Two (2) 115 V incandescent lamps A & B are connected in series across a 230 V source. If lamp A is rated 75 watts and lamp B is rated 50 watts. Determine the current drawn by the series connection.

Q: An alternating voltage is given by v1 = 75 sin( 200 Ttt -0.25 ) volts. What is the phase angle…

A: Phase angles Difference in degree= -45°

Q: A half-cycle average voltage of 20 V is equal to what ms voltage?

A: Given: Half cycle average voltage = 20 V

Q: V (Volts) 12V 30 18 42 t (ms) -12V

A: The waveform is shown below: (i) Peak value is the value of the maximum displacement of the wave…

Q: Is there a limit to the series voltage a chain of these batteries can achieve?

A: we need to explain given statement.

Q: What is the difference between alternating current (AC) and direct current (DC)?

A: Electricity is essential in modern civilization, powering a wide range of gadgets and processes. Its…

Q: V (Volts) 9V 12 20 28 t (ms) 4 -9V Figure 1

A: From waveform Peak value=9 volt Peak to peak value=9-(-9) Peak to peak value=18 volt

Q: Using a multimeter, what is VOUT Blank 1? (in Volts, up to 2 decimal places) 110 VRMS 60 Hz Sine…

A: In this question We need to determine the value of voltage of thr multimeter  We know In transformer…

Q: What value of direct current must flow through a resistor to produce the same heating power as an…

A: Given: Peak value of the alternating current, Im=3.5 A

Q: The number of currents alternating at different time intervals in an alternating current circuit are…

A:

Q: For the waveform of Figure, determinea) Period  I got 100us b) Frequency  I got 10kHz c)…

A: a) Given time = 525usNumber of cycles for 525us =  5 cycle + 1/4 cycle = 5.25 cycle.So period =…

Q: Two 115-V incandescent lamps A & Bare connected in series across 230-V de source. Lamp A is rated…

A: This problem is related to circuit theory. This is based upon the concept of incandescent bulbs…

Q: Why/how is a small 100OHMS source resistor used to measure the phase angle of current using the…

A: Oscilloscope- Oscilloscope is a device or output device which gives an output of the circuit in…

Q: What is factor of a cable at 5 degrees celcius when calculating resistance

A: The solution is provided in the following section.

Q: 19. What are the ms and peak currents for a 60 W bulb? (The ms voltage is the usual 120 V.) A. 0.71…

A:

Q: Which of the following arrangements of three identical incandescent bulbs DRAWS MOST CURRENT from…

A:

Q: Question Why a fuse is also important in our power supply

A: Given: Fuse is a very common electrical safety device. It protects the device from getting damaged…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,664 ohms R2 =…

A: inductive reactance = 2π×frequency×inductance. if two impedances Z1 and Z2 are connected in series…

Q: An alternating voltage, given by v = 100 sin 314t is connected in series with a diode. The average…

A: Given data, V=100sin314t

Q: in wind turbine, high watt range machines are used for and

A: It is asked what is the purpose to use high watt range machines in wind turbine. Generators…

Q: R1 1 ww- High voltage de supply C Us R2 10W 8 3W

A:

Q: If a voltage waveform has a peak voltage of 88.0V and 4.5% ripple, what is the minimum voltage

A: In this question we need to find the minimum voltage.

Q: If you reverse the flow of electricity in a converter, it then becomes an?

A: From the INVERTER concepts

Q: How would you describ the flow of Alternating Circuit (AC) and Direct Current?

A: In direct current (DC), the electric charge (current) only flows in one direction and it is…

Q: A voltage sources an IR drop across a 20 ohms R1, 60 volts across a 30 ohms R2, and 180 volts across…

A:

Q: A 5.3 V zener is rated at 1.5 watt. The maximum zener current is equal to a. 2.83 mA. O b. 283 mA. O…

A: In this question we need to find a maximum zener current .

Q: 7. An inductor is connected in a 240 volt, 60 Hz circuit. The circuit current is 2.5 If the…

A:

Q: A square wave that is 13 V at its on state and 0 V at its off state will produce an average DC…

A: Duty cycle = on period/time period. Using average value integral evaluate avarage value of the…

Q: Attempt Only if you are sure . a 24 V DC voltage source is controlled by a rotational potentiometer.…

A: Given data At θ=0°C, V0°C=24 V At θ=12°C, V12°C=10 V To find out We have to determine the voltage…

Q: For the waveform of Figure, determinea) Period  I got 95.45usb) Frequency  I got 10.476kHzc)…

A: a) Time for 5 cycle + 1/4 cycle is 525us5 cycle + 1/4 cycle = 5.25 cycleSo period = 525/5.25 = 100us…

Q: an ammeter has a range of (0-5a) and an accuracy of ±1% of f. s. d. what is the measured value for…

A:

Q: If a voltage surge lasts for 20 microseconds, what is the frequency of the surge?

A: Voltage surge is defined as sudden rise in voltage which is able to damage the installed electrical…

Q: A 10 Q2 resistor is connected in series to a parallel combination of a 60 resistor and a 20 resistor…

A: Given data, R1=10ohm R2=60ohm R3=20ohm V=220V

Q: A wire carries a triangular wave current with a maximum value of 10 amperes. What is the RMS of the…

A: A wire carries a triangular wave current with a maximum value of 10 amperes. What is the RMS of the…

Q: The suitable lamps for street lighting are O a. Mercury vapour lamps O b. Sodium discharge lamps Oc.…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.