When a Car enters the hall, a particular sequence will be followed automatically. The steps are 1) Soaping, 2) Washing, 3) Rinsing, and 4) Drying. Implement this process sequence in PLC using the Ladder Diagram programming language. Explain each rung of your program, and remember to describe your instructions.

For the following design, write Verilog code to describe it. Write testbench program to test the circuit for all possible inputs. INPUTS OR AND OR AND OUTPUTS

Industrial Motor Controls 14.a. Single sweep operation of a PLC is normally used toA. produce an output when a timer reaches preset value.B. issue a RUN command to the PLC.C. create a negative transition output coil.D. debug newly written ladder logic.14.b. A photoeye will have which of the following abbreviations?A. PHOTOB. PEC. PHEYED. PEYE

we are interested in an automatic garage gate system for a building. This system includes a gate that goes up or down, a motor to actuate the gate (pull, push) and sensors to collect information (gate open contact, gate closed contact). The sensors are all similar, each signaling to its controller that a contact has taken place. The user has a remote control to control with just two buttons: open, close. The operating principle of the system is as follows. Suppose the gate is closed. The user opens the gate by pressing the Open button on his remote control. He can stop opening by pressing the Open button again, the motor stops. Otherwise, the gate opens completely and triggers a Gate Open sensor which causes the motor to stop. Pressing the Close button causes the gate to close if it is open (partially or fully). The closing can be stopped by pressing the Close button again, the motor stops. Otherwise, the gate closes completely and triggers a Gate Closed sensor which causes the engine…

Explain and draw a 7490 chip in a circuit of your own design. I want the actual chips drawn with the symbols inside, then a wiring diagram showing the interconnections. Power source and A, B, C, and/or D inputs may be added in the form of either buttons or switches.

Arrange a circuit to implement the following logic: In a production system, conveyors are used to deliver workpieces from one place to another. The START (with memory) and STOP pushbuttons are used to activate (stand-by) and disable the system. In the stand-by condition, the conveyor motor will turn on if an object touches the first limit switch and will turn off if the object touches the second limit switch. The red-light flashes to indicate the conveyor is moving. If the conveyor is not moving, the green light will be on. Draw ladder diagrams and wiring diagrams!

Explain different types of programming methods (programming languages) for the PLC. Include a labeled diagrams if possible.

Solve correct please

1. Fill-in the blanks with the correct answer or chose the correct answer. the blue wire 1-3. Given a 3-wire NPN inductive sensor, the black wire is to be connected to the and the brown wire to the to the 4. After connecting the load to an NPN sensor, the other terminal of the load will be connected to the 5. If a PLC, serving as load, uses a sinking input card, it needs a (PNP/NPN) proximity sensor. 6. Capacitive, Inductive, Photo electric sensors are called proximity sensors because

fire alarm with motor control Explaining how the circuit works, the stages of circuit work, its benefits, types, and places of use. And the mechanism of using programming in it