Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 4, Problem 18MC
The boiling point of the coolant in an engines cooling system is raised by the
- thermostat
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Which of the following statements about PTC heaters is not true?
Some vehicles have a PTC heating element in the heater core.
Some vehicles have a PTC element installed in an air duct from the blower housing to increase the air temperature in the ducts.
PTC heaters are electronically controlled and work with the cooling system to provide hot coolant.
PTC elements are small ceramic stones that react quickly to changes in current.
Surface condensers allow the two fluids to mix, is the statement true or false
A 2 inch-diameter horizontal jet of water with a velocity of 20 ft/s relative to
the ground strikes a flat plate that is attached to a car moving at a velocity of
Ve. After it hits, the water splatters in all directions in the plane of the plate.
Investigate the effect of the car velocity V. on the force exerted on the plate.
Chapter 4 Solutions
Automotive Technology
Ch. 4 - Prob. 1SACh. 4 - Explain the four strokes of the internal...Ch. 4 - In addition to the battery, what does the charging...Ch. 4 - What is meant by the term regenerative braking?Ch. 4 - Which of the following is not a common emission...Ch. 4 - Automatic transmissions use a instead of a clutch...Ch. 4 - Which of the following is not one of the strokes...Ch. 4 - Prob. 4MCCh. 4 - Which is not a common automotive fuel? Gasoline...Ch. 4 - What does the valve train do? It delivers fuel to...
Ch. 4 - Technician A says that liquid cooling an engine...Ch. 4 - Prob. 8MCCh. 4 - Which emission control system introduces exhaust...Ch. 4 - Prob. 10MCCh. 4 - Technician A says that a transaxle delivers torque...Ch. 4 - Which of the following is not part of the running...Ch. 4 - Which of the following statements about unibody...Ch. 4 - Which type of transmission uses pulleys to change...Ch. 4 - Prob. 15MCCh. 4 - What two major engine components work together to...Ch. 4 - Technician A says that an air-conditioning system...Ch. 4 - The boiling point of the coolant in an engines...Ch. 4 - While discussing the operation of air-conditioning...Ch. 4 - Prob. 20MCCh. 4 - Which of the following is not accomplished by the...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that air in the system can cause excessive pressure within the system, restricting the refrigerants ability to change its state from gas to liquid within the refrigeration cycle. Technician B says that moisture can cause freeze-up at the cap tube or expansion valve, which restricts refrigerant flow or blocks it completely. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardTechnician A says that some refrigerant leaks can also be traced to pinholes in the evaporator caused by acid, which forms when water and refrigerant mix. Technician B says that leaks are most often found at the compressor hose connections and at the various fittings and joints in the system. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardTechnician A feels up and down the face or along the return bends of the condenser for a temperature change and says that there should be a gradual change from hot to warm from the bottom to the top. Technician B says that a restriction in the condenser will be evident by a sudden change in temperature. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forward
- While discussing an inoperative blend air door: Technician A says that to check the proper functioning of the ductwork, move the temperature control lever to see if any change at the doors occurs. If it does not, shut off the air conditioner and turn on the heater. Move the temperature control arm again to see if any change occurs. If not, check the cable and the flap door connected to the temperature control lever. Technician B says that in some cases you can reach under the dash to reconnect the cable or free a stuck flap. Who is right? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardTechnician A says that when the refrigerant is pumped out of the compressor and sent to the condenser, heat in the refrigerant is moved to the outside air by conduction and convection. Technician B says that the refrigerant leaves the bottom of the condenser as a high-pressure, high-temperature liquid. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardWhat special valve is used in a refrigerated air drier? A. Four-way valve B. Defrost valve C. Three-way valve D. Hot gas bypass valvearrow_forward
- how can a hermetic compressor be tested for efficiencyarrow_forwardWhich of the following statements is not true? A direct acting PRV: Is complex in construction, therefore can malfunction if a very small dirt gets trapped inside the valve, which may result in safety hazard Offers uneven flow Does not provide precise pressure control Causes more wastage of HP compared to a compound one Which of the following basic system components has the primary function of removing the heat of compression from the air? Receiver Relief valve Pressure regulator Dryer Aftercooler Which of the following statements is true? A single acting cylinder may have two ports at two different ends and pressurized fluid can be directed to both of them A single acting cylinder with two ports will can be used as a double acting cylinder A single acting cylinder may have two ports at two different ends but into only one of the ports pressurized fluid is being directed A single acting cylinder…arrow_forwardAn overheating vehicle is being discussed. Technician A states that coolant in a normal flow cooling system flows from the radiator to the heater core to warm up the passenger compartment quickly. Technician B states that in a reverse flow cooling system, coolant flows to the cylinder heads first, which keeps engine components at a more uniform temperature. Who is correct? Select one: a. Technician A only b. Technician B only c. Both Technicians A andB d. Neither Technician A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...Mechanical EngineeringISBN:9781305494695Author:Larry JeffusPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...
Mechanical Engineering
ISBN:9781305494695
Author:Larry Jeffus
Publisher:Cengage Learning
Hydronics Step by Step; Author: Taco Comfort Solutions;https://www.youtube.com/watch?v=-XGNl9kppR8;License: Standard Youtube License