Cold rolled Annealed Gauge Length Original diameter Yield load 69mm 69mm 13.82mm 13.82 79kN 44.7kN Maximum load 95.6kN 64.2kN Final length between gauge points Diameter at fracture 88.9mm 93.2mm 9.11mm 7.09mm Results (to be computed) Cold rolled Annealed Yield stress Ultimate Tensile Stress (UTS) (MPa) Yield Strength (MPa) % Elongation (%) % Reduction in Area (%)

Cold rolled Annealed Gauge Length Original diameter Yield load 69mm 69mm 13.82mm 13.82 79kN 44.7kN Maximum load 95.6kN 64.2kN Final length between gauge points Diameter at fracture 88.9mm 93.2mm 9.11mm 7.09mm Results (to be computed) Cold rolled Annealed Yield stress Ultimate Tensile Stress (UTS) (MPa) Yield Strength (MPa) % Elongation (%) % Reduction in Area (%)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A high-density polyethelene (HDPE) [E = 780 MPa; v = 0.46] rod has a diameter of 100 mm before load P is applied. In order to maintain certain clearances, the diameter of the rod must not exceed 102 mm when loaded. What is the largest permissible compressive load P that can be applied to the HDPE rod? P. High-density polyethelene (HDPE) rod Answer: P = i P kN
Question.
7
A 3/8" fillet weld was deposited on a lap joint on 1/2" steel plate. The width of the face of the fillet weld measures 9/16". The maximum convexiy permitted on this deposited fillet weld is:
A 42 meter solid shaft is under torsional loading 53 Nm. If in this application, the allowable shear stress for the material is 369 MPa. Calculate the required minimum diameter of the shaft: _____ mm ( input the value directly from your calculation before rounding it up to an engineering accepted diameter) Pay attention to units, and calculate your answer to one decimal place.
Don't copy and complete solution please
Please show complete solution with complete FBD
Solve it civil problem
A hot rolled steel tension test sample has a diameter of 6 mm and the original gage length of 30 mm. In a test to fracture, the stress and strain data below were obtained. Determine Generic Strain Value, %0.2 offset strain, and Calculated stress at %0.2 offset. Original diameter - 6mm Original Length - 30 mm Fracture diameter - 4.54 mm
What is the allowable bending stress number, sat, in ksi, for grade 1 Steel Material flame - hardened 54 HRC?
How do I find the specimen’s final length and diameter
A high-density polyethelene (HDPE) [E = 780 MPa; v = 0.46] rod has a djameter of 70 mm before load P is applied. In order to maintain certain clearances, the diameter of the rod must not exceed 71 mm when loaded. What is the largest permissible compressive load P that can be applied to the HDPE rod? Answer: P = KN