The 2-hr unit hydrograph is given in the table. Determine the 6-hr unit hydrograph. Use the given table. The last column of your data count as your final answer. time (hr) 2-hr UH (cfs) 1 15 2 21 18 14 6 7 8 9 10 11

The 2-hr unit hydrograph is given in the table. Determine the 6-hr unit hydrograph. Use the given table. The last column of your data count as your final answer. time (hr) 2-hr UH (cfs) 1 15 2 21 18 14 6 7 8 9 10 11

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Refer to the previous problem. Determine the time to empty the hemispherical bowl through the…

A: C = 0.60 r = 2m diameter of orifice = 50mm It has been asked in the question to determine the time…

Q: Solve the following loop to estimate water flows using the Hardy Cross method 20 100 =3 r-5 1=2 50…

Q: Answer fast

A: Detailed explanation: We must examine the suction head measurements recorded at five distinct times…

Q: Compute the discharge of a river from the data given in table below. The current meter coefficients…

A: The discharge is given by: Q=A×V Where, A = Cross sectional area = Width×Depth V = Velocity of river…

Q: Compute the standard deviation of the data. Report your answer with two decimal places.

Q: Ground surface Groundwater table (free surface) Direction aöndəəs yo Impervious layer A permeable…

Q: Compute the discharge of a river from the data given in table below. The current meter coefficients…

A: The dischrage is given by: Q=A×V Where, A = Cross sectional area = Width×Depth V = Velocity = n×a+b…

Q: 5. A finite difference flow model well. Is the model-predicted head likely to be higher or lower…

A: To determine flow rates, flow direction, and hydraulic heads through an aquifer, the finite…

Q: An orifice meter with bore diameter, Do is placed in a pipeline of diameter, D. The pressure drop,…

A: functional equation for the pressure drop ∆p=ϕV,D0,D,ρ ,μwhich in its general…

Q: 3 m P Lower reservoir 100 m 1 m Upper reservoir 10 m

Q: Question: How did you get 25400 on the numerator when solving for S(Potential maximum retention )?

A: S(Potential maximum retention )

Q: Using Penman-Kohler Nomograph, determine the daily evaporation from a lake for a day during which…

A: Using Penman-Kohler Nomograph, determine the daily evaporation from a lake for a day during which…

Q: How would we derive a solution for groundwater drawdown due to pumping near a river (i.e. a recharge…

A: Brief concept introduction- Groundwater- It is the water that is stored under the earth's crust.…

Q: Q1: Find the distance Z shown in the Figure below. O=30° {1 Bar=100 (KN/m2) and pw = 1000 (Kg/m³)}.…

A: "Since, you have asked multiple questions, we will answer first two questions for you (because they…

Q: the following data were recorded to determine the unit weight of water usung the direct method. the…

Q: Dry Unit Weight vs Water Content Water Content Dry Unit Weight, (w, %) Sample (v, N/m³) 1 10.45…

A: Ans. During compaction as we increase moisture content, dry density increase upto a certain value…

Q: The annual peak flow rates in a river between 1980 and 1996 are as follows: Year Peak flow Year Peak…

A: Annual peak flow rates in a river between 1980 and 1996:YearPeak flow,…

Q: Q#2:…

A: The discharge is given by: Q=A×V Where, A = Cross sectional area = Width×Depth V = Velocity = a×n+b…

Q: A mercury manometer used for measuring pressure difference indicates 50 cm head of Hg. This pressure…

A: Given- Pressure difference=50 cm head of Hg, Pressure difference in meters of water is required.

Q: is miven hy the difterer: between the two stream tunction Values. 1 stream function is given by y =…

Q: 5. Using 2D-diagram interprets the Groundwater system hydrologic budget below: (10points) I+ Gin –…

Q: A differential manometer is attached to pipe (φ=10cm) which deposites a volume of 5 drums an hour ,…

A: Initial part of This this question are already solved on bartleby I am extending that solution…

Q: Q3/ Determine the useful storage depth that used in hydroelectric power plant according to the…

A: The water levels in a reservoir are divided into:Maximum flood level(MFL): It is the highest water…

Q: A 2-hour unit hydrograph can be approximated as trapezium as shown in figure. The UH refers to…

A: Given- 2 hr unit hydrograph- Catchment area=?

Q: 4. GNEH: watER 250 2m 44m SUめMERCED RECTAN GULAR SURPAOE OF WIDTH W = : (m

Q: Determine the drag velocity in meter per seconds of a 5mm rainfall at sea level. Use the table…

Q: Two level sections 85 ft apart with center heights 4.3 and 7.9 ft in fill, base width 40 ft, side…

Q: Time-drawdown data collected at a distance of 30 m from a well pumping at a rate of 1000 m³/day are…

A: As Given Question contains multi-parts, hence as per the rule, only first three parts will be…

Q: The data in below table were obtained in a pressure build-up test on an oil well producing above the…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: B. Field Density Determination Volume of hole = 1900 cc Weight of dry soil from hole (field) = 2600…

A: Since you have posted questions with multiple sub-parts, we will solve the first three sub-parts for…

Q: Q3) the following information regarding isohytes was observed from the analysis of a storm.…

A: Average rainfall by isohyetal method is given by: Pav = Po+P12*Ao+P1+P22*A1+.......Ao+A1+......

Q: The table below show data collected from flow rate measurement experiment that was carried out using…

A: We will divide volume by time to calculate discharge.

