State the reason why the multistage compression reduces the compression work as a result of inter-cooling and the multistage expansion increases the turbine work as a result of reheating for a specified pressure ratio.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9.12, Problem 113P

To determine

State the reason why the multistage compression reduces the compression work as a result of inter-cooling and the multistage expansion increases the turbine work as a result of reheating for a specified pressure ratio.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

2. A freezer of 20 TR capacity has evaporator and condenser temperatures of 30°C and 25°C respectively. The refrigerant R-12 is sub-cooled by 4°C before it enters the expansion valve and is superheated by 5°C before leaving the evaporator. The compression is isentropic and the valve throttling and clearance are to be neglected. If a six-cylinder, single acting compressor with stroke equal to bore running at 1000 r.p.m. is used, determine: A- C.O.P. of the refrigerating system, B- Mass of refrigerant to be circulated per min, C- Theoretical piston displacement per minute and D- Theoretical bore and stroke of the compressor.

28. In a marine gas turbine unit a high-pressure stage turbine drives the compressor, and a low-pressure stage turbine drives the propeller through suitable gearing. The overall pressure ratio is 4: 1, and the maximum temperature is 650°C. The isentropic efficiencies of the compressor, H.P. turbine, and L.P. turbine are 0.8, 0.83, and 0.85 respectively, and the mechanical efficiency of both shafts is 98%. Calculate the pressure between turbine stages when the air intake conditions are 1.01 bar and 25°C. Calculate also the thermal efficiency and the shaft power when the mass flow is 60 kg/s. Neglect kinetic energy changes, and pressure [Ans. 1.57 bar; 14.9% ; 4560 kW) loss in combustion.

on (sat vapor) o, Py 0.14MPa @Ty Rizia (®) tig- 1340 =7 © ¥y =1 om/kg) (@ Ta= (©) Miomy ) Qo= @) BSvura =2 Comdenser) An adiabatic compressor works with R-134a as working fluid and 0.15 KW. The refrigerant enters compressor as saturated vapor at 0.14MPa. The refrigerant leaves compressor at 70°C and 1.2MPa and then enters condenser 10 be cooled at which pressure remains constant and leaves condenser at 40°C. If the surrounding temperature is 30° Find: (a) initial temperature (T1). (b) mass flow rate of R-134a, (¢) volumetric rate of R-1342 at entrance. of compressor ( ¥;). (@) T, . (¢) compressor efficiency, (1) rate of heat Tosses from condenser, and (g) fotal entropy generation in condenser and also show if the process is possible or not.