Solve by hand not using chat gpt will give thumbs up 1. For the two magnetically coupled coils shown in Figure 1:a. If we would like to replace these coupled coils by a single coil Lab, what isthe expression of this inductance in terms of the self-inductances and mutualinductances?b. What is the voltage Vab if the self-inductances and mutual inductances areL₁ = 6H, L₂ = 9H, M 5H and the current iab = 2 cos(50t) A?aiab=Li-ML2bFigure 1

Answered: Image /qna-images/answer/704de261-3bce-434e-85b2-e00702faf007.jpg

Answered: 1. For the two magnetically coupled…

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 5RQ

See similar textbooks

Similar questions

Two coupled coils have self-inductances L1= 2 H and L2=0.5 H, and a coefficient of coupling K = . 0.9. Determine the turns ratio N1/N2 of the two coils. a. 2 b. 0.2 c. 0.5 d. 0.9
-write legibly-show the complete solution
4. An Impedance Coil has a resistance of 7.5 ohms and an inductive reactance of 18 ohms (connected in series). a) What is the voltage equation for a voltage that produces a current i = 11.3sinwt, b) Solve for the values of E, I, voltage across the resistor and voltage across the inductor.
A 120-V rms 60-Hz source supplies two loads connected in parallel, as shown in the figure. a) Find the power factor of the parallel combination. b) Calculate the value of the capacitance connected in parallel that will raise the power factor to unity.
A 6-H inductor is connected to a 12-VDC source. What is the value of its inductive reactance? I was unable to find an equation that would help me solve this problem
A Cockcroft-Walton type voltage multiplier has ten stages with capacitances, all equal to 0.1 μF. The supply transformer secondary voltage is 100 kV at a frequency of 60 Hz. If the load current to be supplied is 5 mA, find (a) the percentage ripple, (b) the regulation, and (c) the optimum number of stages for minimum regulation or voltage drop.
You are modifying the design of an existing inductor and want the inductance to be 1/2 of it's current value. You could achieve this by which of the following options. Select all that apply. Question 1 options: Decreasing the number of windings by a factor of 2. Decreasing the length of the inductor by a factor of 2. Increasing the area of the inductor by a factor of 2. Increasing the number of windings by a factor of 2. None of the other responses are correct.
I need the answer at 20 minute
A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the final value of current, the value of current after 4 ms, the value of the voltage across the resistor after 6 ms, the value of the voltage across the inductance after 6 ms, and the time when the current reaches 15A.
A 100 kVA, 400 V/250 kV testing transformer has 8% leakage reactance and 2% resistance on 100 kVA base. A cable has to be tested at 500 kV using the above transformer as a resonant transformer at 50 Hz. If the charging current of the cable at 500 kV is 0.4 A, find the series inductance required. Assume 2% resistance for the inductor to be used and the connecting leads. Neglect dielectric loss of the cable. What will be the input voltage to the transformer?
A 1,000-W electric motor is connected to a sourceof 120 Vms, 60 Hz, and the result is a lagging pf of 0.8.To correct the pf to 0.95 lagging, a capacitor is placedin parallel with the motor. Calculate the current drawnfrom the source with and without the capacitorconnected. Determine the value of the capacitorrequired to make the correction.
Which of the following sensors has a permanent magnet inside? Hall effect sensor thru-beam optical sensor piezo-electric sensor LVDT capacitive proximity sensor |o|0|0|6

SEE MORE QUESTIONS

Recommended textbooks for you

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning