7. Calculate the amount of lime (84%) and soda (92%) required for treatment of 20,000 litres of water, whose analysis is as follows: Ca(HCO3)2 = 40.5 ppm; Mg(HCO3)2 = 36.5 ppm; CaSO4 = 34 ppm; CaCl2 = 27.75 ppm; MgSO4 = 30.0 ppm; SiO2 = 3.5 ppm; NaCl = 10 ppm. Also calculate the temporary & permanent hardness of water sample

Q: 9. A core sample is saturated with Oil, Gas and Water , the initial weight of the saturated sample…

A: Given data - bulk volume of sample = 100 cc Initial weight of saturated sample is 220 gm Increased…

Q: The specific gravities of solids and carrier fluids of a slurry are usually known, but the specific…

A: Specific gravity is defined as the ratio of the density of solids in the slurry and the density of…

Q: For the particles in problem 3, determine the percent removal in a sedimentation basin with a depth…

A: Answer  We are given Before flocculation Average diameter = 20 μm  Specific gravity S = 2  After…

Q: You need to soften water at a 20 MGD potable water treatment facility using lime (Ca(OH)2) and soda…

A: Data Given:   Concentration Molecular Weight CO2 6 mg/L 44 g/mol Ca2+ 20…

Q: In constructing dams, the concrete is poured in lifts of approximately 1.8 m (y₁ = 1.8 m). The forms…

A: y1=1.8 mAssume that the moment will occur at the base be: MMoment = Force  Distance

Q: EA two-stage distiller system is used to remove TDS from sea water as shown in the figure. The…

A: Given:- two stage distiller To find:- concentration

Q: www (pH=7). What is the total hardness (TH) of water that contains the following ion concentrations…

A: Given:Required:Total hardness of water

Q: The amount of chlorine residual remaining when gases start evolving during disinfection and when…

A: The amount of chlorine residual remaining when gases start evolving during disinfectionand when they…

Q: Determine the pH of a solution that contains 2*(10^-4) mg/L of OH- (at 25 degrees)

A:

Q: 6 Ydu will obtain 2.0 L of tap water for you water hardness test. The water hardness test uses a…

A: We will solve this question in step no. 2

Q: After being filled to a depth d with SAE 30 oil (SG = 0.91), a glass is placed to float in a tank of…

A: Depth upto which SAE oil is filled in a glass to make it float on water = d , Specific Gravity og…

Q: h=1.4, w =3,L= 4.7 alumium block  / brass block h=1.4, w =1.7l=2.4   densities  (p alumiun 2700kg/m3…

A:

Q: 3.2 If an ion exchange water softener has 0.2 m' of ion-exchange resin with an exchange capacity of…

A: 3.2)

Landfills

The landfill is a site used for the disposal of waste materials. The landfill is a solid waste facility that is often known as a dumping ground. The image below shows a landfill site in Hawaii. Landfilling is the most ancient and common method used for the disposal of waste. For the landfill, a deep trench is constructed in an isolated place away from the city. The trench for landfills is designed properly after analyzing the total population and the waste generation per capita. The waste is dumped into the trench and after every layer of waste, a layer of soil is spread on the top of it.