2. The following resistors are connected in series 470 ohms, 680 ohms, 1 kiloohms and 1.2 kilo ohms. The votage is 20V. The current through the 680 ohms resistor is approximately.. 3. The inductance of an iron core decreases if the number of turns is 4. It is device that stores electric energy, previously called condenser.

2. The following resistors are connected in series 470 ohms, 680 ohms, 1 kiloohms and 1.2 kilo ohms. The votage is 20V. The current through the 680 ohms resistor is approximately.. 3. The inductance of an iron core decreases if the number of turns is 4. It is device that stores electric energy, previously called condenser.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

How temperature effect conductivity? Explain with the help of following equation. m e'n7'
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R1, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diode have? (Use constant voltage drop model for the Silicon diode) DI 14001 RL V onl O V 10 kN D2 IN4001 allle
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R1, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diode have? (Use constant voltage drop model for the Silicon diode) DI IN4001 RL out 10 kN D2 IN4001 allle lelll
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R1, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diode have? (Use constant voltage drop model for the Silicon diode) DI IN4001 R1 out OV 10 kN IN4001 elle lelll
Determine zener diode boltahe value as well as the ripple percentage of the circuit bellow with 240Vpp
If the charging resistor was twice as large as the discharging resistor in Figure 4, theamplitudes of the charging and discharging waveforms would be ________.a. The sameb. Different
Half-wave rectifier loaded with R-L is fed with a 120 VAA 60 Hz source. 10 Ω loadFind the inductance value that limits the average load current to 5A for the resistance.
Define ohms law
What is the value of the average voltage at the output of the circuit in the figure, knowing that: Voltage at the transformer output is equal to 5 Vac and the four diodes are from the 1N4001 family.
the non-inductive resistance of kelvin double bridge are set at 100ON each, the standard resistance is set at 0.10020 and the low resistance 0.0000122 was very low. determine the unknown resistance
Diodes Are Connected In Series To Share A Total... 21 Question • Two diodes are connected in series to share a total reverse voltage of VD=D 5 KV. Reverse leakage currents of the diodes are ID1=30 mA and Ip2=35 mA. - Find Vp1 and Vp2 for R,=R2=100 k2 - Find R, and R2 for VD1=VD2 R1 VD1 Hint: Is=L,+IRj= I,2+IR2 VD R2 VD2
I want explanation