A closed water tank 80cm high, 120cm long, and 50cm wide is to be transported. The acceleration is along the width of the water tank. If the horizontal acceleration is 3m/s^2, solve the maximum pressure in the tank if the water level is 75cm high prior to motion. O 8.13kPa O 7.85kPa O 9.76kPa O 6.51kPa

A closed water tank 80cm high, 120cm long, and 50cm wide is to be transported. The acceleration is along the width of the water tank. If the horizontal acceleration is 3m/s^2, solve the maximum pressure in the tank if the water level is 75cm high prior to motion. O 8.13kPa O 7.85kPa O 9.76kPa O 6.51kPa

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A block of mass m = 1 kg is released from the top of an inclined plane with a height h = 80 cm and a slope of 37 °. The kinetic friction coefficient between the block and the inclined plane is u = 0.3. Find the value (in J) of the work done by the friction force until the block reaches the bottom of the incline.
An open cylindrical vessel, 3m high and 1.5m in diameter is filled with water to a depth 2.5m. In its side is a 50mm circular orifice C = 0.60 placed 300mm above the bottom of the vessel. The vessel is rotated about its own axis at 60rpm and the water allowed to escape through the orifice for a period of 3 minutes. Determine the volume (V) of water allowed to escape through the orifice in cubic meters
h = 5.58 m An open cylindrical tank, 2 m in diameter and 4 m high contains water to a depth of 3m. It is rotated about its vertical axis with a constant angular speed w. (e) If wo=100in rpm, how much area at the bottom of the tank is uncovered? rpm SOLUTION:
A square tank 1.20m on each side, 3m deep is filled to a depth of 2.7m with water. A wooden cube having a specific gravity of 0.5 measuring 60cm on an edge is placed in the water so that it will float. Determine the depth of submergence of the cube in the water, the rise of water above the original liquid surface, and the distance of the bottom of the cube from the bottom of the tank.
An open cylindrical tank with a diameter of 37cm and 90cm high is partially filled with water. At what speed would it be rotated so that the pressure at the center of the bottom tank is zero? Ans, in rpm
An inverted CONICAL tank (D = 0.5 m, H = 1 m) is full of water. Find the pressure at the bottom of the tank if it is moving downward at 2 m/s^2.
P27
8. A vessel containing liquid, S = 1.3, is rotated about a vertical axis. The pressure at one point 0.6m radially from the axis is the same as at another point 1.2m from the axis and with elevation 0.6m higher. Calculate the rotational speed. Ans. 31.52rpm
9) Water flows in a rectangular channel of 5 m wide as shown in figure below. Calculate a) the force on the step. 9 = 5.1 m³/s/m b) the head loss through the jump y₁ = 5.56 m ! Y2 = ? Az=0.5m 3 ! y3 = 4.0 m 3-94
A rectangular tank 7m long by 2.4m deep and 2.65m wide, contains 1.2m of water.If the linear acceleration horizontal in the direction of the tank's length is 2.75m/s²a) Compute the total force due to the water acting on each end of the tankb) Show that the difference between these forces equals the unbalanced force necessary to accelerate the liquid massc) If the tank is filled with water and accelerate in the direction of its length at the rate 1.72m s³, how many litres of water are spilledd) What is the maximum acceleration should be to keep no water will spill out
Q34. A 10 cm diameter jet of water éxerts a force of 2 kN in the direction of flow against a stationary flat plate which is inclined at an angle of 30° with the axis of the stream. Find, (i) Force normal to the plate (ii) Velocity of the jet (1) Mass flow rate of water kg/sec. Answer
A 100-N 8.0-m uniform cantilever is installed as a diving board fixed to the ground using two support fulcrums. It is expected to accommodate divers with a maximum weight of 800 N. Determine the reactions (magnitude and direction) of the two support fulcrums A and B before the diver jumps off the end of the diving board? *