The reason for the mixture of poly(A), poly(B) and the three DNAs shown in the curve to vary with respect to the C 0 t value needs to be explained. Concept introduction: The C 0 t value analysis is a technique used to measure the complexity in the size of DNA or gene and this technique is based on DNA renaturation kinetics. This technique states the following principles: Renaturation rate is directly proportional to the number of times the sequences exist on the DNA Strand. When enough time is given all the denatured DNA are re-associated or reannealed. Renaturation takes the least time when there is more repetition of the sequences. The renaturation process carried out by heating the DNA and allowing it to cool down to reanneal. The C 0 t value depends on − DNA Concentration, reassociation temperature, cation concentration, and viscosity and is given by the equation: C 0 t value = DNA Concentration ( moles/L ) × Renaturation time ( Secs ) × Buffer Factor Lower C 0 t value shows more repetition of sequences while Higher C 0 t value indicates a greater number of unique sequences.

Question

Want to see the full answer?

Answer 1

Question

Chapter 4, Problem 50P

Interpretation Introduction

Interpretation:

The reason for the mixture of poly(A), poly(B) and the three DNAs shown in the curve to vary with respect to the C₀t value needs to be explained.

Concept introduction:

The C₀t value analysis is a technique used to measure the complexity in the size of DNA or gene and this technique is based on DNA renaturation kinetics.

This technique states the following principles:

Renaturation rate is directly proportional to the number of times the sequences exist on the DNA Strand.

When enough time is given all the denatured DNA are re-associated or reannealed.

Renaturation takes the least time when there is more repetition of the sequences.

The renaturation process carried out by heating the DNA and allowing it to cool down to reanneal.

The C₀t value depends on − DNA Concentration, reassociation temperature, cation concentration, and viscosity and is given by the equation:

C0t value = DNA Concentration (moles/L)×Renaturation time (Secs)×Buffer Factor

Lower C₀t value shows more repetition of sequences while Higher C₀t value indicates a greater number of unique sequences.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

When was the dihydropyridine calcium channel blocker isradipine first patented and by whom? Please provide information on the origin and history of isradipine and who owns it/manufactures it.

9) Below, there is a representation of an SDS-PAGE gel. Assuming the samples in the MW standard have masses of: 66 kDa, 45 kDa, 36 kDa, 29 kDa, 24 kDa, 20.1 kDa, and 14.2 kDa, a) Figure 4: indicate where each of the measurements were taken and label as in II.6. figure 2 above. b) As in II.7. Table 1 above create Table 2 using the data below. Determine the r.f. values for the MW standards, plot the relative mobility versus the log of the mass for the standards, and use the best fit straight line to determine the molecular weights of the proteins in the whey, peak 1, and peak 2 lanes. (5 pts—this will be scaled up appropriately if your gel did not develop properly) dye MW Whey Peak 1 Peak 2

what are the different classes and some examples of neuroprotectants that can be used to treat, prevent, or combat neurotoxicity/a neurotoxicant...for example, antioxidants, nutraceuticals, etc.,..?