College Physics
1st Edition
ISBN: 9781938168000
Author: Paul Peter Urone, Roger Hinrichs
Publisher: OpenStax College
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 9, Problem 18CQ
Suppose the biceps muscle was attached through tendons to the upper arm dose to the elbow and the forearm near the wrist. What would be the advantages and of this of construction for the motion of the arm?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
If you are holding a 25lb weight in your hand 30cm from your elbow joint and your biceps brachii is generating a 30lb upward force at its attachment 5cm from the axis at 30° of elbow flexion, what will happen to the weight?
Jatapra
If 25 kg is the maximum mass m that a person can
hold in a hand when the arm is
positioned with a 105° angle at the elbow as shown
in the figure below, what is the
maximum force, FM, that the biceps muscle exerts
on the forearm? Assume the forearm
and hand have a total mass of 2.0 kg with a CG that
is 15 cm from the elbow, and that the
biceps muscle attaches 5.0 cm from the elbow.
(please include given and explain step by step)
E
105°
max
5.0 cm
15 cm
25 kg
(2.0 kg)g
-35 cm
Chapter 9 Solutions
College Physics
Ch. 9 - What can you say about the velocity of a moving...Ch. 9 - Under what conditions can a rotating body be in...Ch. 9 - What three factors affect the torque created by a...Ch. 9 - A wrecking ball is being used to knock down a...Ch. 9 - Mechanics put a length of Pipe over the handle of...Ch. 9 - A round pencil lying on its side as in Figure 9.13...Ch. 9 - Explain the need for tall towers on a suspension...Ch. 9 - When visiting some countries, you may see a person...Ch. 9 - Scissors are like a double-lever "Stem, Which of...Ch. 9 - Suppose you pull a nail at a constant rate using a...
Ch. 9 - Why are the forces exerted on the outside world by...Ch. 9 - Explain why the forces in our joints are several...Ch. 9 - Why are the forces exerted on the outside world by...Ch. 9 - Explain why the forces in our joints are several...Ch. 9 - Certain of dinosaurs were bipedal (walked on two...Ch. 9 - Swimmers and athletes during competition need to...Ch. 9 - If the maximum force the biceps muscle can exert...Ch. 9 - Suppose the biceps muscle was attached through...Ch. 9 - Explain one of the reasons why pregnant women...Ch. 9 - (a) When opening a door, you push on it...Ch. 9 - When tightening a bolt, you push perpendicularly...Ch. 9 - Two children push on opposite sides of a door...Ch. 9 - Use the second condition for equilibrium (net =0 )...Ch. 9 - Repeat the seesaw problem in Example 9.1 with the...Ch. 9 - Suppose a horse leans against a wall as in Figure...Ch. 9 - Two children of mass 20.0 kg and 30.0 kg sit...Ch. 9 - (a) Calculate the magnitude and direction of the...Ch. 9 - A person carries a plank of wood 2.00 m long with...Ch. 9 - A 17.0-m-high and 11.0-m-long wall under...Ch. 9 - (a) What force must be exerted by the wind to...Ch. 9 - Suppose the weight of the drawbridge in Figure...Ch. 9 - Suppose a 900-kg car is on the bridge in Figure...Ch. 9 - A sandwich board advertising sign is constructed...Ch. 9 - (a) What minimum coefficient of friction is needed...Ch. 9 - A gymnast is attempting to perform splits. From...Ch. 9 - To get up on the roof, a person (mass 70.0 kg)...Ch. 9 - In Figure 9.21, the cg of the pole held by the...Ch. 9 - What is the mechanical advantage of a nail puller...Ch. 9 - Suppose you needed to raise a 250-kg mower a...Ch. 9 - a) What is the mechanical advantage of a...Ch. 9 - A typical car has an axle with 1.10 cm radius...Ch. 9 - What force does the nail puller in Exercise 9.19...Ch. 9 - If you used an ideal pulley of the type shown in...Ch. 9 - Repeat Exercise 9.24 for the pulley shown in...Ch. 9 - Verity that the force in the elbow joint in...Ch. 9 - Two muscles in the back of the leg pull on the...Ch. 9 - The upper leg muscle (quadriceps) exerts a force...Ch. 9 - A device for exercising the upper leg muscle is...Ch. 9 - A person working at a drafting board may hold her...Ch. 9 - We analyzed the biceps muscle example with the...Ch. 9 - Even when the head is held erect, as in Figure...Ch. 9 - A 75-kg man stands on his toes by exerting an...Ch. 9 - A father lifts his child as shown in Figure 9.43....Ch. 9 - Unlike most of the other muscles in our bodies,...Ch. 9 - Integrated Concepts Suppose we replace the 4.0-kg...Ch. 9 - (a) What force should the woman in Figure 9.45...Ch. 9 - You have just planted a sturdy 2-m-tall palm tree...Ch. 9 - Unreasonable Results Suppose two children are...Ch. 9 - Construct Your Own Problem Consider a method for...
Additional Science Textbook Solutions
Find more solutions based on key concepts
The speed of the person sitting on the chair relative to the chair and relative to Earth.
Conceptual Physics (12th Edition)
The proton is a composite particle composed of three quarks, all of which are either up quarks (u; charge +23e)...
Essential University Physics: Volume 2 (3rd Edition)
Consider a standing wave modeled as y(x,t)=4.00cmsin(3m1x)cos(4s1t) . Is there a node or an antinode at x=0.00m...
