In constructing dams, the concrete is poured in lifts of approximately 1.8 m (y₁ = 1.8 m). The forms for the face of the dam are reused from one lift to the next. The figure shows one such form, which is bolted to the already cured concrete. For the new pour, what moment will occur at the base of the form per meter of the length (normal to the page)? Assume that concrete acts as a liquid when it is first poured and has a specific weight, y = 24 kN/m³. Cantilevered form Bolts 60° New pour level YI Old pour level Cured concrete

Q: Two couples act on the beam. (Figure 1) Figure 60° 0.2 m 1 m 300 N < 1 of 1 2m 500 N Part A If the…

A:

Q: Calculate the density of the concrete  Volume of the bucket = 0.00727 m3 Mass of empty bucket =…

A:

Q: A cube of a material with a yield strength of 100x10° N/m?is subjectedtothe loads shown onthe right.…

A: The maximum shear stress is generally the maximum concentrated shear force in a small area. In…

Q: During the construction of a dam, concrete was poured into a lift of approximately 1.8 m (yı = 1.8…

A: Given: Specific Weight, e=20 kN/m3 y1 =1.8m

Q: Stress analysis Task Question / Calculate the critical design loads applied to the Stirling Engine…

A: Please find the answer in the below attachments

Q: For an assembly shown below, determine the stresses in each rod after a temperature rise of 30°C.…

A: Given:- Properties of barBronze   Length=1.2 m=1200 mm                C/S    =1400  mm2…

Q: If weight of aggregate is 79 kg and specific gravity of aggregate is 2.67. Assuming angularity…

A: Given data: Weight of aggregate, w = 79 kg Specific gravity of aggregate, Ga=2.67 Angularity number…

Q: A concrete floor is constructed of 3 wythes of carbonate concrete that is each 2 inches thick. If…

A: Fire hazard is a serious hazard since fire severely affects the strength of building materials.…

Q: Help me with Solution, Need fast. Do not waste time. A steel beam is installed in a building when…

A:

Q: During the construction of a dam, concrete was poured into a lift of approximately 1.8 m (yı = 1.8…

A: Concrete dam: Concrete dams are known as gravity dams. Concrete dams are generally constructed to…

Q: When a pressure of 650 psi is applied to a solid, its  specific weight increases from 310 lb>ft3  to…

A: given- pressure P=650 psispecific weight increases from 310 lb/ft3 to 312lb/ft3

Q: Hand

A:

Q: Why a reduction factor ra is used in liquefaction relationship? Please explain with sketches.

A: To explain:Why reduction factor rd is used in liquefaction relationship

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.