A drum 6 inches in diameter and 40 inches long contained acetylene at 250 psia and 80°F. After some of the acetylene was used the pressure was 200 psia and the temperature was 70°F (a) what portion of the acetylene was used, and (b) what volume would the used acetylene occupy at 14.7 psia and 60°F. R(acetylene) = 59.35 ft-lbf/lbm-R Answer: a. b. V = % mass

A drum 6 inches in diameter and 40 inches long contained acetylene at 250 psia and 80°F. After some of the acetylene was used the pressure was 200 psia and the temperature was 70°F (a) what portion of the acetylene was used, and (b) what volume would the used acetylene occupy at 14.7 psia and 60°F. R(acetylene) = 59.35 ft-lbf/lbm-R Answer: a. b. V = % mass

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: The ideal gas equation is PV=nRTPV=nRT where PP is pressure, VV is volume, nn is the number of…

A: The ideal gas equation is PV=nRT Where, P is pressure, V is volume, n is the number of moles, R is…

Q: Consider one mole of a real gas at 330 K packed into a container of 9.7 liters that obeys the van…

Q: A pioneer aeronaut is planning the design of a hot-air balloon. What volume of air, in m³, at 100°C…

Q: (a) Show that dq = nCvdT + nRT dV is an exact differential.

A: Dear learner,as per our guildeline I can solve one question at once further can be reposted.thanks.…

Q: 1) A lungful of air (337 cm3 ) is exhaled into a machine that measures lung capacity. If the air is…

A: 1) As per the given data we haveP1=1.88atm P2=0.958atmT1=42.10C(315.25K)…

Q: Given a gas sample with a Temperature of 298 K, a Pressure of 1.2 atm, and a molar quantity of 0.12…

Q: A truck tire has a volume of 218 L and is filled with air to 35.0 psi at 295 K. After a drive, the…

A: a.

Q: The maximum gas pressure that a 4.00 L experimental container can maintain without rupturing is 3.50…

A: The ideal gas equation is the equation, to determine the behavior of gas when it behave ideally.…

Q: A 1.25 gram sample of solid calcium carbide (CaC2) reacts with water to produce acetylene gas (C2H2)…

Q: Ethanol vapours were allowed to completely fill a jug with a volume of 18.9L. The ethanol was burned…

Q: 4. a) What is the osmotic pressure of an aqueous solution at 25°C if its freezing point is -2.1°C?…

A: Using relationship between different colligative properties to concentration we can calculate the…

Q: Combustible vapor-air mixtures are flammable over a limitedrange of concentrations. The minimum…

Q: The following reaction was carried out in a 3.00 reaction vessel at 1100 K: C(s) + H₂O(g) = CO(g) +…

A: The equilibrium constant of a chemical reaction is the value of its reaction quotient at chemical…

Q: 9. A cylinder is fitted with a moveable piston. A gas in the cylinder is heated up. If the pressure…

A: Volume of the cylinder is also increases slightly along with the pressure when a gas in the cylinder…

Q: When completely empty, a 4.5gallon [gal] tank weighs 118 newtons [N] on the Earth. Now on Mars,…

A: Given the weight of the empty tank on mars, Wtank = 118 N Now the tank is filled with oxygen gas(MW…

Q: Calculate the density of a mixture containing 90% air and 10% SO2 at a temperature of 150\deg C and…

A: Answer:Density form of ideal gas law is:Here:

Q: CO2 (g) + 2NH3 (1) → CO(NH2), (s) + H2O(1) This reaction models how urea fertilizer is produced from…

A: Number of mols = weight / molecular weight At S.T.P. 1 mol of any gas occupy the volume 22.4L

Q: what is the pressure inside the can?

Q: How many liters of chlorine gas at 25°C and 0.950 atm can be produced by the reaction of 15.0 g of…

A: We will begin by calculating the number of mole in 15.0 g of MnO2

Q: A chemist vaporizes a volatile liquid hydrocarbon (carbon, hydrogen and oxygen) compound to a gas…

Q: Ammonia is produced industrially by reacting N2 with H2 at elevated pressure and temperature in the…

Q: 5.31 A McLeod gauge measures low gas pressures by com- pressing a known volume of the gas at…

A: McLeod gauge is a scientific instrument which is used to measure the very low pressure . It work…

Q: What is the final volume?

A: Given :- initial volume = 6700 mL initial temperature = 320 k final temperature = 395 k To…

Q: What is the pressure of a gas (in units of torr) in an open-end mercury-based (Hg density = 13,593…

A: Answer:Open end manometer is a device that is used to measure the pressure in hydrostatics by the…

Concept explainers

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.

Question

A drum 6 inches in diameter and 40 inches long
contained acetylene at 250 psia and 80°F. After some of the
acetylene was used the pressure was 200 psia and the
temperature was 70°F (a) what portion of the acetylene was
used, and (b) what volume would the used acetylene occupy
at 14.7 psia and 60°F.
R(acetylene) = 59.35 ft-lbf/lbm-R
Answer: a.
b. V =
% mass

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Hot gaes Expanding A mixture hot gases expands, changing volume from 2.45 L to 6.82 L, against a constant pressure of 3.22 atm. The P-Vwork involved is Latm .
The combustion of propane, C,Hs, in a gas fuelled car, produces CO,, which is expelled from the exhaust pipe as gas (g): C,H 50 3CO, 4H,O What is the volume of CO, produced, during a day of summer, at the temperature of 40°C and a pressure of 99.5 kPa when 19.5 g of propane are burned in this reaction? (Note the molecular weight of C;H; is 44.1 g mol-). Select one: a. 24.0 m2 O b.31.2 dm O c 34.7 dm O d.4.71 m² O e 2.37 dm Finish attempt .. Previous page A Week 11 Student Feedback Jump to.. O QMplus Media A QMplus Hub Help & Support QMPLUS ARCHIVE LIBRARY LUELD G CU RRORT
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In another test, the valve of a 500 L cylinder full of the gas mixture at 2000 psi (gauge pressure) is opened wide so that the gas rushes out of the cylinder very rapidly. Why might some N2O condense during this process? (a) This is an isochoric process in which the pressure decreases, so the temperature also decreases. (b) Because of the rapid expansion, heat is…
i need answer in sig fig, thank you so much!
nR dT nRT -)dv dX where R (= 0.08206 atm-L/mol-K or 8.314 J/mol-K) is the gas constant; n is the number of mole, V is the volume and T is the temperature. av Determine the value of (in units of L (liter) and K (Kelvin)) when n = 4.00 mol, V = 114.8L and T = 350 K (with 3 significant figures). %3D
The average kinetic energy of the molecules in a gas sample depends only on the temperature, T. However, given the same kinetic energies, a lighter molecule will move faster than a heavier molecule, as shown in the equation for rms speed 3 RT rms speed %3D where R = 8.314 J/(mol-K) and M is molar mass in kilograms per mole. Note that a joule is the same as a kilogram-meter squared per second squared (kg-m²/s²). What is the rms speed of O, molecules at 411 K? rms speed: m/s What is the rms speed of He atoms at 411 K? rms speed: m/s