Q: a. Find Q in [cfs] b. Draw the EGL and HGL for the system. Be precise when drawing so your graphs…

A: Elevation of Reservoir A= 120 ft Elevation of Reservoir B= 100 ft Pipe length of reservoir A=12800…

Q: Table 4.1 Flow Chart for liquid limit Water Content (%) 35 No. of Blows 34 28 37 21 39 15 41

Q: Samples of water are tested for total dissolved solids (TDS). TDS is normally distributed. The…

A: Given Data:TDS2480 2440 2400+34 2360+37 2320Frequency2335402221

Q: 1. Given below is a 2hour unit hydrograph. Derive 8 hr unit hydrograph by S curve method Time 0 2 8…

A: The ordinates of the 2 hr unit hydrograph is given,First we need to get S-curve ordinates then from…

Q: For the manometer in the figure, determine the difference in gage pressures between points A and B

A: Write the pressure equilibrium equiation between A and B ·When Going down the sign is positive…

Q: A concrete dam cross-section is given in the Figure. Check the stability of the dam

Q: use ripple diagram or cumulative mass curve ,estimate the active reservoir capacity to supply…

A: See explanation below:Explanation:Plot the cumulative mass curve using Python:import pandas as pd…

Q: Q2/Gage A shown in Figure No (2) reads 4 (Bar). Find the reading of Gage B. If the value of PA is…

A: Given data, PA = 4 Bar = 400 KN/m2 Pa = 150 KN/m2 Height of mercury = 1.2 m γwater = 9.81 KN/m3…

Q: The answers to the head loss and Ry are correct but Rx is wrong. Rx should be 170 N, could you try…

A: Given a 45 degree bend with one end open to atmosphere so Guage pressure at exit will be zero. Draw…

Concept explainers

Unit Hydrograph

Hydrology is the science which deals with the study of water on the earth’s surface. The word Hydrograph is derived from the word hydro which means water. Hydrograph is basically a graph in which the discharge is plotted against the time interval at a specific point in a river or other channel. In a hydrograph, the discharge is plotted along the y-axis and time interval is plotted along the x-axis. Hydrograph is used to estimate the runoff. The variations in discharges with the change in time is shown by a hydrograph. It was revealed that the total discharge at an outlet increases with time by a kinematic wave model.

Question

The 2-hr unit hydrograph is given in the table. Determine the 6-hr unit hydrograph. Use the given table. The last column of your
data count as your final answer.
time (hr)
2-hr UH (cfs)
1
15
21
3
18
4
8
19
10
11

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

30-min unit hydrograph is given in the table. Determine 60-min unit hydrograph. Must use table format as process details. time (min) 30 min UH (cms) 10 20 4 30 6 40 14 50 60 70 80 90 2. 2.
Errors in measurement
B4
Table Q4 shows the details of the storm hydrograph with the corresponding direct discharge. The given time interval is 3 hours between the readings. Q4 Table Q4 Excess rainfall (mm) 11 Time (hr) Direct discharge (m³/s) 3 70 28 230 9. 30 600 12 1400 15 2380 18 3300 21 4880 24 6320 27 3305 30 350 33 300 36 100 By using the convolution method, determine the unit hydrograph ordinates. (a) (b) Illustrate the unit hydrograph.
The storage in the reach of a stream has been studied. The values of x and K in Muskingum equation have been identified as 0.28 and 1.6 days. If the inflow hydrograph to the reach is as given below, compute the outflow hydrograph. Assume the outflow from the reach at 1 = 0 as 3.5 m³/s. Time (h) Inflow (m³/s) 6 12 18 24 30 35 55 92 130 160 140
Problem 7.7 A mixing basin in a sewage filtration plant is stirred by a mechanical agitator with a power input W = F. LIT. Other parameters describing the performance of the mixing process are the fluid absolute viscosity μ=F.T/Ľ², the basin volume = Ľ³, and the velocity gradient G=1/T. Determine the form of the dimensionless relationship.
Hydrology: i need the answer quickly i need all the steps, i need the answer in Handwritten.
10-A hydrograph resulting from two hour rain fall over an area of 370 km². Derive one hour unit hydrograph. 1 Time, hr Flow, m³/s 10 2 80 3 380 4 500 5 480 6 7 340 210 8 80 9 10
Problem 4: Approximating Discharge from Velocity Consider steady flow in a stream d = 0.50 m deep and w = 3.0 m wide ("into the page"): Part A Part B h X X The velocity distribution is u = Umax(1- h²/d²), where Umax = 0.20 m/s. A few sample values are shown in the following table: 0.25 h[m] 0 u [m/s] 0.20 0.15 ▼ Part A On the figure, sketch the velocity profile using the equation. No need to calculate points. Part B On the figure, sketch an approximate velocity profile, with an upper area and a lower area. Plot the average velocity for the upper area and the lower area (hint, recall the wedding cake). Part C Using your approximation, calculate the discharge Q [m³/s]. Part D Using your approximation, calculate the average velocity V[m³/s].
Estimate the water influx constant (B) for the following bottom-water-drive reservoir. Boundary pressure (at WOC) and water influx history data are as follows. Time (days) Boundary (psia) Cumulative Influx (1000RB) 30 60 90 120 150 180 210 240 pressure 3000 2956 2917 2877 2844 2811 2791 2773 2755 Water | 0 79 282 570 930 1354 1810 | 2287 2786 The reservoir is circular and has an approximate radius of 2000 ft. Other pertinent aquifer data include r,→, R = 2000 ft , h = 200 ft, k H= 50 md, k,= 2 md, µ = 0.395 cp, ¢ = 0.1, and c, = 8×10-6 psi!.
Which parameters do Barometer and Manometer measure? o Pressure difference; Atmospheric pressure o Pressure difference; Absolute pressure o Absolute pressure; Pressure difference o Atmospheric pressure; Pressure difference • What is the absolute pressure at location 1 (P1)? Ga OP = Pan + Pgh OP = Pan OP, - Pgh OP can not be calculated
How to find the area of the figure (2° figure) shown below, explain it..