The systematic names for the given compounds to be predicted. Concept introduction: 1. The cation is named before the anion. 2. Within a complex ion, the Ligands are arranged in an alphabetical order followed by the metal ion name. The anionic Ligand should ends with a letter –o, the neutral Ligand are called by the molecules (some common name for some exception). 3. When more Ligands are present, Greek prefixes like di, tri, tetra, penta, and hexa to specify their number. 4. The oxidation number of the metal is represented in roman numerals immediately following the metal ion name. 5. If the complex ion is an anion, the metal name should end with –ate.

Question

Want to see the full answer?

Answer 1

Question

Chapter 23, Problem 23.113P

(a)

Interpretation Introduction

Interpretation:

The systematic names for the given compounds to be predicted.

Concept introduction:

1. The cation is named before the anion.

2. Within a complex ion, the Ligands are arranged in an alphabetical order followed by the metal ion name. The anionic Ligand should ends with a letter –o, the neutral Ligand are called by the molecules (some common name for some exception).

3. When more Ligands are present, Greek prefixes like di, tri, tetra, penta, and hexa to specify their number.

4. The oxidation number of the metal is represented in roman numerals immediately following the metal ion name.

5. If the complex ion is an anion, the metal name should end with –ate.

(b)

Interpretation Introduction

Interpretation:

The systematic names for the given compounds to be predicted.

Concept introduction:

1. The cation is named before the anion.

2. Within a complex ion, the Ligands are arranged in an alphabetical order followed by the metal ion name. The anionic Ligand should ends with a letter –o, the neutral Ligand are called by the molecules (some common name for some exception).

3. When more Ligands are present, Greek prefixes like di, tri, tetra, penta, and hexa to specify their number.

4. The oxidation number of the metal is represented in roman numerals immediately following the metal ion name.

5. If the complex ion is an anion, the metal name should end with –ate.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Please correct answer and don't use hand rating

Don't used hand raiting

Reagan is doing an atomic absorption experiment that requires a set of zinc standards in the 0.4- 1.6 ppm range. A 1000 ppm Zn solution was prepared by dissolving the necessary amount of solid Zn(NO3)2 in water. The standards can be prepared by diluting the 1000 ppm Zn solution. Table 1 shows one possible set of serial dilutions (stepwise dilution of a solution) that Reagan could perform to make the necessary standards. Solution A was prepared by diluting 5.00 ml of the 1000 ppm Zn standard to 50.00 ml. Solutions C-E are called "calibration standards" because they will be used to calibrate the atomic absorption spectrometer. Table 1: Dilutions of Zinc Solutions Solution Zinc Solution Volume Diluted Solution Concentration used volume (ppm Zn) (mL) (mL) concentration (ppm Zn) Solution concentration A 1000 5.00 50.00 1.00×10² (ppm Zn(NO3)2) 2.90×10² Solution concentration (M Zn(NO3)2 1.53×10-3 B Solution A 5.00 100.00 5.00 C Solution B 5.00 50.00 0.50 7.65×10-6 D Solution B 10.00 50.00…