A singl core cable of voltage 30 kv. The diameter of Conductor is 3 cm. The diameter of cable is 25 cm. This cable has Two layer of insulator having arelative permittivity 5-3 respectively of The ratio of maximum electric stress of maximum electric stress 8 First layer to the of second layer is 10 Find & 1- The thickness of each layers. 3- The voltage of each layers. §. Layers The saving in radius of cable if another ungrading cable has the Same maximum electric stress, Total village, Conductor diameter of grading cable.

A singl core cable of voltage 30 kv. The diameter of Conductor is 3 cm. The diameter of cable is 25 cm. This cable has Two layer of insulator having arelative permittivity 5-3 respectively of The ratio of maximum electric stress of maximum electric stress 8 First layer to the of second layer is 10 Find & 1- The thickness of each layers. 3- The voltage of each layers. §. Layers The saving in radius of cable if another ungrading cable has the Same maximum electric stress, Total village, Conductor diameter of grading cable.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.17P: Determine the GMR of each of the unconventional stranded conductors shown in Figure 4.30. All...

See similar textbooks

Similar questions

A 33 kV single core cable has a conductor diameter of 1 cm and a sheath of inside diameter 4 cm. Find the maximum and minimum stress in the insulation.
9. What size THWN copper conductors are required to supply a 120/208V, three-phase panelboard with 20.5KVA of noncontinuous load and 25KVA of continuous load? a. 250 kcmil b. No. 1 C. 1/0 d. 4/0
The diameter of an ACSR conductor is 1.1116 inches. The steel core has strands of diameters of 0.1291 inches each. If 54 Aluminum strands have the diameters of 0.1351 inches each, the number of Steel strands is: O A. 15 O B. None of choices are correct O C. 19 O D.7 O E. 27
The diameter of an ACSR conductor is 1.162 inches. The steel core has 7 strands of diameter 0.1291 inches each. If Aluminum strands have the same diameter as that of a steel strand, the number of Aluminum strands is: O A. None of choices are correct O B. 36 O C. 74 O D. 54 O E. 45
Determine the GMR of each of the unconventional stranded conductors shown in Figure 4.30. All strands have the same radius r.
The Aluminum Electrical Conductor Handbook lists a dc resistance of 0.01558 ohm per 1000 ft at 20C and a 60-Hz resistance of 0.0956 ohm per mile at 50C for the all-aluminum Marigold conductor, which has 61 strands and whose size is 1113 kcmil. Assuming an increase in resistance of 2 for spiraling, calculate and verify the dc resistance. Then calculate the dc resistance at 50C, and determine the percentage increase due to skin effect.
To size conductors and overcurrent devices for source circuits, you must multiply the module string short-circuit current by ______________________.
Consider the three single-phase two-winding transformers shown in Figure 3.37. The high-voltage windings are connected in Y. (a) For the low-voltage side, connect the windings in , place the polarity marks, and label the terminals a, b, and c in accordance with the American standard. (b) Relabel the terminals a, b, and c such that VAN is 90 out of phase with Va for positive sequence.
In an outdoor substation the three bus-bar conductors are supported by units of post type insulators. Each unit consists of a stack of 3 pin type insulators fixed one on the top of the other. The voltage across the lowest insulator is 15kV and that across the next unit is 12kV. Estimate: ratio of mutual to self-capacitance i. the bus-bar voltage of the substation. Efficiency across the string of insulators ii. iii.
The principle operation of LVDT is based on the variation of Select one a. Self inductance b. Reluctance c. Mutual inductance d. Permanence
An ACSR conductor has 54 aluminum stands with each strand diameter of 0.1628 inches. The steel core has 19 strands with a strand diameter of 0.0977 inches. The overall diameter will be: O A. 1.0731 inches O B. 1.5116 inches O C. 2.26 inches O D. None of choices are correct O E. 1.2699 inches
In transformer, the eddy current loss can be minimized by O using thin size copper conductors O using magnetic material with low permeability laminating the core O using magnetic material with high permeability