n open tank containing water isaccelerated vertically at 6.28 . IfAnm. Ifthe motion is downward withpositive acceleration, determine thepressure (kPa) 1.72 m below thesurface.

Assuming the atmospheric pressure to be equal to ZERO gage value. The change in pressure will…

Answered: An open tank containing water is…

An open tank containing water is accelerated vertically at 6.28 . If s2 the motion is downward with positive acceleration, determine the pressure (kPa) 1.72 m below the surface.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 8. The man is trying to push the homogeneous 20-kg ladder AB up a wall by applying the horizontal…

A: To determine the smallest value of P that would move the ladder, we need to consider the forces…

Q: A 90° elbow is used to direct water flow at a rate of 0,025 m/s in a horizontal pipe upward. The…

A: by continuity equation

Q: Find the (i) slope of the liquid surface, (i) Pressure at B, for the liquid contain subjected to…

Q: Problem 11: The uniform 7-m steel shaft has a mass of 200 kg and is supported by a ball and socket…

Q: 11.10 (A/B). A load of 2 kN falls through 25 mm on to a stop at the end of a vertical bar 4 m long,…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: W.S.V

Q: Consider a laminar flow in the x-direction between two infinite parallel plates (Couette flow). The…

A: Given: Flow between parallel plates Velocity of upper plate Distance between plates Dynamic…

Q: ne tank is filled with liquid with 1.0 specifi- d has a hole at point A. Inside the tank, a lloon…

A: According to given data The tank is filled with liquid with 1.0 specific gravity and has a hole at…

Q: Q3) A closed 0.4 m diameter cylindrical tank completely filled with oil (SG=0.9) rotates about its…

A: D = 0.4 m SG = 0.90 = 40 rad/s

Q: Solve ot A 30 m high vertical column of a fluid of density 1878 kg/m' exists in a place where g =…

A: Given data, Density ρ = 1878 kg/m3 Height h = 30 m g = 9.65 m/s2

Q: A horizontal water jet impinges against a vertical flat plate at 32 ft/s and splashes off the sides…

A: The velocity of jet, V = 32 ft/sec The density of water = 62.4 lbm/ft3 The horizontal force to hold…

Q: Q.36 A2 m wide tank contains water upto a height of 0.50 m above its base. An immiscible liquid of…

Q: the value of P and w are unknowns using DIM.

Q: determine the velocity of the ball just after the impact.

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

Q: Fig. 4 , a 2-in-diameter stream of water strikes a 4-ft-square door which is at an angle of 30° with…

A: The force exerted by the door on water will be normal to the door without friction. There are no…

Q: A steady laminar flow is taking place between two parallel plates. The distance between the plates…

Q: An open cylindrical vessel, 3m high and 1.50m in diameter is filled with water to a depth of 2.50m.…

A: we have to determine the volume of water allowed to escape through the orifice

Q: Determine the reactions.

Q: A horizontal water jet impinges against a vertical flat plate at 27 ft/s and splashes off the sides…

A: Horizontal water jet impinges against vertical flat plateVelocity of flow (V) = 27 ft/s Force…

Q: A vertical water jet is issuing upwards from a nozzle with a velocity of 10 m/s. The nozzle exit…

Q: An inverted CONICAL tank (D = 0.5 m, H = 1 m) is full of water. Find the pressure at the bottom of…

Q: A vertical water jet is issuing upwards from a nozzle with a velocity of 10 m/s. The nozzle exit…

Q: Calculate the rotational speed.

Q: Q34. A 10 cm diameter jet of water éxerts a force of 2 kN in the direction of flow against a…

Q: The velocity of water at the outer edge of a 60cm diameter whirlpool, where the water level is…

A: Given- Diameter d=60 cm, velocity=2.5 m/s,

Q: tank has one of its side inclined inward at an angle of 30° with horizontal. The free surface of the…

A: Giventhat Elevation 1 = 15.25m Elevation 2= 14m Elevation 3 = 10.7 m

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

n open tank containing water is
accelerated vertically at 6.28 . If
An
m
. If
the motion is downward with
positive acceleration, determine the
pressure (kPa) 1.72 m below the
surface.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An open rectangular tank mounted on a truck is 5 m long, 2 m wide and 2.5 m high is filled with water to a depth of 2 a.) What final velocity in kph can the truck achieve if it accelerated in 10 s so that the tank will not spill any water? b.) What is the maximum pressure experienced by the truck?
Explain
The barrel of oil rests on the surface of the scissors lift. Determine the maximum pressure developed in the oil if the lift is moving upward with (a) a constant velocity of 4 m/ s, and (b) an acceleration of 2 m/s2. Take po = 900 kg/m2. The top of the barrel is open to the atmosphere 1.25 m
with FBD PLS...
Situation 4: An open horizontal tank 2 m high, 2m wide and 4mlong is full of water. Determine the amount of water spilled out when the tank is accelerated horizontally at 2.45 m/s in a direction parallel with its longest side in m?. Find the force acting on the side with the greatest depth in kN. 9. 10.
Q
Fluid 5
Problem 3: Shipping Tool is moving.. M1 = 5.5 1 (2) 8₂ = 12° Air at Mach, M1 = 5.5 at a pressure of P1 = 70 kpa flows along a smooth curved wall bending away at an angle of 12°. Determine the Mach number, temperature, density, velocity, speed of sound and pressure, total pressure, and total temperature after the bend in region-2. M₂
The specific gravity of the manometer fluid is 1.52. Cv= 0.98. Determine the flow rate.