Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (Chs 1-42) Plus Mastering Physics with Pearson eText -- Access Card Package (4th Edition)
4th Edition
ISBN: 9780133953145
Author: Randall D. Knight (Professor Emeritus)
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 8, Problem 9EAP
Suppose the moon were held in its orbit not by gravity but by a massless cable attached to the center of the earth. What would be the tension in the cable? Use the table of astronomical data inside the back cover of the book.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
At the north pole and equator, a 75 kg man would weigh? For this instance, the earth is a perfect sphere with complete uniform mass distribution.
Which scale reading is higher and by how much (north pole vs equator)?
How far from the earth must a body be along a line toward the sun so that the sun’s gravitational pull balances the earth’s? The sun is 9.3 × 107 miles away and its mass is 3.24 × 105 Me.
The Sun pulls on the Earth, and the Earth pulls on the Sun. However, the Earth is pulled
more and less depending on what part of the Earth you consider. If the distance between
the Earth and Sun is A, and the radius of the Earth is R then they are related by A =
23500 r. Give the ratio of the acceleration on the near and the far side of the Earth from
the Moon. Is the Sun responsible for the tides on Earth?
Chapter 8 Solutions
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (Chs 1-42) Plus Mastering Physics with Pearson eText -- Access Card Package (4th Edition)
Ch. 8 - In uniform circular motion, which of the following...Ch. 8 - A car runs out of gas while driving down a hill....Ch. 8 - FIGURE Q8.3 is a bird's-eye view of particles on...Ch. 8 - Tarzan swings through the jungle on a massless...Ch. 8 - FIGURE Q8.5 shows two balls of equal mass moving...Ch. 8 - Ramon and Sally are observing a toy car speed up...Ch. 8 - A jet plane is flying on a level course at...Ch. 8 - A small projectile is launched parallel to the...Ch. 8 - 9. You can swing a ball on a string in a vertical...Ch. 8 - A golfer starts with the club over her head and...
Ch. 8 - As a science fair project, you want to launch an...Ch. 8 - A 500 g model rocket is on a cart that is rolling...Ch. 8 - A 4.0 × 1010 kg asteroid is heading directly...Ch. 8 - A 55 kg astronaut who weighs 180 N on a distant...Ch. 8 - A 1500 kg car drives around a flat 200-m-diameter...Ch. 8 - A 1500 kg car takes a 50-m-radius unbanked curve...Ch. 8 - A 200 g block on a 50-cm-long string swings in a...Ch. 8 - In the Bohr model of the hydrogen atom, an...Ch. 8 - Suppose the moon were held in its orbit not by...Ch. 8 - 10. A highway curve of radius 500 m is designed...Ch. 8 - It is proposed that future space stations create...Ch. 8 - A 5.0 g coin is placed 15 cm from the center of a...Ch. 8 - Mass m1on the frictionless table of FIGURE EX8.13...Ch. 8 - A satellite orbiting the moon very near the...Ch. 8 - What is free-fall acceleration toward the sun at...Ch. 8 - 16. A 9.4 × 1021 kg moon orbits a distant planet...Ch. 8 - Communications satellites are placed in circular...Ch. 8 - A car drives over the top of a hill that has a...Ch. 8 - The weight of passengers on a roller coaster...Ch. 8 - A roller coaster car crosses the top of a circular...Ch. 8 - The normal force equals the magnitude of the...Ch. 8 - A student has 65-cm-long arms. What is the minimum...Ch. 8 - While at the county fair, you decide to ride the...Ch. 8 - A 500 g ball swings in a vertical circle at the...Ch. 8 - A 500 g ball moves in a vertical circle on a...Ch. 8 - A heavy ball with a weight of 100 N (m = 10.2 kg)...Ch. 8 - A toy train rolls around a horizontal...Ch. 8 - 28. A new car is tested on a 200-m-diameter track....Ch. 8 - An 85,000 kg stunt plane performs a loop-the-loop,...Ch. 8 - Three cars are driving at 25 m/s along the road...Ch. 8 - Derive Equations 8.3 for the acceleration of a...Ch. 8 - 32. A 100 g bead slides along a frictionless wire...Ch. 8 - 33. Space scientists have a large test chamber...Ch. 8 - 34. A 5000 kg interceptor rocket is launched at an...Ch. 8 - Prob. 35EAPCh. 8 - 36. A rocket- powered hockey puck has a thrust of...Ch. 8 - Prob. 37EAPCh. 8 - A 2.0 kg projectile with initial velocity m/s...Ch. 8 - A 75 kg man weighs himself at the north pole and...Ch. 8 - A concrete highway curve of radius 70 m banked at...Ch. 8 - a. an object of mass m swings in horizontal circle...Ch. 8 -
42. You’ve taken your neighbor’s young child to...Ch. 8 - A 4.4-cm-diameter, 24 g plastic ball is attached...Ch. 8 - A charged particle of mass m moving with speed v...Ch. 8 - Two wires are tied to the 2.0 kg sphere shown in...Ch. 8 - Two wires are tied to the 300 g sphere shown in...Ch. 8 - A conical pendulum is formed by attaching a ball...Ch. 8 - The 10 mg bead in FIGURE P8.48 is free to slide on...Ch. 8 - In an old-fashioned amusement park ride,...Ch. 8 - The ultracentrifuge is an important tool for...Ch. 8 - In an amusement park ride called The Roundup,...Ch. 8 - 52. Suppose you swing a ball of mass m in a...Ch. 8 - A 30 g ball rolls around a 40-cm-diameter L-shaped...Ch. 8 - FIGURE P8.54 shows a small block of mass m sliding...Ch. 8 - The physics of circular motion sets an upper limit...Ch. 8 - A 100 g ball on a 60-cm-long string is swung in a...Ch. 8 - A 60 g ball is tied to the end of a 50-cm-long...Ch. 8 - Elm Street has a pronounced dip at the bottom of a...Ch. 8 - 59. A 100 g ball on a 60-cm-long string is swung...Ch. 8 - Scientists design a new particle accelerator in...Ch. 8 - 61. A 1500 kg car starts from rest and drives...Ch. 8 - Prob. 62EAPCh. 