He equipment room housing the compressor and condenser of a refrigerant ammonia system has dimensions 5 by 4 by 3 m. Calculate the minimum mass of the refrigerant in kg which would have to escape into the space to cause a toxic concentration for a 1/2-h exposure. 0.53 100 76 0.26

He equipment room housing the compressor and condenser of a refrigerant ammonia system has dimensions 5 by 4 by 3 m. Calculate the minimum mass of the refrigerant in kg which would have to escape into the space to cause a toxic concentration for a 1/2-h exposure. 0.53 100 76 0.26

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter9: Refrigerant And Oil Chemistry And Management-recovery, Recycling,

Section: Chapter Questions

Problem 17RQ: What is the name of the conference that was held in Canada in 1987 to attempt to solve the problem...

See similar textbooks

Similar questions

Required information Problem 04.038 - Energy balance for water in a piston-cylinder device NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. An insulated piston-cylinder device contains 3.5 L of saturated liquid water at a constant pressure of 175 kPa. Water is stirred by a paddle wheel while a current of 8 A flows for 45 min through a resistor placed in the water. One-half of the liquid is evaporated during this constant-pressure process and the paddle-wheel work amounts to 400 kJ. 11,0 consta Problem 04.038.a - Find source voltage Determine the voltage of the source. Use data from the steam tables. (Please provide an answer before moving on to the next part) The voltage of the source is V.
The equipment room housing the compressor and condenser of a refrigerant ammonia system has dimensions 5 by 4 by 3 m at 1 bar room pressure. Calculate the minimum mass of the refrigerant in kg which would have to escape into the space to cause a toxic concentration for a 1/2-h exposure.
Evaporative cooling PLEASE DO NOT USE PSYCHROMETRIC CHART. THANK YOU In the diagram below inlet air is drawn over a pool of liquid water in a steady-state, steady-flow isobaric process. Evaporation on the pool resultsin saturated air at the exit. The pool of liquid water is assumed to be at the same temperature as the exitair. Discharge fans at the exit provide a volumetric flow rate of 800,000 ft3/min. In the diagram above inlet air is drawn over a pool of liquid water in a steady-state, steady-flow isobaric process. Evaporation on the pool resultsin saturated air at the exit. The pool of liquid water is assumed to be at the same temperature as the exitair. Discharge fans at the exit provide a volumetric flow rate of 800,000 ft^3/min. Problem #1: Assume that the exit temperature is T2 = 90 °F. For this model of the system and from thedata provided determine:a) The mass flow rate dry air through the system (lbm/sec).b) The rate of heat that is output from the R-134a condenser Qout…
On a hot summer day, the temperature is 35 ° C, barometric pressure 103 kPa and relative humidity 90%. One The air conditioner draws the outside air and cools it to 20 ° C and raises the air to 12500 L / h. Calculate the condensation rate of the moisture (kg / h) and the flow rate of the air drawn from the outside.
QUESTION 2 A new induced raft cooling tower is circulating 120 000 L/h of water that is cooled from 50 °C to 22 °C. How much blow-down and make-up is required to maintain the concentration of dissolved solids in the circulating water at four times the concentration in the make-up water? Assume the following: - The evaporated water contains no dissolved solids so all solids entering the system in the make-up must be removed by blow-down and windage. - The windage value of the induced draft cooling tower is 0.3% for each 5.6 °C. - The evaporative losses value is 1.1%.
Calculate the daily evaporation rate (in mm/ day) from an open surface, if the net radiation is 220 W/m^2, relative humidity of 42%, water surface temperature is 32 degrees Celsius and the air temperature is 25 degrees Celsius. Assume no other sensible heats or ground heat flux. Use Energy-Budget Method.
c) The data obtained from air monitoring station in one area are as follows: (CO2,C4) Carbon monoxide 18.50ppm Ozone 0.53ppm Nitrogen oxide 5.80ppm Nitrogen dioxide 3.00ppm Sulphur monoxide 0.70ppm
I need a step by step answer please, and please clearly state where from the table we get the values and numbers Thank you :)
2. Two hundred and fifty pounds of a mixture of 10 mol% propane 20% n-butane, and 70% n-pentane is completely vaporized in a pipe still in one hour. At the outlet, the temperature anc 433 F and 600 psia. What is the volumetric flow pressure are rate in cfm at the outlet conditions? Answer: The physical properties of the gas are: Tc Pc MW Propane 369.9 K 665.8 R 42.0 atm 44 Butane 425.17 K 765.31 R 37.47 atm 58 Pentane 469.8 K 845.64 R 33.3 atm 72
Liquid ammonia at 30°C is metered through an expansion valve to an evaporator operating at a saturation temperature of -5°C. Calculate the dryness fraction of the refrigerant entering the evaporator. 21.7% 0.1288% 12.88% 15.78%
1. The air conditioning process in the humidifier, air at a dry bulb temperature of 40 ° C and RH 25% increases the RH to 60%. Determine the amount of air vapor added to the humidifier per kg of dry air. = (kg air / kg air).
Which process results in the greatest endothermic change for 10.0g of H2O