.8- KCL and KVL is limited to write two equations for a particular circuit.9- When assigning branch currents, you need not be concemed with the directionyou choose.10- For the circuit shown below (Fig.1) the value of resistance is 17.5 ohms5 ohm2 A70 v7 ohmR?Fig.1

1.TRUE According to Kirchhoffs sum of current law current flowing into a node must be equal to the…

Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction) must be equal to the current flowing out of it. 2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery. The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as a node 4- The algebraic sum of voltages around any closed path in a network is equal to one 5- The basic laws for analyzing an electric circuit are Newtons laws

Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction) must be equal to the current flowing out of it. 2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery. The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as a node 4- The algebraic sum of voltages around any closed path in a network is equal to one 5- The basic laws for analyzing an electric circuit are Newtons laws

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What do you know about the voltage dividers and current divider circuits.How are they analyzed for finding the voltages between two points and current in an unknown branch,respectively.
Voltage sources in series Select one: a. None of the answers b. When two or more voltage sources are connected in parallel, the total voltage equals to the sum of all individual voltage sources c. When two or more current sources are connected in parallel, the total current equals to the sum of all individual current sources d. When two or more voltage sources are connected in series, the total voltage equals to the sum of all individual voltage sources e. When two or more current sources are connected in series, the total voltage equals to the sum of all individual voltage sources
2. From the figure, when the voltage V2 is 10 and 10 volts, the total voltage VD4 and VD6 is 0.7 volts. The voltage VD5 is 0.3 volts. The resistances R4, R5 and R6 are 9 5.1 and 15.1 ohms accordingly. Sequence Show how to calculate and answer the questions in the box. empty as follows D4 A D5 D6 R4 V2 R5 R6 When V2 equals 10 Volts 2.2 When V2 is equal to -10 Volts i Current flow through D4 : Answer.... : Current value Flow through D4 : Answer... .: Current flow through D5 : Answer.. Krahok fee stream flowing through D5 : Answer.. Current flow through D6 : Answer.. Current value Flow through D6 : Answer.... Current flow through R4 : Answer.. Current value Flow through R4 : Answer.... Current flow through R5 : Answer.. . Current value Flow through R5: Answer Current flow through R6 : Answer.. Current value Flow through R6 : Answer.... Current source V2 : Answer.. Current value Power supply V2 : Answer..
Choose the correct answer
Explain how this circuit diagram works. Note: When the circuit receives light, the motor begins to run, and when there is no light, the motor stops. This circuit is used for an automatic curtain that opens when there is sunlight and closes when there is no light.
What is the advantage of using the voltage divider technique in determining the voltage across a resistor from a series of resistors, compared to using Ohm’s law.
Part 1 After using the UT33B multimeter to check the voltage of the batteries and the resistance of, light bulb and resistors, these are the results: - Voltage of the battery is measured to be 1608 mV, The scale used to measure voltage is 2000mV on the UT33B multimeter - Resistance of the bulb is measured to be 0.24 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter - Resistance of the resistor1 (R1) is measured to be 15.2 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter - Resistance of the resistor2 (R2) is measured to be 27.2 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter Part 2 After connecting a circuit to find the resistance of the light bulb and resistors experimentally using a circuit, these are the results: LIGHT BULB - Resistance of the light bulb and resistors could not be measured on the UT33B multimeter, so the voltage and current were measured and the resistance was found using ohms law.…
1. Calculate the total resistance with uncertainty estimation, if the following resistors are R₁ = 10 k ± 5% and R₂ = 2.2k2 ± 10% are connected in series.
a. In the circuit shown in Figure below, what is the current i in amperes? Round-off answer to 2 decimal places and enter answer w/o units. b. In the circuit shown in Figure below, what is the current i3 in amperes? Round-off answer to 2 decimal places and enter answer w/o units. c. In the circuit shown in Figure below, what is the voltage V0 volts? Round-off answer to 2 decimal places and enter answer w/o units.
Solve only 6 and 7:
Three resistors R1,R2, and R3, are connected in series and to a 120-volt source. If R2 = 2R1, R3 = 3R1, and the total power taken by the circuit is 200 watts, calculate (a) the resistance of each resistor, ( b) the power in each resistor
Q2: In the Voltage Divider Cct., what is the effective of RE