4.8. A three-phase transposed line is composed of one ACSR 159,000 cmil, 54/19 Lapwing conductor per phase with flat horizontal spacing of 8 meters as shown in Figure 37. The GMR of each conductor is 1.515 cm. (a) Determine the inductance per phase per kilometer of the line. (b) This line is to be replaced by a two-conductor bundle with 8-m spacing mea- sured from the center of the bundles as shown in Figure 38. The spacing between the conductors in the bundle is 40 cm. If the line inductance per phase is to be 77 percent of the inductance in part (a), what would be the GM R of each new conductor in the bundle? - D12 = 8 m D23 = 8 m -D13 = 16 m- %3D FIGURE 37 Conductor layout for Problem 4.8 (a).

4.8. A three-phase transposed line is composed of one ACSR 159,000 cmil, 54/19 Lapwing conductor per phase with flat horizontal spacing of 8 meters as shown in Figure 37. The GMR of each conductor is 1.515 cm. (a) Determine the inductance per phase per kilometer of the line. (b) This line is to be replaced by a two-conductor bundle with 8-m spacing mea- sured from the center of the bundles as shown in Figure 38. The spacing between the conductors in the bundle is 40 cm. If the line inductance per phase is to be 77 percent of the inductance in part (a), what would be the GM R of each new conductor in the bundle? - D12 = 8 m D23 = 8 m -D13 = 16 m- %3D FIGURE 37 Conductor layout for Problem 4.8 (a).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Please neglect the simulation
The total conductor cross section of a 537.40 kV (Peak value) three-phase overhead line with a length of 100 km is 517 mm2 and the conductor diameter is 29.6 mm. The roughness factor of the conductors is 0.8 and the distance between the conductors is 6 m. The ambient pressure along the line is 650 mmHg and the temperature is 15oC. Since there is corona discharge in only 5 km of this line, find the total Corona loss lost to the line using the Peek equation (Ed=30kVpeak/cm for Air). I would be very happy if you could be quick. :)
For the Figure 9 shown: A 65 -km long, 59 Hz, three-phase, transmission line is composed 2 parallel lines. The conductors in the lines are stranded with GMR of 15.92 -mm each. If the distance D in the figure is 2.46 m., What is inductive reactance per line in (ohm)? Figure 9 $0 D 1.732D 2D 1.732D 1.732D D b' 1.732D
Q2(a) Figure Q2(a) shows the spacing of a double circuit 3-phase overhead line. The phase sequence is UVW and the line is completely transposed. i) Critically assess the advantages of double circuit line over single circuit line Calculate the inductance per phase for 500 meter length of line using Table 2(a) data for the Figure Q2(a). Table 2(a) GMR of the line 0.01m Distance a-b' 6.m Distance c-c' 8.3m a b Figure Q2(a)
one circuit of a sinlge phase transmission line is composed of three solid 0.5 cm radius wires. the return circuit is the composed of two solid 2.5 cm radius wire . the arrangement of conductors is as shwon in figure below. applying the concept of GMD and GMR , find the inductance of the complete line in millihenry per kilometer
Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides 20, 10, and 18 meters. The diameter of each line conductor is 1 cm. Calculate the Capacitance per phase per km (C1) for this arrangement. Calculate Capacitance per phase per km(C2) if the spacing between the conductors are reduced by 1/4th of given spacing. NOTE -- an Capacitance inuF per Phase per Km for Arrangement 1 (C1) Capacitance in µF per phase per km for Arrangement 2 (C2)
The capacitance between the line to neutral of a three-phase 50 Hz, 66KV overhead line conductors with horizontal configuration is 8.5 x 10- Farad/ph/m. Then the line to line capacitive reactance in 2/km is ..
In terms of cable performance, what are the effects of temperature fluctuations on transmission cabling?
A) Two conductors of a single phase line, each of 1 cm diameter, are arranged in a vertical plane with one conductor mounted 1 m above the other. A second identical line is mounted at the same height as the first and spaced horizontally 0-25 m apart from it. The two upper and the two lower conductors are connected in parallel. Determine the loop inductance per km of the resulting double circuit line.
2. 100km, 132kV, 50Hz transmission line has per phase resistance R=0.036(22/km). Each phase (a, b, c) are composed of 4-bundle solid conductors with radius of 2 cm. The conductors of this line are arranged horizontally as shown in the figure. Find; a. b. C. d. GMD, GMRL, GMRC Inductance of the line in mili-H. Capacitance of the line in Micro-F. ABCD parameters of the line. 13 m 13 m b di di d₂ r1=2 cm d₁= 40 cm
please help solve this question A 100 km Three-Phase 50 Hz transposed transmission line is composed of bundle of three ACSR, 1,431,000 cmil, 47/7 Bobolink conductors as shown in Figure 2 (a). The Three-Phases (bundled Conductors) have flat horizontal spacing of 11 meters as shown in the Figure 2(a). The conductors have a diameter of 3.8 cm and a GMR of 1.5 cm. The Line is going to be replaced with a six conductor bundle of ACSR, 477,000 cmil, 26/7 Hawk conductors. The conductors have a diameter of 2.5 cm and a GMR of 0.9 cm. The new line will have a horisontal phase spacing of 14 meters as it is going to be operated at higher Voltage rating. The new line is shown in Figure 2 (b). The spacing between the bundles in Figure 2 (a) and (b) is 45 cm. Determine,a) The capacitance for each case and the percentage change in capacitanceb) The inductive reactance for each line and the percentage change.c) The inductance for each case and the percentage change ininductance