8 - 63. A 2.0 kg ball swings in a vertical circle on...Ch. 8 - In Problems 64 and 65 you are given the equation...Ch. 8 - In Problems 64 and 65 you are given the equation...Ch. 8 - Sam (75 kg) takes off up a 50-m-high, 10°...Ch. 8 - In the absence of air resistance, a projectile...Ch. 8 - The father of Example 8.2 stands at the summit of...Ch. 8 - A small bead slides around a horizontal circle at...Ch. 8 - A 500 g steel block rotates on a steel table while...Ch. 8 - If a vertical cylinder of water (or any other...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A 75 kg man weighs himself at the north pole and at the equator. Which scale reading is higher and by how much? Assume the Earth is a perfect sphere with a completely uniform mass distribution.arrow_forwardA person with a gravitational force of 750 N is sitting in the centre of a hammock which is strung between two trees. The ropes supporting the hammock make an angle of 20.0 degrees to the level ground. What is the magnitude of the force on each rope?arrow_forwardA person pushing a uniformly-loaded 31.7 kg wheelbarrow of length L with pushing force P is attempting to get it over a step. The maximum horizontal force that the person can apply is P, = 233 N. What is the maximum height h of the step, expressed as a fraction n of the wheel's radius R. that the person can get the wheelbarrow over? The gravitational acceleration is g = 9.81 m/s². 8459 R Incorrect hnRarrow_forward
- Certain neutron stars (extremely dense stars) are believed to be rotating at about 3.5 rev/s. If such a star has a radius of 23527 km. For the material on this neutron star's surface to remain in place during the rapid rotation, its minimum mass should be ?answer in kgarrow_forwardIn 1956, Frank Lloyd Wright proposed the construction of a mile-high building in Chicago. Suppose the building had been constructed. Ignoring Earth's rotation, find the change in your weight if you were to ride an elevator from the street level, where you weigh 746 N, to the top of the building. Number 0.3802 Units N.arrow_forwardAt an amusement park there is a ride in which cylindrically shaped chambers spin around a central axis. People sit in seats facing the axis, their backs against the outer wall. At one instant the outer wall moves at a speed of 3.06 m/s, and an 71.1-kg person feels a 250-N force pressing against his back. What is the radius of a chamber?arrow_forward
- You are swinging a 0.25 kg water balloon vertically. The distance from your shoulder (acting as the center of rotation) and the water balloon is about 0.65 m. You estimate the water balloon is traveling at 7.0 m/s. At the very top of the circular path, how much force is your hand holding the water balloon? Enter absolute value. Hint: the water balloon is experiencing uniform circular motion.arrow_forwardThe figure shows an arrangement in which four disks are suspended by cords. The longer, top cord loops over a frictionless pulley and pulls with a force of magnitude 94.9 N on the wall to which it is attached. The tensions in the shorter cords are T1 = 68.7 N, T2 = 46.9N, and T3 = 5.51 N. What are the masses of (a) disk A, (b) disk B, (c) disk C, and (d) disk D? (a) Number Units (b) Number Units (c) Number Units (d) Number Units >arrow_forwardAn aluminum can is half-filled with water and whirled about in a horizontal circle on the end of a string 1.00 m long. If the total mass of the can and its contents is 0.115 kg and its tangential speed is 10.0 m/s, what is the tension in the string?arrow_forward
- A cylinder having a mass of 40 kg with the radius of 0.5 m is push to the right without rotation and with acceleration of 2 m/sec2. Determine the magnitude of the horizontal force P if the coefficient of friction is 0.30. * 40 kg a = 2 m/s? ma 0.50 m h O h = 15.7 cm O h = 19.7 cm O h = 20.2 cm O h = 34.6 cmarrow_forwardYou are swinging a 0.45 kg water balloon vertically. The distance from your shoulder (acting as the center of rotation) and the water balloon is about 0.70 m. You estimate the water balloon is traveling at 6.0 m/s. At the very bottom of the circular path, how much force is your hand holding the water balloon?arrow_forwardI just need E block 1 has mass m1 = 460 g, block 2 has mass m2 = 520 g, and the pulley is on a frictionless horizontal axle and has radius R = 5.0cm. When released from rest, block 2 falls 74 cm in 5.4 s without the cord slipping on the pulley. (a)What is the magnitude of the acceleration of the blocks? What are (b) tension T2 (the tension force on the block 2) and (c)tension T1 (the tension force on the block 1)? (d) What is the magnitude of the pulley’s angular acceleration? (e)What is its rotational inertia? Caution: Try to avoid rounding off answers along the way to the solution. Use g = 9.81 m/s2.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Rotational Kinematics Physics Problems, Basic Introduction, Equations & Formulas; Author: The Organic Chemistry Tutor;https://www.youtube.com/watch?v=0El-DqrCTZM;License: Standard YouTube License, CC-BY