The test by which the hardenability of steel is measured.

Question

Want to see the full answer?

Answer 1

Question

Chapter 8, Problem 26CQ

To determine

The test by which the hardenability of steel is measured.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

(Solid Mechanics) A setup for single-edge-notch-bending (SENB) tests is shown below. Support rollers provide frictionless contact with the specimen, while a load is applied at the middle of the top surface of specimen. The thickness of the specimen is 10 mm and the height W 10mm. The properties for this ductile alloy are E = 70 GPa, v=0.3, σᵧ = 400 MPa, Kᵢ? = 25 MPa.m¹/². (1) Ignore any crack or defects in the material, what is the maximum static force that the specimen could carry before failure? (2) A cyclic load of low amplitude 2.8 kN is applied. Because of the cyclic load a defect is nucleated on the edge and grows into a fatigue crack of 2 mm length shown in the right. If the cycling is interrupted, what is the maximum static tensile force that the specimen could carry? (3) With more cycles, the fatigue crack keeps growing. Estimate the critical crack length (a range is fine) at which the plate will fail from the low-amplitude cyclic load 2.8 kN only. (maximum two iterations are…

For a bronze alloy, the stress at which plastic deformation begins is 275 MPa (40,000 psi), and the modulus of elasticity is 115 GPa (16.7 x106 psi). (a) What is the maximum load that may be applied to a specimen with a cross-sectional area of 325 mm2 (0.5 in.2) without plastic de- formation? (15pts)(b) If the original specimen length is 115 mm (4.5 in.), what is the maximum length to which it may be stretched without causing plastic deformation?(15pts)

Given your understanding of what initiates and controls failure in materials, which of the following will increase the failure strength or lifetime of a test piece or component and why? a. Decreasing the difference between the maximum and minimum stress values, as this effects the stress concentration factor b. Decreasing the temperature below the brittle-ductile transition temperature, to make it harder C. Polishing to reduce surface defects Od. Increasing its volume, to give a larger cross sectional area Oe. Increasing the grain size so there are less grain boundaries to initiate failure