Determine the line current,neutral current and total activepower in an unbalanced starconnected load supplied from asymmetrical three-phase, 440 Vsupply system. The branchimpedance of the load are ZR= 15 300 \Omega, ZW= 20 750 \Omega and ZB= 400 500 \Omega. The phasesequence is R-W-B.

Steps to Solve the Problem (with complete information):Convert Percentages to Ohms:Identify the…

Answered: Determine the line current, neutral…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Similar questions

The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three-phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT
An 11 kV generating station has four identical 3-phase alternatorsGl, G2, G3 and G4 each of L0 MVA capacity and l2%o reaclarce.There are two section of bus-bar P and Q, linked by a reactor X ratedat 10 MVA with 24o/oreactance. From section Q load is taken througha 6 MVA, i 1kV/66kV step-up transformer (T1) having a reactance of37o. Determine the fault current if a three-phase short-circuit occursnear the high voltage terminal of the transformer (F) as shown inFigure.Assume prefault voltages to be 1 pu and prefault currents to be zero
From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri = 120Vrms? %3D Np:Ns 6:1 D. Vp 120 Vac 60 Hz Vout R = 200 Q O 20Vrms O 720Vrms O 120Vrms O Ovrms wi m
Draw the complete circular stator winding for a three phase delta connected AC generator consisting of 4 poles and 24 slots using a parallel connection. Your submission must consist of two drawings as follows: One drawing must show the winding arrangement of the phasegroups in the slots of the stator highlighting the start and finish of each phasegroup The other drawing must show only the end connections of each phase group for a parallel connection of the phasegroups and a delta connection of the phases The use of AutoCad or any other software is encouraged.
Hi, Help me with this circuit question
Please show your complete work in the solution
Draw the complete circular stator winding for a three phase delta connected AC generator consisting of 4 poles and 24 slots using a parallel connection. Your submission must consist of two drawings as follows: One drawing must show the winding arrangement of the phasegroups in the slots of the stator highlighting the start and finish of each phasegroup The other drawing must show only the end connections of each phase group for a parallel connection of the phasegroups and a delta connection of the phases
Problem 1 - Series en Parallel AC networks [19] Look at the circuit in Figure 1 and determine the following: (a) Total Admittance. (b) Total Impedance. (c) Total Current (l:). (d) Current (I1) through impedance Z2. (e) Current (12) through impedance Z3. (f) Current (I3) through impedance Z4. (g) Is this an inductive or capacitive circuit? A. B Zs 220V;50HZ Figure 1 (h) Voltage across Z1. (i) Voltage across A and B. G) Voltage across Zs. Z1 = 3 + j5 ohm Z2 = 10 + jo ohm Z3 = 5 + j15 ohm Z4 = 10 – j30 ohm Zs = 20 – j30 ohm Admittance and Impedance in rectangular notation. All currents and voltage in polar notation. Take voltage as reference.
Does an open- operation, the kVA rating compared to that of the original thr-phase bank is (a) 2/3 (b) 58 (c) 1
The maximum size overcurrent device for primary only protection of a three-phase 75 kVA transformer with a 480V primary and a 120/208V secondary is Oa. 90A Ob.100A Oc 125A Od. 150A
A three phase power transformer having a line voltage ratio of 400 V to 33 kV is connected in star-delta. The C.T.s on 400 V side have current ratio as 1000/5. What must be the C.T. ratio on 33 kV side. Assume current on 400 V side of transformer to be 1000 A. C.T. secondaries in delta p 5A oooo oooo 5√3 A -0000 0000 0000 0000 Star-delta transformer 0000 5√3 A vooo னள். m reeee p C.T. secondaries in star 5√3 A 0000
The impedance Z1 = 6+j8, Z2 = 8 -j6 and Z3 = 10+j0 ohms measured at 50Hz from three branches of a parallel circuit. This circuit is fed from a 100-volt 50-Hz supply. A purely reactive (inductive or capacitive) circuit is added as the fourth parallel branch to the above three-branched parallel circuit so as to draw minimum current from the source. Determine the value of L or C to be used in the fourth branch and also find the minimum current.

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning