An experiment on the growth rate of certain organisms requires an environment of humid air enriched in oxygen. Three input streams are fed into an evaporation chamber to produce an output stream with the following composition. (A) Liquid water, fed at a rate of 20.0 cm³/min (B) Air (21% mole % 02, the balance N2) (C) Pure oxygen, with a molar flow rate one-fifth of the molar flow rate of stream B The output gas is analyzed and is found to contain 1.5 mole % water. Calculate the molar flowrate of all unknown stream variables.

An experiment on the growth rate of certain organisms requires an environment of humid air enriched in oxygen. Three input streams are fed into an evaporation chamber to produce an output stream with the following composition. (A) Liquid water, fed at a rate of 20.0 cm³/min (B) Air (21% mole % 02, the balance N2) (C) Pure oxygen, with a molar flow rate one-fifth of the molar flow rate of stream B The output gas is analyzed and is found to contain 1.5 mole % water. Calculate the molar flowrate of all unknown stream variables.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Photosynthesis is a process that incorporates carbon dioxide and water and yields food in the form of glucose (CGI-11206) for the plant with oxygen (02) as the by-product. In a (5) five minute period a tree consumes 45 grams of water and 60 grams of carbon dioxide in this process. Determine the limiting reagent, the excess reagent and the amount remaining of the excess reagent, and the amount of glucose produced, (Show all work for each section) (This is a limiting reagent problem). Determine the amount of glucose produced
8. 9. butane is consumed, and the product gas contains 9 mol CO2 per mol CO. Calculate the molar flow rate of water in the stack gas. Butane is completely burned in a process fed with 25.0% excess air. Based on 1 mol/h of butane, determine the composition in mole fractions of oxygen in product stream. Methane at a molar flow rate of 55 mol/min is burned with dry air. A partial analysis of the exit gas reveals that the mole fraction of nitrogen is 0.85 on a dry basis, and the molar flow rate of the dry exit gas is 600 mol/min. P
A drum 6 inches in diameter and 40 inches long contained acetylene at 250 psia and 80°F. After some of the acetylene was used the pressure was 200 psia and the temperature was 70°F (a) what portion of the acetylene was used, and (b) what volume would the used acetylene occupy at 14.7 psia and 60°F. R(acetylene) = 59.35 ft-lbf/lbm-R Answer: a. b. V = % mass
A gas mixture consists of 0.62 percent N, and 0.38 percent CO, by mole basis. Take 1 kg mole of the mixture and the molecular weight of N2 and CO2 are 28 and 44 kg/kg.mol respectively. Determine the (i) mole fractions of the constituents, (ii) mass fractions of constituents, (ii) the average molar mass of the mixture, and (iv) the average gas constant of the mixture. Take universal gas constant is 8.314 kJ/k mole.K. mole fraction of N2 mole fraction of CO2 Mass fraction of N2 Mass fraction of CO2 Molar Mixture Mixture gas constant
A water containing 50 mg/L of phosphate (PO,") is flowing in an open channel at a volumetric flow rate (Q) of 2 MGD (million gallons per day). (a) What is the concentration of phosphate expressed in (i) mg/L as PO, --P, (ii) mM as PO., and (iii) mM as PO, P. (b) Find the mass flow rate (S) of phosphate through any section perpendicular to the direction of flow in the open channel expressed in lb/day? Given: Atomic weights: P= 31 g/mole, O = 16 g/mole, 1 gallon = 3.785 L, 1 kg = 2.204 Ib. %3D
In the determination of molar mass of an unknown substance by ebullioscopic constant, 30 mL of acetone (C3H6O) was placed in a test tube with thermometer and glass tubing and subjected to water bath. Upon boiling, the temperature reads 56 deg C. For the boiling point of unknown-acetone solution, you prepared the solution by mixing 1.60 g of unknown solute in the 30 mL acetone and subjected it again to water bath. The boiling temperature of the solution is 56.68 deg C. The density of acetone = 0.9849 g/mL and the Kb of acetone = 1.67 degC/kg What is the value for delta Tb or the change in boiling temperature (in degrees Celsius)? Final answer must be rounded off to 2 decimal places, and shall NOT have any unit.
Q1- Methyl alcohol C,H,OH burns with excess air at an( air /fuel) ratio =10 (actual) ,determine the equivalence ratio and the mole fraction of N, in the product mixture.
Methanol (CH3OH) is produced in the reaction of carbon dioxide and hydrogen via the reaction and process given below: CO2+3H2→CH3OH+H2O The fresh feed to the process contains hydrogen, carbon dioxide, and 0.400 mol% inerts (I). The reactor effluent passes through a condenser that removes essentially all of the methanol and water formed and none of the reactants or inerts. The unreacted reactants and inerts are recycled to the reactor. To avoid buildup of the inerts in the system, a purge stream is withdrawn from the recycle. 100 mol/h of feed to the reactor (not the fresh feed to the process) contains 29.5 mol% CO2, 68.0 mol% H2, and 2.50 mol% inerts. The single-pass conversion of hydrogen is 46.71%. What is the recycle-to-fresh feed ratio?
Provide right solution clearly
Determine the volume (L) of hydrogen needed (based on room temperature 25 °C and l atm) to hydrotreat 1 liter crude oil with 1.8 wt % S to a sulfur content of 0.2 wt%. The oil has a specific gravity of 0.8 (compared to water). The stoichiometry follows the following reaction: Oil-S + 2H2¬→O¡I-H2 + H2S
Bb Blackboard Collaborate Ultra – 1 X Bb Collaborate - Live Tutorial Ses X O Mail - Jenna Lewis - Outlook G 0.615 ml to litres - Google Search x + 8 https://au.bbcollab.com/collab/ui/session/playback Not syncing O Instagram (11) Facebook In class questions: Q97: - Use the provided equation to calculate the following: KMNO, (aq) + HCI (aq) → MnCl, (aq) + Cl, (g) + H,0 (1) + KCI (aq) а. The moles of H,0 that can be obtained from 15.0 ml of 0.250 M HCI. b. The volume of 0.150 M KMno, needed to produce 0.0143 g MnCl,. С. The volume of 2.50 M HCI needed to produce 125 ml of 0.525 M KCI. 2KMNO, (aq) + 16HCI (aq) → 2MNCI, (aq) + 5Cl, (g) + 8H,0 (1) + 2KCI (aq) 01:36:12 01:59:28 [CC 9:14 AM O Type here to search 14°C Sunny 4) ENG 9/09/2021
What is the Molecular weight of a certain volatile liquid which is placed in 225 g flask which has total capacity volume of 251.74 ml where after the liquid was heated to 97.7 oC, the gas volatilized and the weight of the flask measured 227.26g.? Round you answer in one decimal place unit is NOT required