A tank containing 0.6 m deep of water is transported by an elevator. What is the pressure at the bottom of the tank when the elevator accelerates 2 m/s? downward? A. 7.09 kPa B. 6.32 kPa C. 4.69 kPa D. 5.25 kPa

A tank containing 0.6 m deep of water is transported by an elevator. What is the pressure at the bottom of the tank when the elevator accelerates 2 m/s? downward? A. 7.09 kPa B. 6.32 kPa C. 4.69 kPa D. 5.25 kPa

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

4. The siphon shown is 76 mm in diameter. It draws oil from a large tank. The loss of head up to the summit is 6 cm and from the summit to the exit is 23 cm of oil. a. Calculate the exit velocity. b. Calculate the pressure at the summit. 0.6 8.3 76- mm 0 siphon
INSTRUCTIONS: Solve for the following problems. 1. A container contains a certain liquid with unit weight of 7 KN/m³ to a depth of 4 m. Water is poured into the container and the total depth of the liquid is now 6 m. What is the gage pressure at the interface of the two liquids? a. 47.62 kPa b. 28 kPa a. 54.72 kPa c. 19.62 kPa 2. The absolute pressure of air in a water condenser is 40 kPaa. What is the gage pressure 1.5 m below the water surface? b. -46.61 kPa c. 156.04 kPa 3. What is the pressure at A in the figure shown. a. 32.56 kPa c. 38.26 kPa b. 40.89 kPa d. 43.25 kPa d. 21 kPa b. 11.25 m d. 10.00 m d. -63.89 kPa 4. If water is used to measure the atmospheric pressure how high would it I a. 9.81 m c. 10.33 m water d. 7,500 m 150 mm 450 mm sg.10 5. For the value of the atmospheric pressure at sea level used in engineering practice, evaluate about how high, in meters, is the atmosphere above sea level a. 8,500 m b. 10,000 m c. 9,500 m
A cylindrical tank of water is 20 m in diameter and 3.5 m tall. There is a 1.0 cm diameter hole at the bottom from which water is leaking. A feeder pipe at the top of the tank, 4.0 m above the ground delivers water at a rate of 0.02 m/min. Ir the tank is initially half full, tal what is the water flow rate in m^3/sec from the top feeder pipe? (bi what is the pressure at the bottom of the tank? (Hint: Bernoul's principle) () what is the water speed at the bottom? (d) what is the leaking flow rate at the bottom? fe) at what rate is the volume of water changing? (Assume the tank is open to air at the top)
Determine (a) the magnitude and (b) direction of the anchoring force needed to hold the horizontal elbow and nozzle combination shown in the figure below in place. Atmospheric pressure is 97.1 kPa. The gage pressure at section (1) is 103 kPa. At section (2), the water exits to the atmosphere. Assume p₁ = 103 kPa, V₁ = 4 m/s. (a) Kx = i 2260.24 (b) to the left N V₂ 160 mm Section (2) 300 mm V₁ Water Section (1) P1 V₁
Given the bulk modulus of water B-2.1x1o° Pa= 2.1 GPa, What increase in pressure needs to be applied to the surfaces of a cube of water 1 m on a side to reduce its volume by 4%? O a 0.0600 GPa Ob. None. O c.0840 GPa O d. 0.0700 GPa O e 0.1050 GPa
diameter = 60 cm height = 60 cm The CLOSE cylindrical tank is two-thirds full of water. It is subjected to pressure = 10 kpag. Considering that the tank is to rotate about the axis at the center at 10 rad/s a. What is the pressure at point C? b. What is the pressure at point D?
A vacuum pump is used to drain a flooded mine shaft of 68 °F (20 °C) water. The vapor pressure at this temperature is 1.34 psi, incapable of lifting the water higher than 400 inches (10.16m). Compute the atmospheric pressure. 65°F = 0.01604 ft3/lbm 70°F = 0.01605 ft3 /lbm
Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe length is 100 m. If the water pressure needs to be at a pressure of 1.6 atm on a lower level. What should be the different in elevation between the upper and lower levels in order to achieve this pressure? Take the density of water 1000 kg/m3 and gravity is 9.81 m/s2, consider the energy loss.
2.) A 90-mm circular orifice is situated 0.5 m from a bottom of a closed cylindrical tank 4 m high contains 2.5 m of water. In order to discharge water at 11 hp, what pressure of air (kPa) is required to be maintained in the air space?