Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 42, Problem 2TF
True or False? The neutral safety switch and reverse lamp switch are typically part of a digital transmission range sensor.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Which of the following is not a voltage-generating type sensor?
vehicle speed sensor
OSS
MAP
ISS
what is meant by sensor bias voltage in automotive
A throttle position sensor has _________ .
a- a 0-5 volts signal output terminal
b- a 5-volt reference input terminal
c- all answers are correct
d- a ground terminal
Chapter 42 Solutions
Automotive Technology
Ch. 42 - While discussing the CVT transaxie used in Toyota...Ch. 42 - Although computers receive different information...Ch. 42 - What happens if the TCM determines that the...Ch. 42 - Prob. 4SACh. 42 - List five things that could cause incorrect shift...Ch. 42 - Most late-model transmission control systems have...Ch. 42 - What inputs are of prime importance to a computer...Ch. 42 - What are the advantages of using electronic...Ch. 42 - Voltage generation devices are typically used to...Ch. 42 - True or False? On most late-model EAT systems,...
Ch. 42 - True or False? The neutral safety switch and...Ch. 42 - Which of the following is not a voltage-generating...Ch. 42 - A glitch appears in the waveform of a vehicle...Ch. 42 - Prob. 3MCCh. 42 - Which of the following would probably not be...Ch. 42 - Technician A says that some systems use a special...Ch. 42 - Technician A says that shift solenoids direct...Ch. 42 - Technician A says that throttle position is an...Ch. 42 - Technician A says that a faulty TP sensor can...Ch. 42 - Technician A says that some shift solenoids can be...Ch. 42 - An electronically controlled transmission has...Ch. 42 - While discussing transmission adaptive learning:...Ch. 42 - While discussing valve body assemblies in...Ch. 42 - A transmission has delayed upshifts under all...Ch. 42 - While diagnosing the cause of TCC shudder:...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- When testing an engine temperature sensor: Technician A uses an ohmmeter to test the thermistor. Technician B says that the thermistor reacts to pressure and applies air pressure to the backside of the sensor. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardA defective LAT sensor or circuit may cause the fol lowing problems, except. hard engine starting rich or lean air-fuel ratio improper converter clutch lockup reduced fuel economyarrow_forwardWhen testing a frequency varying MAF: Technician A says that the frequency should increase with an increase in engine speed. Technician B says that when observed on a lab scope, the signal from the sensor should be a square wave. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- True or False? An A/F ratio sensor can be tested in the same way as an oxygen sensor.arrow_forwardTrue or False? On some engines, if the gap between the crankshaft sensor and its trigger wheel is outside specifications, the sensor should be replaced.arrow_forwardWhich of the following is the least likely cause of a no-start condition? Faulty CKP sensor Faulty KS Fuel or ignition system faults Faulty PCM wiringarrow_forward
- True or False? On most late-model EAT systems, separate procedures must be followed to retrieve the DTCs from the transmission control system and the TCC system.arrow_forwardWhile discussing Hall-effect vehicle speed sensor tests: Technician A says to use an ohmmeter to test the resistance of the coil. Technician B says that the voltage generated by the sensor can be measured by connecting a voltmeter across the sensors terminals. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardA digital speedometer constantly reads 0 mph: Technician A says that the problem may be the vehicle speed sensor. Technician B says that the problem may be the throttle position sensor. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- True or False? In a high-speed CAN system, a serial data bus is used to allow communication between the various control modules in a vehicle.arrow_forwardA transmission has delayed upshifts under all operating conditions: Technician A says that low mainline pressure can cause this. Technician B says that a faulty TFT sensor can cause this. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forwardWhen an engine is running lean, the voltage signal from the oxygen sensor will be (low or high).arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Mod-01 Lec-16 Basics of Instrumentation; Author: nptelhrd;https://www.youtube.com/watch?v=qbKnW42ZM5c;License: Standard YouTube License, CC-BY