he data pertaining to a stream-gauging site are given below. The rating equation of the current meter is v = 0.35Ns + 0.02 m/s where Ns =revolutions per second. Calculate the following: Round off your final answers to two decimal places, a. Discharge of the second segment? b. Velocity of the third segment? c. Discharge of the fourth segment? d. Velocity of the fifth segment? e. Discharge of the sixth segment? f. Total discharge?

Q: Calculate the discharge, in ft3/s, m3/s, and liter(s)/s of the stream according to the given…

A: The objective of the question is to calculate the discharge of a stream given the cross-sectional…

Q: Answer Four Questions 1. The discharge measured in a stream at various stage are given below. Plot…

A: To estimate the discharge at a stage of 9 meters, we will plot the given stage-discharge data and…

Q: In the context of a sewer system, your objective is to find the optimal slope (SS) of a pipe to meet…

A:

Q: Problem 5.5 One field party measured the following data (Table 5.12) using the current metering…

A:

Q: Compute the standard deviation of the data. Report your answer with two decimal places.

A:

Q: Compute the discharge of a river from the data given in table below. The current meter coefficients…

A: The dischrage is given by: Q=A×V Where, A = Cross sectional area = Width×Depth V = Velocity = n×a+b…

Q: The annual daily mean discharge data for USGS 08057000 (Trinity Rv at Dallas, TX) is shown in the…

A:

Q: The following are the data obtained in a stream- gauging operation. A current meter with calibration…

A:

Q: Gasoline (r.d%=0.68) is flowing. Calculate gage readings and flowrate. 0.6m D=300mm 3m 0.9m D=150mm

A:

Q: Calculate the total discharge throughout the section presented below, based on the measurements…

A:

Q: Time (hr) Q (cfs) OO 0 0 1 100 2 300 3 250 4 150 5 0 6 0 99.16

A: Given :Given the 2-Hour Unit Hydrograph construct a 3-Hour Unit Hydrograph using the S-Hydrograph…

Q: The annual daily mean discharge data for USGS Gage 08057000 (Trinity Rv at Dallas, TX) is shown in…

A: Given:Required:Median of the data

Q: The annual daily mean discharge data for USGS 08057000 (Trinity Rv at Dallas, TX) is shown in the…

A:

Q: A Venturi meter, 12 in. by 6 in., is installed in a vertical pipeline carrying water. A differential…

A: Given data :Venturi coefficient (Cd)=0.97Diameter at inlet (d1)=12 inDiameter at throat (d2)=6…

Quantity takeoff

Quantity takeoffs (QTO) are precise estimates of the materials and labor costs required to finish a construction project. During the pre-construction phase, an estimator prepares them, breaking down the project into smaller, more manageable parts that are easier to evaluate. These measurements are used to prepare a construction scope bid. Estimators examine the drawings, specifications, and models to figure out different quantities and their costs. Since, the components, their quantity, and price are all included in the model, quantity take-off can be done automatically using Building Information Modelling (BIM). The time taken for completing a construction project can be reduced by the use of quantity takeoff. These takeoffs are also called material takeoffs and construction takeoffs.