Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction must be equal to the current flowing out of it. 2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt batter The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as node 4- The algebraic sum of voltages around any closed path in a network is equal one 5- The basic laws for analyzing an electric circuit are Newtons laws 6- Relation between currents according to KCL for a node with two input currer (I1 & I2)and two outputs (I3 & I4) is I1-12+I3+14=0 7- A 3-ohm and 6-ohm resistor are connected in parallel, and a 10-ohm resistor in series with the combination. When 36 volts is applied to the three resistor the total current in the circuit is 2 amps. 8- KCL and KVL is limited to write two equations for a particular circuit. 9- When assigning branch currents, you need not be concerned with the directio you choose. 10- For the circuit shown below (Fig.1) the value of resistance is 17.5 ohms 5 ohm 2 A 70 v 7 ohm R ?

Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the current flowing into a node (or a junction must be equal to the current flowing out of it. 2- A 20-ohm and 80-ohm resistor are connected in parallel across a 64-volt batter The total current for this circuit is 4 amperes. 3- A junction where two (or) more than two network elements meet is known as node 4- The algebraic sum of voltages around any closed path in a network is equal one 5- The basic laws for analyzing an electric circuit are Newtons laws 6- Relation between currents according to KCL for a node with two input currer (I1 & I2)and two outputs (I3 & I4) is I1-12+I3+14=0 7- A 3-ohm and 6-ohm resistor are connected in parallel, and a 10-ohm resistor in series with the combination. When 36 volts is applied to the three resistor the total current in the circuit is 2 amps. 8- KCL and KVL is limited to write two equations for a particular circuit. 9- When assigning branch currents, you need not be concerned with the directio you choose. 10- For the circuit shown below (Fig.1) the value of resistance is 17.5 ohms 5 ohm 2 A 70 v 7 ohm R ?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

15. Two resistors R1 and R2 are connected in series and parallel. The values of the resistances are Calculate the uncertainty in the combined resistance for both the series andthe parallel arrangement D) For series connection, 0.1044 ohms For parallel connection, 0.1338 ohms
QUIZ 1 I. TRUE OR FALSE: Write TRUE if the statement is correct; and if false, write NO and underline the WORD that makes the statement incorrect. 1. The voltage across a short is equal to the source voltage. 2. Most circuits in commercial and industrial electronics equipment are parallel circuits. 3. A parallel –- series circuit cannot be reduced to a single total or equivalent resistance. 4. The total current increases each time a lamp is added in a parallel circuit. 5. To produce any circuit to a single representative resistance, you start with the components nearest from the power source 6. The current across a short is zero. 7. The line current and voltage distribution of the voltage divider changes as the load changes. 8. The sum of the resistances determines the total amount of circuit voltage in a series resistive circuit. 9. Thevenin's and Norton's theorems can be used for circuit analysis by reducing a complex circuit to a simple equivalent circuit. 10. Copper wire is a…
Compare between the practical and theoretical.1 .results ? When do we need to use the current divider rule.2 Explain why the voltage is common in parallel.3 ?connection and different in series
ii) Given the circuit diagram in Figure 4, find the Vda and Vef voltages. 8 V 12 V 20 V 16 V 8 V 14 V 12 V 4 V Figure 4
Kirchhoff's Law Problem: Please show complete solutions with explanations.
Kindly also make sure the KCL and KVL loops are marked just so that i can understand better if possible thank you!
For the circuit shown in Figure B16a, R1 Si V1 3kQ 10 V R2 2k0 Ge R3 4 kQ 2V Figure B16a Calculate the following a) VI b) i c) i2 in
2k ohms 47 ohms Loop 2 +)av Loop 1 740 ohms Measure the voltage across each of the resistors. Apply Kirchhoff's Voltage Law on each of the loop. Resistor Measured Voltage 2k ohms 740 ohms 47 ohms Q4. What is the algebraic sum (considering the polarities of voltage) of the voltage around Loop 1? Q5. What is the algebraic sum (considering the polarities of voltage) of the voltage around Loop 2? Q6. Applying KVL around the outer loop (9V, 2k0, 470, and 9V), is the algebraic sum equal to 0?
Calculate the values of Voltages, Currents, and Resistances in the following Series- Parallel Circuit. Write and fill-in in the table the answers. V = 70 volts AM R1= 5 ohms ww R8= 6 ohms VT= V₁= V₂= V3= V4= V5= V6= V7= V8= V9= V10= V11= V12= V13= V14= V15= R9=5 ohms R2= 8 ohms ли M R7 = 12 ohms IT= I₁= I2= I3= I4= I5= 16= I7= I8= I9= I10= I11= I12= I13= I14= I15= R10=14 ohms M R3=5 ohms M RT= R₁= R₂= R3= R4= R5= R6= R7= R8= R9= R10= R11= R12= R13= R14= R15= M44 R11=7 ohms R12 10 ohms M R13-14 ohms M R14=14 ohms M R4 13 ohms M R15= 3 ohms ANL R6=13 ohms 44 M R5=7 ohms
1.Series parallel connection circuit a. Solve for the total value of resistance b. Solve for the value of current given 100Vdc c. Total Power Note: Duplication of the activity will be scored divided by the number of duplication.
Solve only 6 and 7:
Follow the instructions. Typewritten for an upvote. No upvote for handwritten. PLEASE SKIP IF YOU HAVE ALREADY DONE THIS. Thank you