Q1 Answer by True or False the following statement1- Kirchhoff's current law states that the current flowing into a node (or a junction)must be equal to the current flowing out of it.2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery.The total current for this circuit is 4 amperes.3- A junction where two (or) more than two network elements meet is known as anode4- The algebraic sum of voltages around any closed path in a network is equal toone5- The basic laws for analyzing an electric circuit are Newtons laws6- Relation between currents according to KCL for a node with two input current(Ii & I:)and two outputs (Is & 14) is I-12+ls+l4=07- A 3-ohm and 6-ohm resistor are connected in parallel, and a 10-ohm resistor isin series with the combination. When 36 volts is applied to the three resistors,the total current in the circuit is 2 amps.8- KCL and KVL is limited to write two equations for a particular circuit.9- When assigning branch currents, you need not be concerned with the directionyou choose.10- For the circuit shown below (Fig.1) the value of resistance is 17.5 ohms5 ohm2 A70 v7 ohmR?Fig.1

As per the guidelines, we supposed to answer first three part of the question at a time so please…

Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction) must be equal to the current flowing out of it. 2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery. The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as a node

Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction) must be equal to the current flowing out of it. 2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt battery. The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as a node

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. Calculate the total resistance with uncertainty estimation, if the following resistors are R₁ = 10 k ± 5% and R₂ = 2.2k2 ± 10% are connected in series.
Which of the following statements is true ? OA. Power is additive in series and parallel circuits. O B. A battery is a current source. OC. In a closed circuit, current leaves the positive terminal of a battery, and is used up by the time it reaches the negative terminal. O D. Current only flows through the path of least resistance.
3
1.Series parallel connection circuit a. Solve for the total value of resistance b. Solve for the value of current given 100Vdc c. Total Power Note: Duplication of the activity will be scored divided by the number of duplication.
B 12 V (+ 32 kn I, A 1 kM 2 kN 1 kN 2 mA D
Solve only 6 and 7:
In the circuit, Determine: a. the total resistance (R7) of the circuit in kl. (. . places for the final answer) b. the current flowing in mA for each of the resistors, R1, R2, R3 and R4 ( use 2 decimal places for the 12V final answer) c. the voltage in V across each of the resistors, R1, R2, R3 and R4 ( use 2 decimal places for the ; use 2 decimal R = 3000 R3 = 4000 R2 = 1000 R4 = 1ka %3! final answer)
Three resistors R1,R2, and R3, are connected in series and to a 120-volt source. If R2 = 2R1, R3 = 3R1, and the total power taken by the circuit is 200 watts, calculate (a) the resistance of each resistor, ( b) the power in each resistor
5. Consider the resistor network connecting points A and B in the figure be- low. What is the equivalent resistance between points A and B? If the potential difference between A and B is 12 volts, what is the current in the 4 2 resistor? What is the rate at which heat is produced in the 42 resistor? 1 12n
part a and b table too
6. You have a circuit with two resistors, labeled Alpha and Beta, in parallel connected to a battery. (The same type of circuit we tested in our previous lab.) The voltage drop across resistor Alpha is 9.50 V. Alpha has a resistance of 235.0 2 and resistor Beta has a resistance of 518.0 2, What is the voltage drop across resistor Beta?" a. b. What is the total voltage drop across the entire circuit?? c. What is the equivalent resistance for the entire circuit? 10dio
1.5 Use KCL to find the values of , & for the circuit of following Figure, in which i=4, *=3. Which elements are connected in series in this circuit? A B "e FD