Five kilo of water vapour are contained at 178 kPa and 85 percent quality is a suitable enclosure. Calculate the heat which must be added in order to just produce a saturated vapour. What will the pressure be at the end of the heating process?

Q: Q3: A cylinder fitted with a piston has initial volume (0.5 m') and contain air at (140 kpa) and (25…

A: Given data as per question Initial volume  of air = 0.5 m3Initial  Pressure  of air=140 kpawork done…

Q: Differentiate between a saturated vapour and a superheated vapour?

A: Vapour: A phase of a fluid at a temperature where the same substance can exist in both solid and…

Q: Question 1 (variation a) Five litres (5 L) of saturated water steam is contained in a…

A: Answer: (a) Total mass of the steam is 0.961165 kg. (b) The quality of steam is 0.2489%. (c) The…

Q: Differentiate between saturated liquid and saturated vapor. Make use of T-S diagram along with your…

A: It is required to differentiate between the saturated vapour and saturated liquid states.

Q: -35%- The pressure in the automobile tire depends on the air in the tire. When the air temperature…

A: Given:T1=25°C =298 KPg1=210 kPaV=0.025 m3T2=50°C =323 KPatm=95 kPa

Q: What is the difference in the saturated vapor pressure for refrigerant R-134aat the two given…

A: given: What is the difference in the saturated vapor pressure for refrigerant R-134aat the two given…

Q: Evaporator, single effect is used to upgrade the concentrate 8000 kg/h of tomato juice than 5%…

A:

Q: You have 2 kg of saturated vapour at 8°C.  Calculate its volume in m3.

A:

Q: What is the phase and pressure of water at 280°C with specific volume 0.92 m3/kg? answer :…

A:

Q: Calculate the quality of the fluid: Ammonia at 200kPa, with a temperature of 30°C

A:

Q: Design a hydrocooling unit to cool down fruits and vegetables from 30 °C to 5 °C in 20 minutes at a…

A: Assuming specific heat of fruits Cf= 3.65 KJ/Kg mass flow rate of fruits= mf= 20000 Kg/h = 5.55 kg/s…

Q: Saturated liquid water at 500 kPa is throttled to a pressure of 200kPa. What is the finial…

A: According to the given data P1=500KPa and quality x=0 (Saturated liquid) P2=200KPa Throattling…

Q: 3. With the increase in pressure: (a) Boiling point of choose the water increases correct answer and…

A:

Q: Two spherical shape container with diameter of 6 feet are connected to each other by means of a…

A: Given: The diameter of containers, d = 6 feet The temperature in both the container, T = 80 F The…

Q: Glinder arrang enment-It u heated pam 12 Lar, 25°C to Constant pressre: ement-It s heated 200°C at…

A: When the pressure of a thermal cycle remains constant, the process is called the constant pressure…

Q: 5kg of water vapour are contained at 150kPa and 90% dry in a suitable enclosure. Calculate: 1.1.1…

A: Given:P1 = 150 kPax1 = 0.9x2 = 1 (Since the end state is saturated vapor)v1 = v2 (As water vapor is…

Q: find frmperature at the trißle point ? Vapow pressure of.liquid & Sofid ammoni ay are respecfivelcy…

A:

Q: 400-L rigid tank contains Skg of water at 200kPa. Determine (a) the temperature, (b) the total…

A:

Q: What is the value of x for air when below relationship is followed in adaibatic process: P^x V = Con

A: Explanation For adaibatic process Here x is the ratio of specific heats (x=cpcv) which is defferent…

Q: A rigid tank containssome liquid water at 300C. The rest of the tank is filled with atmospheric air.…

A: Here I'm going to tell that, how can be water boiled without raising it's temperature.

Q: The rigid sealed vessel with a safety temperature valve, as shown, has a volume 0.4 m and contains…

A:

Q: What is the resulting pressure when one pound of air at 15 psia and 20°F is heated at a constant…

A: Given data,  P1= 15 psia =103.421 KPa T1=20°F =366.483 K  T2= 800°F = 699.817 K

Q: Five kg of water vapour are contained at 150 kPa ad 90 per cent quality in a suitable enclosure.…

A: Given Data The mass of the water vapour is: m=5 kg The initial pressure of the water vapour is:…

Q: A 1.2m3 tank is filled with water mixture at 200C if 90% of the mass is liquid and the rest is vapor…

A:

Q: how would you find the conditions of Saturated vapor at 1 MPa on a Mollier Chart

A:

Q: The water in the vessel consisting of liquid and vapor in equilibrium at 8.547 Mpa. It has found out…

A: Given DataP=8.5MPaU=2138.545kJ/kg

Q: What is different in bitween Saturated Vapor and Superheated Vapor.

A: Saturated vapor - If a substance exists complete vapor at saturation temperature then it is called…

Q: Calculate the vapour properties asked.  ALL interpolation must be shown Question   P (kPa) T…

A:

Q: What is the temperature at the triple point?

A: Given; In the vicinity of the triple point, the vapour pressureof liquid and solid ammonia are…

Q: Why smaller vapor pressure in cavity is superheated liquid?

A: Explain smaller vapour pressure in cavity is superheated liquid.

Q: Use steam table, Saturated steam has a pressure of 2.546 Mpa. What are the temperature, specific…

A: As per our guidelines we are supposed to solve only 3 subparts if multiple subparts are asked .…

Q: One liquid has a temperature of 140oF and another liquid has a temperature of 60oC. Are the liquids…

A:

Q: When does boiling occur in a fluid?   Briefly state Pascal's Law?

A: Solution:

Q: F.0065 M^2 and a mass ume of the cylinder is 10 ntil the system become. m/s^2, determine:

A:

Q: Determine the heat required to boil the water at 25°C if hf=1000, and specific heat of water is 4.

A: Given Data The specific heat of the water is: hf=1000 cal/kg°C The mass of the water is: m=4 kg The…

Q: 5kg of water vapour are contained at 150kPa and 90% dry in a suitable enclosure. Calculate:…

A:

Q: Five kilo of water vapour are contained at 178 kPa and 85 percent quality is a suitable enclosure.…

A:

Q: Dis cuss uhat hoppens when a tebe of smaeller

A: When a tube of small diameter like capillary tube is dipped into the water, then because of surface…

Q: T, °C P, kPa v, m³/kg Phase description -8 500 30 0.022 320 Saturated vapor 100 600

A:

Q: Air in a 36.15 m3 tank has a pressure of 816.132 kPa and temperature of 42.995 C. Determine the mass…

A:

Q: spherical shape container with diameter of 6 feet are ns of a short pipe with valve closed. Each…

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.