b) A 208-V three-phase power system consists of an ideal 208-V Y- connected three-phase generator connected through a three phase transmission line to a Y-connected load. The transmission line has an impedance of 0.06 + j0.12 2 per phase, and the load has an impedance of 12 + j92 per phase. For this simple power system below; V-120-240° V-120-120° Find; V-12020⁰ 0.06 Ո 3.12 Ո www m 0.06 Ո mm 208 V j0.12 2 0.06 10.12 i) The magnitude of the line current I ii) The power factor of the load 1.4 7, Z=12+9

Q: In the transformer circuit shown, find the primary current I1 (Polar form, in Aprms). Refer all…

A:

Q: 7. For the circuit below, calculate the value of Zz for maximum average power transfer to the load.…

A: Calculate the value of Z for maximum average power tyansfer to the load. In addition, deternmine the…

Q: A balanced delta load of -j60 impedance is fed by a balanced three-phase generator of negligible…

A:

Q: A 3 phase, wye-connected salient-pole generator has on per phase basis Xd = 2 ohms, Xq = 1.5 ohms…

A:

Q: Determine the capacitor required to be connected in parallel with the motor so that the power factor…

A:

Q: A 3-phase synchronous generator has no-load line-to-line terminal voltage of 1KV. When the output…

A:

Q: 8. Two impedances, Z, = 0.8 + j5.6 Q and Zz = 8 - j16 Q, and a single-phase mot are connected in…

A: In this question we will find complex power for each impedance and total current and total power…

Q: 2) A 30- resistor, a 15-0 inductive reactance, and a 12- capacitive reactance are connected in…

A: In this question,  We need to determine the current in the each Branch, total current and impedance…

Q: VASSESSMENT PROBLEM Objective 5-Be able to analyze circuits with ideal transformers .15) The source…

A: Current in primary =1 I1=25kv∠01.5kΩ+j6*103=4.04∠-75.96o Secondary current is I1a  where a is turns…

Q: Zjine 1:10 10:1 |Vc = 13.84 0° kV Z1oad T1 T2 A 13.8-kV, single-phase generator supplies power to a…

A: The transformer has a primary and a secondary side. It converts electrical power to electrical power…

Q: A power station is to supply two loads. The daily load curves of two loads are shown in figure…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Q4) The three phase circuit seen in the following figure is derived by a three phase balanced…

A: the sinusoidal steady-state solution of the iR (t) current , and . the total complex power consumed…

Q: [04]: 3KVA 380/110V, 50Hz, Y/Y connected three-phase tr-r with per unity impedances referred to…

A: In this question we need to find the following the equivalent circuit impedance referred to…

Q: 1) In the system shown, the load is 80 KVA with a p.f. 0.85 lagging at 480 V voltage. Line impedance…

A: In this question,  We need to determine the real and reactive power delivered by the voltage source.…

Q: (b) A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical delta-…

A:

Q: 013: Choose the correct answer: 1. In a symmetrical three phase system the total instantaneous three…

A: The solution is given below

Q: Question 2 A Load ZL is connected in parallel with an impedance of -j120 Q. The parallel combination…

A: The solution is given below.

Q: Three Phase Power Factor Improvement Suppose that a shop is served with a three-phase, 400 V…

A: Given: Before power factor correction: After correction:

Q: uror Ab Hom end nas a fota Ear end, the voltage V, = 240 V and the current is 100 A at a pf of 0-8…

A:

Q: A symmetrical three-phase voltage source, wye connected with Van = 200 Vrms feeds a three phase load…

A:

Q: reactance of and 3-phase, star-connected alternator has a resistance of 0.5 2/phase and a…

A: Given Data: A three-phase, star-connected alternator with, Resistance per phase Ra=0.5 Ω…

Q: 3. A three phase source, 4-wire having a per phase voltage of 230V. An unbalanced load is connected…

A: I will appreciate your kind rate. Please assess my answer, and if there is any doubt, do not…

Q: Q. 2a) The impedance Zi and Z2 are connected in parallel across 200 V, 50 HZ single phase ac supply.…

A:

Q: Two three-phase transformers of equal voltage ratios are operating in parallel. The load draws a…

A: Given: load current IL=200∠-cos-10.9IL=200∠-25.84° AZ1=0.1+j0.3 ΩZ2=0.2+j0.5 Ω

Q: a) A three-phase star connected alternator supplies a star connected load. Given the supplied single…

A:

Q: What can you say about the flow of power as a function of time between a balanced three-phase source…

A: Concept: A definition of a function is that a relation from a set of inputs to a set of possible…

Q: 2. Given that Vs(t) = 100cos oot volts, f= 50 Hz, R₁ = 100 ohm, R₂ = 200 ohm, RL = 250 ohm, C = 40…

A: In this question,   We need to average power across the RL  Power P= I2 R Value of R and L for…

Q: Element X shown in the three-phase schematic is a pure reactive element. With this element…

A: " Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Suppose that a current source with Is amperes of current is connected in parallel to a pair of…

A: This is a basic problem of circuit.  The solution is given in the next step.

Q: Two identical Y‐connected alternators are running in parallel. The generated phase voltages  are: E1…

A: Given data E1=6.7 kV, E2=6.5 kV Here E2 is leading E1 by 10°, δ2=δ1+10°. Load current; IL=500∠-37° A…

Q: A balanced three-phase source of 4160 V is feeding a balanced three-phase induction motor through a…

A: source voltage V = 4160 V induction motor draws active power P = 400 KW power factor cosϕ = 0.8…

Q: The power factor angle of a three-phase synchronous generator rated at 10 kW, 230 V working at unity…

A: Let  ∅ be the power factor angle , then power factor = cos(∅)

Q: 14.20 A load consists of a resistance connected in parallel with a capacitive reactance is taking 20…

A:

Q: a. As an electrical engineer, explain about the power system in Figure Q2 with respect to the…

A:

Q: 4.3. Consider 3 ac loads connected across a 240V ac source where: L1 absorbs 10kW at 0.8pf laggin L2…

A:

Q: Q5/ A 3-phase, 415V, 4-pole, 50Hz star connected S.M has a synchronous impedance of 0.72+j6/phase.…

A: For a 3-phase star connected synchronous motor,Voltage, V=415 V.Pole, P=4.Frequency, f=50…

Q: 1.) A 6 pole, 75 Hz, 240 V, Y-connected, 3-phase generator has a synchronous reactance of 2 ohms and…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: 10 Ω j4 Ω + E₁ Μ ~) Vs 2:1 The Ioad on the right is absorbing 650 W - j200 VAR. V, = 80 / 0° V. I1…

A: Given in question, Power absorbed by the load and load voltage are, SL=650 W-j200 VARVL=80∠0° V we…

Q: Key = 93 ohm • Consider a single phase three wire power supply as shown in the figure below. This is…

A: In the circuit, 2 independent voltage sources are supplied to the three resistive load.    Find the…

Q: Q\Two 3-phase, 6.6kW, star-connected alternators supply a load of 300kW at 0.8 pf lagging. The…

A: In this question we need to find the current, power factor, induced emf and load angle of each…

Q: Referring to the rated values of the components in Figure Q.2, draw the impedance diagram with all…

A:

Q: A 20-pole alternator is having 180 identical stator slots with 6 conductors in each slot. All the…

A: Given- Alternator poles P=20, Number of slots in stator = 180, Number of conductors in each slot=6,…

Q: Shown are two buses connected via a transmission line. Connected to Bus 1 is a generator(modelled as…

A: The circuit can be redrawn as Load are given asSL=PL+jQL,SL=100+j60 MVA,Power share by the…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.