Answered: A mixture of water (density=1000 kg/m3)…

A mixture of water (density=1000 kg/m3) and vapor flowing with a mass rate = 7 kg/sec in a pipe of 1000 m long and 50 mm diameter, the gas fraction is 20%,then the volumetric rate of the water is:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An 80m deep and 100m wide river flows from the left to the right off the page. An action will release two sources of oil to the river: (1) the indirect runoff of oil accumulated on a bridge that runs off site and crosses over the river and (2) the direct and permitted discharge of water containing oil from the activities onsite (a water pollution control plant) to the river. The oil has a molecular weight of 100 g/mol, it fully dissolves in the river water, and it decays in the river with a rate constant of 0.2 d-1. Estimate the potential impact of this action on the concentration of oil in the river at a location 500m downstream of the WPCP. (1) bridge runoff Q1 = 1 m's C = 1 mol/m (2) WPCP discharge Q2 = 50 m's C2 = 0.01 mol/m Qin = 1000 m³'s Cin = 0.001 mol/m? --500m- 500m- -500m 80m 100m a. Recommend the x, y, and z dimensions of the CV. Justify your recommendations. b. Estimate the oil concentration in the water 500m downstream of the WPCP assuming steady and 1D mixed. c. Sketch…
can you show me how did it get the universal gas constant (R)?
5kg of water vapour are contained at 150kPa and 90% dry in a suitable enclosure. Calculate: 1.2.1 the heat required to produce saturated vapour
A tanker ship is transporting 0.798 kg/m3 of a rare gas in its tank. After the fill-up, the 1.94 m long pipe used to fill the tank was left open for 10.4 hours. In that time, 11.7 x10-4 kg of the gas diffuses out of the tank, almost nothing compared to the original quantity of gas in the tank. If the concentration of that gas in our atmosphere is typically zero, and the diffusion constant of that gas is 2.13 x10-5 m2/s, what is the cross-sectional area of the pipe?
Please don't give image based answer..thanku Question:- Water vapor enters a continuous flow adiabatic turbine at 9 MPa pressure, 450 o C temperature and 188 m/s velocity, and exits at 50 m/s speed at 20 kPa pressure and 92% dryness. Calculate the turbine inlet cross-sectional area since the mass flow rate of the steam is 12kg/s.
In a paint manufacturing process, two different colored paints are being mixed in an infinitelylarge drum.Paint A, with a concentration of 30% pigment, is pumped into the drum at a rate of 10 liters perminute.Paint B, with a concentration of 17% pigment, is pumped into the drum at a rate of 17 liters perminute.Both paints have the same density of 1.0 kg/liter.If the mixture is cotinuously stirred and drained from the drum at a rate of 22 liters perminute, what isthe concentration of pigment in the resulting mixture?
air is flowing inside of a pipe with radius=0.4 meters at a mass velocity of 29.4 kg/s*m2 at 322 K, with the walls of the pipe at 300 K. At the conditions of the experiment, the viscosity of air is 1.984 x 10-5 Pa*s, the density of air is 1.22 kg/m3, the heat capacity is 1 kJ/kg*K, and the thermal conductivity is 0.025 W/m*K. Determine the rate of heat loss by air per meter of duct.
None of above A mixture of water (density=1000 kg/m3) and vapor flowing with a mass rate= 7 kg/sec in a pipe of 1000 m long and 50 mm diameter, the gas fraction is 20%,then the volumetric rate of the water is: O 0.0056 m3/sec O 0.056 m3/sec O 0.56 m3/sec 5.6 m3/sec
Estimate the mass-transfer coefficient for moist air flowing normal to a 25 mm diameter tube (Nu = 0.615 Re0.47). The air velocity is 0.5 m/s. Assume standard air.
Develop a mathematical expression for the effective mass transfer rate achieved by an implanted drug delivery device that consists of a spherical core of radius R0 containing the drug, surrounded by a gel barrier of uniform thickness (R1-R0), i.e., the radius of the device (reservoir + barrier) is R1. When implanted, a scar tissue layer of thickness (R2-R1) forms around the device. State and justify any assumptions you might make. For a spherical shell, the flux and mass transfer rate are given by the following expressions (see notes “Steady State Molecular Diffusion: Geometry Effects”
Saturated steam at 10 bar pressure is supplied to increase the temperature of the feed natural gas from its inlet temperature of 30°C to within 15°C of the steam outlet temperature. All steam properties can be verified in the steam table, attached. Evaluate the mass flow rate of the steam supplied, if about 20% of the steam is still uncondensed at the exit. The relevant properties of Natural gas (NG) are as follows: NG Flow Rate = 1500 kMol/hour Average specific heat Capacity of NG = 40 kl/kMol.°C.
Solve with me time 40 minutes