Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 4, Problem 19MC
While discussing the operation of air-conditioning systems: Technician A says that in order for the refrigerant to release heat, it must be at a low temperature and pressure. Technician B says that in order for the refrigerant to absorb heat, it must be at a high temperature and pressure. Who is correct?
- Technician A
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A vehicle is having its water pump replaced.
When the water pump is removed, severe
corrosion is found on the water pump
impeller, and inside the engine. Technician A
states that the radiator cap may be
overpressurizing the system. Technician B
states that the vehicle may have been run
with 100% water in the cooling system for
some time. Who is correct?
Select one:
a. Technician A only
b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
An overheating vehicle is being discussed.
Technician A states that the vehicle may be
overheating because the heater control valve
is stuck closed. Technician B states that the
vehicle may be overheating because the
PCM in not energizing the cooling fan relay.
Who is correct?
Select one:
a. Technician A only
b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
Which of the following statements is false?
The condenser is normally mounted just in front of the radiator.
The receiver/dryer is a storage tank for the liquid refrigerant from the condenser.
An accumulator is not used in any system with a receiver/dryer.
All of the above.
Chapter 4 Solutions
Automotive Technology
Ch. 4 - Prob. 1SACh. 4 - Explain the four strokes of the internal...Ch. 4 - In addition to the battery, what does the charging...Ch. 4 - What is meant by the term regenerative braking?Ch. 4 - Which of the following is not a common emission...Ch. 4 - Automatic transmissions use a instead of a clutch...Ch. 4 - Which of the following is not one of the strokes...Ch. 4 - Prob. 4MCCh. 4 - Which is not a common automotive fuel? Gasoline...Ch. 4 - What does the valve train do? It delivers fuel to...
Ch. 4 - Technician A says that liquid cooling an engine...Ch. 4 - Prob. 8MCCh. 4 - Which emission control system introduces exhaust...Ch. 4 - Prob. 10MCCh. 4 - Technician A says that a transaxle delivers torque...Ch. 4 - Which of the following is not part of the running...Ch. 4 - Which of the following statements about unibody...Ch. 4 - Which type of transmission uses pulleys to change...Ch. 4 - Prob. 15MCCh. 4 - What two major engine components work together to...Ch. 4 - Technician A says that an air-conditioning system...Ch. 4 - The boiling point of the coolant in an engines...Ch. 4 - While discussing the operation of air-conditioning...Ch. 4 - Prob. 20MCCh. 4 - Which of the following is not accomplished by the...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that when the refrigerant is pumped out of the compressor and sent to the condenser, heat in the refrigerant is moved to the outside air by conduction and convection. Technician B says that the refrigerant leaves the bottom of the condenser as a high-pressure, high-temperature liquid. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardWhich of the following statements best defines the term evacuation? A process in which the refrigerant in a system is released. A condition that exists when a compressor runs until there is no refrigerant left in the system. The process that pulls all traces of air and moisture from the system. A process that uses air to force moisture and dirt out of the system.arrow_forwardTechnician A feels up and down the face or along the return bends of the condenser for a temperature change and says that there should be a gradual change from hot to warm from the bottom to the top. Technician B says that a restriction in the condenser will be evident by a sudden change in temperature. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forward
- Technician A says that some refrigerant leaks can also be traced to pinholes in the evaporator caused by acid, which forms when water and refrigerant mix. Technician B says that leaks are most often found at the compressor hose connections and at the various fittings and joints in the system. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardTechnician A says that air in the system can cause excessive pressure within the system, restricting the refrigerants ability to change its state from gas to liquid within the refrigeration cycle. Technician B says that moisture can cause freeze-up at the cap tube or expansion valve, which restricts refrigerant flow or blocks it completely. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardTechnician A says that evacuating (pumping down) an air-conditioning system removes air and moisture from the system. Technician B says that evacuating (pumping down) an air-conditioning system removes dirt particles from the system. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forward
- While discussing the reaction by a refrigerant to heat: Technician A says that to absorb heat, the temperature and pressure of the refrigerant are kept low. Technician B says that to dissipate heat, the temperature and pressure are kept high. Who is correct?arrow_forwardAn overheating vehicle is being discussed. Technician A states that the vehicle may be overheating becuase the heater control valve is stuck closed. Technician B states that the vehicle may be overheating because the PCM in not energizing the cooling fan relay. Who is correct?arrow_forward3) What are some criteria that need to be considered in the selection of a refrigerant? Please choose one type of refrigerant in air conditioning system market and elaboratearrow_forward
- Technician A says that when the A7C system is off, the refrigerant occupies the system as a liquid and its pressure is the same throughout the system. Technician B says that refrigerant is pumped out of the compressor as a high-pressure, high-temperature vapor and is sent to the condenser. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forward1-While refilling an 8-quart (7.57 L) system with coolant: Technician A initially puts in 4 quarts (3.78 L) of straight coolant and tops it off with water. Technician B fills the system with the correct mixture, tightens the radiator cap, and then checks for leaks. Who is correct? 2-While checking for conditions that might cause coolant electrolysis: Technician A places the positive lead of a voltmeter into the coolant and connects the negative lead to a ground. Technician B checks for the presence of voltage in the coolant with the ignition off. Who is correct? 3-Technician A says that if the PCV valve or connecting hoses become clogged, excessive pressure will develop in the crankcase and can cause oil leaks. Technician B says that if the PCV valve or connecting hoses become clogged, oil may be pushed into the air cleaner or cause it to be drawn into the intake manifold. Who is correct? 4-While bleeding air from a cooling system: Technician A loosens a heater hose at its highest…arrow_forwardWhen condenser tubes become fouled, they may be cleaned by A. using a steel brush. B. using a brass brush. C. using a chisel and hammer. D. running a mixture of sand and water through them.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Electrical Transformers and Rotating MachinesMechanical EngineeringISBN:9781305494817Author:Stephen L. HermanPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Electrical Transformers and Rotating Machines
Mechanical Engineering
ISBN:9781305494817
Author:Stephen L. Herman
Publisher:Cengage Learning
The Refrigeration Cycle Explained - The Four Major Components; Author: HVAC Know It All;https://www.youtube.com/watch?v=zfciSvOZDUY;License: Standard YouTube License, CC-BY