A 2m tall by 10m wide partition wall made of fibreboard (untreated, 12.5mm) separates two rooms, one at 40% rh and 20 oC and the other at 80% rh and 20 oC. Calculate the vapour pressure on either side of the wall as well as the vapour pressure gradient across the wal

A 2m tall by 10m wide partition wall made of fibreboard (untreated, 12.5mm) separates two rooms, one at 40% rh and 20 oC and the other at 80% rh and 20 oC. Calculate the vapour pressure on either side of the wall as well as the vapour pressure gradient across the wal

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter8: Natural Convection

Section: Chapter Questions

Problem 8.2P: 8.2 From its definition and from the property values in Appendix 2, Table 13, calculate the...

See similar textbooks

Similar questions

5kg of water vapour are contained at 150kPa and 90% dry in a suitable enclosure. Calculate: 1.2.1 the heat required to produce saturated vapour
the question below is already answered in the photos that I provided I only want to ask how did it find the answersSaturated steam at a pressure of 25 psia is sprayed into a stream of moist air. The initial condition of the air is 55 dry-bulb temperature and 35 F de-point temperature. The mass rate of air flow is 2000 lb per min. Barometric pressure is 14.696 psia. Determine how much steam must be added in lb per min to produce a saturated air condition, b) the resulting temperature of the saturated air.my question here is:regarding of the solution pls elaborate how did it get w1 and h1 is it given in the psychrometric chart or it has a specific solution to follow
Design a hydrocooling unit to cool down fruits and vegetables from 30 °C to 5 °C in 20 minutes at a rate of 20,000 kg of fruit or vegetables/h. The design must fulfill the following requirements: The unit will be an immersion flooded system. It must be able to cool down and transport the products in chill water. The tank has the following dimensions approximate. three meters wide and up to 90 cm hight. The water will circulate and be cooled through the evaporation section of a refrigeration system. The refrigerant temperature inside the coils will be -2 °C, and the water temperature must not drop below 1 °C and must not exceed 6 °C. Assuming reasonable values for the average density, specific heat, and porosity of the product (the fraction of the volume of air in a box), recommend reasonable values for: The speed of the water through the canal, the capacity of the cooling system. the compressor power.
Please include diagram
The pressure of the water vapour in an atmosphere which is at 380C and 1.013bar, is 0.2642bar. calculate the degree of superheat or water vapour, the specific humidity, the relative humidity, the temperature to which the air must be cooled for it to become saturated. If this air is cooled at 7.864 degrees from its original, calculate the mass of the condensate formed per kg dry air, the heat removed during the cooling process
Water is kept in a closed container at 100 KPa pressure and at 99.6oC temperature, find out whether the water is in pure liquid form or pure vapor form or in mixed form. Use Cardan’s method. You can refer to your notes to check various formulas
Five kilo of water vapour are contained at 178 kPa and 85 percent quality is a suitable enclosure. Calculate the heat which must be added in order to just produce a saturated vapour. What will the pressure be at the end of the heating process?
QUESTION 2 A new induced raft cooling tower is circulating 120 000 L/h of water that is cooled from 50 °C to 22 °C. How much blow-down and make-up is required to maintain the concentration of dissolved solids in the circulating water at four times the concentration in the make-up water? Assume the following: - The evaporated water contains no dissolved solids so all solids entering the system in the make-up must be removed by blow-down and windage. - The windage value of the induced draft cooling tower is 0.3% for each 5.6 °C. - The evaporative losses value is 1.1%.
(c) A sealed rigid vessel contains of 1.8 m’ of saturated water vapor at 135 °C. The vessel is now heated until the temperature reaches at 300 °C. (i) If a safety pressure valve is installed, estimate the pressure should the valve be set to have the maximum temperature of 300 °C. (ii) Calculate the total heat transfer.
Begin with a rigid closed cylinder with fixed 1 L volume at 50 atm pressure and 350 K temperature. Plot the pressure as a function of temperature, as the temperature falls to 200K. Assume the contained fluid is 100% carbon dioxide – assume ideal gas
A rigid tank contains water vapor at 300 C and an unknown pressure. When pain the tank is cooled to 130 C, the vapor start condensing. Estimate the initial pressure in the tank.
Calculate the water vapor pressure of the atmosphere if the dry-bulbtemperature is 22°C and the wet bulb temperature is 10°C at standardatmospheric pressure , Calculate also the relative humidity, the degree or percentof saturation , humidity ratio , and the enthalpy of the mixture. solve with complete diagram