University Physics Volume 1
Draw and label a free-body diagram for system C at a time following the release of the blocks. Indicate separat...
Tutorials in Introductory Physics
Two cars emerge side by side from a tunnel. Car A is traveling with speed of 60 km/h and has an acceleration of...
Physics: Principles with Applications
3. Suppose the door of a room makes an airtight, but frictionless, fit in its frame. Do you think you could ope...
College Physics (10th Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- There is a small but appreciable amount of elastic hysteresis in the large tendon at the back of a horse’s leg. Explain how this can cause damage to the tendon if a horse runs too hard for too long a time.arrow_forwardUnlike most of the other muscles in our bodies, the masseter muscle in the jaw, as illustrated in as shown, is attached relatively far from the joint, enabling large forces to be exerted by the back teeth. (a) Using the information in the figure, calculate the force exerted by the lower teeth on the bullet. (b) Calculate the force on the joint.arrow_forwardJohn is performing an isometric contraction of the quadriceps to hold a 500 N weight at an angle of 45° of knee extension (i.e., 45° below the horizontal). Assume the length of the lower leg is 42.5 cm. How much force must the quadriceps produce if the moment arm for the patellar tendon is 10 mm?arrow_forward
- The arm shown in the figure supports a 4kg sphere. The mass of the hand and forearm together is 3kg and its weight acts at a point 15 cm from the elbow. Determine the force exerted by the biceps muscle.arrow_forwardName four properties which can be determined by a tensile test. (just name them)arrow_forwardIf the fibers of a pennate muscle are oriented at a 43° angle to a central tendon, howmuch tension is produced in the tendon when the muscle fibers contract with 1600 N offorce?arrow_forward
- Calculate the back extensor force (Fm) required to keep the trunk in the static position as shown. Calculate the bone compressive force acting on the lumbar vertebra. Calculate the bone shear force acting on the lumbar vertebra. The weight of the trunk (Wtrunk) is 500 N, and it has a moment arm of 0.10 m. The weight of the arms (Warms) is 50 N, and it has a moment arm of 0.50 m. The horizontal force from the wall (Fwall-x) is 25 N, and it has a moment arm of 0.25 m. The vertical force from the wall (Fwall-y) is 50 N, and it has a moment arm of 0.75 m. The weight of the backpack (Wpack) is 25 N, and it has a moment arm of 0.15 m. The back extensor muscle has a moment arm of 0.05 m.arrow_forwardExplain how dumbbell curls (flexing the elbow while holding dumbbells) with (A) the forearms supinated and (B) the forearms pronated signifncalty alter the demands placed on the elbow flexors. Mention the muscles involved in your answer. Edit View Insert Format Tools Table 12pt v Paragraph v |BIU A ev T? v :arrow_forwardSuppose the humerus is reduced uniformly in size by a factor of two. This means that both the length and diameter arehalved. What is the amount of stretch in this case?arrow_forward
- When picking up an object from the ground, it is generally recommended that you "lift with your legs" - that is, raise and lower yourself by bending your knees but keeping your upper body upright. If instead, you "lift with your back" by bending at the hip so that your upper body is angled, then you put a great deal more stress on your spine and back muscles. Consider a person who is "lifting with their back" such that they are bent at the hip with their upper body is parallel to the ground (i.e., their spine is oriented horizontally). Let us calculate the tension in the back muscles and the compression on the spine in this situation. We will model the spine and upper body as a horizontal rigid rod or uniform density with a length of 50.0 cm and a mass of 40.0 kg. Assume that the person attempts to lift an object with their arms, which we will model as attached at the far end of the rod. Support of the back in this position is provided primarily by the erector spinalis muscle which we…arrow_forwardect loca tecd What would happen to the stick? the Figure A 10m long uniform bar with a 80 W is attac hed by africtionless hinge to weighte of horizontal rope that wall and held by a malces anr le Qof 37° witn the bar. Culculate the distance from the hinge, x, tha t the 10kg tension T in the rope is 25N. Hint: Use g 10 W/kg, sin37°360 and cos 37°: 9. ang should besus peded if the n fo?arrow_forwardThe bones of the forearm (radius and ulna) are hinged to the humerus at the elbow. The biceps muscle connects to the bones of the forearm about 2.15 cm beyond the joint. ,Biceps muscle Assume the forearm has a mass of 2.35 kg and a length of 0.445 m. When the humerus and the biceps are nearly vertical and the forearm is horizontal, if a person wishes to Humerus- hold an object of mass 5.75 kg so that her forearm remains motionless, what is the force exerted by the biceps muscle? Radius M Elbow- Ulna force: N Handarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- University Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College
University Physics Volume 1
Physics
ISBN:9781938168277
Author:William Moebs, Samuel J. Ling, Jeff Sanny
Publisher:OpenStax - Rice University
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Glencoe Physics: Principles and Problems, Student...
Physics
ISBN:9780078807213
Author:Paul W. Zitzewitz
Publisher:Glencoe/McGraw-Hill
College Physics
Physics
ISBN:9781938168000
Author:Paul Peter Urone, Roger Hinrichs
Publisher:OpenStax College
An Introduction to Stress and Strain; Author: The Efficient Engineer;https://www.youtube.com/watch?v=aQf6Q8t1FQE;License: Standard YouTube License, CC-BY