Concept explainers
A spherical shell has inner radius 3.00 cm and outer radius 7.00 cm. It is made of material with thermal
(b) Next, prove that
where T is in degrees Celsius and r is in meters. (c) Find the rate of energy transfer through the shell. (d) Prove that
where T is in degrees Celsius and r is in meters. (e) Find the temperature within the shell as a function of radius. (f) Find the temperature at r = 5.00 cm, halfway through the shell.
(a)
Answer to Problem 20.82CP
Explanation of Solution
The law of thermal conduction is,
Here,
The expression for the surface area of the sphere ism,
Substitute
Since the value of the coefficient of thermal conductivity is constant and the radius of the spherical surface is also constant. The thermal gradient becomes constant.
The rate of energy transfer is directly proportional to the thermal gradient. Since the thermal gradient is constant so the rate of energy transfer through the spherical surface is same.
Conclusion:
Therefore, the rate of energy transfer through the spherical surface is same because the temperature gradient is constant
(b)
To show: The given relation,
Answer to Problem 20.82CP
Explanation of Solution
Let the temperature is
Rearrange the equation (1) to prove the relation,
Integrate at both sides for temperature from
Conclusion:
Therefore, the equation,
(c)
Answer to Problem 20.82CP
Explanation of Solution
From the equation (1),
Integrate at both sides for temperature from
Conclusion:
Therefore, the rate of energy transfer through the shell is
(d)
To show: The given equation,
Answer to Problem 20.82CP
Explanation of Solution
Let the temperature is
Rearrange the equation (1) to prove the relation,
Integrate at both sides for temperature from
Substitute
Put the value of the
Conclusion:
Therefore, the equation,
(e)
Answer to Problem 20.82CP
Explanation of Solution
From the equation (1),
Integrate the above equation,
Conclusion:
Therefore, the temperature within the cell as a function of radius is
(f)
Answer to Problem 20.82CP
Explanation of Solution
From the equation (5),
Substitute
Conclusion:
Therefore, the temperature in spherical shell at radius.
Want to see more full solutions like this?
Chapter 20 Solutions
Physics for Scientists and Engineers, Technology Update (No access codes included)
- A multicylinder gasoline engine in an airplane, operating at 2.50 103 rev/min, takes in energy 7.89 103 J and exhausts 4.58 103 J for each revolution of the crankshaft. (a) How many liters of fuel does it consume in 1.00 h of operation if the heat of combustion of the fuel is equal to 4.03 107 J/L? (b) What is the mechanical power output of the engine? Ignore friction and express the answer in horsepower. (c) What is the torque exerted by the crankshaft on the load? (d) What power must the exhaust and cooling system transfer out of the engine?arrow_forwardAn ideal gas initially at 300 K undergoes an isobaric expansion at 2.50 kPa. If the volume increases from 1.00 m3 to 3.00 m3 and 12.5 kJ is transferred to the gas by heat, what are (a) the change in its internal energy and (b) its final temperature?arrow_forwardWhen a gas undergoes an adiabatic expansion, which of the following statements is true? (a) The temperature of the gas does not change. (b) No work is done by the gas. (c) No energy is transferred to the gas by heat. (d) The internal energy of the gas does not change. (e) The pressure increases.arrow_forward
- You have a spherical heater, outside diameter = 3.40 cm, immersed in a container of water. In order to keep the water in the container heated to a constant temperature of 35.0°C you adjust the temperature of the spherical heater. You reach a steady-state condition when the surface temperature of the spherical heater is at 79.0°C. Assuming the electrical efficiency of the heater is 100.0%, calculate the power required by the heater (i.e., calculate q). Ignore radiation.arrow_forwardCompressed air can be pumped underground into huge caverns as a form of energy storage. The volume of a cavern is 6.3 x 105 m³, 5 and the pressure of the air in it is 7.4 × 106 Pa. Assume that air is a diatomic ideal gas whose internal energy U is given by U = nRT. If one home uses 30.0 kWh of energy per day, how many homes could this internal energy serve for one day?arrow_forwardAn unknown substance has a mass of 0.125 kg and an initial temperature of 98.0\deg C. The substance is then dropped into a calorimeter made of aluminum containing 0.285 kg of water initially at 30.0\deg C. The mass of the aluminum container is 0.150 kg, and the temperature of the calorimeter increases to a final equilibrium temperature of 32.0\deg C . Assuming no thermal energy is transferred to the environment, calculate the specific heat of the unknown substance. _J/kg. \deg Carrow_forward
- A workshop with well-insulated walls and containing 800 m of air at 305 K is heated at constant pressure (atmospheric). Consider air to be an ideal diatomic gas. (a) Determine the energy (in k) required to increase the temperature of the air in the building by 2.90°C. kJ (b) Determine the mass (in kg) this amount of energy could lift through a height 3.10 m. kgarrow_forwardThe heat capacity of air at room temperature and pressure is approximately 21 J×mol-1×K-1. a) How much energy is required to raise the temperature of a room dimensions 5.5 m x 6.5 m x 3.0 m by 10°C from room temperature (298.15 K) assuming ideal behavior? b) How long will it take a heater rated at 1.5 kW to achieve that increase if 1 W = 1 J×s-1 (assuming no loss)?arrow_forwardThe specific heat of water is 4186 J/kg c°. How much does the internal energy of 200 g of water change as it is heated from 20°c to 30°c? Assume the volume is constant.arrow_forward
- An aluminum washer has an outer radius ro=1.3cm and an inner radius of ri=0.43cm. The temperature of the washer is raised from 282K to 630K. If the mass of the washer is 0.037g, the molar mass of aluminum is 26.98g/mol, and the molar specific heat of aluminum is 24.3J/mol-K, what is the change in the internal energy of the washer?arrow_forwardA test is conducted to determine the overall heat transfer coefficient in a shell-and-tube oil-to-water heat exchanger that has 24 tubes of internal diameter 1.2 cm and length 2 m in a single shell. Cold water (cp = 4180 J/kg·K) enters the tubes at 20°C at a rate of 3 kg/s and leaves at 55°C. Oil (cp = 2150 J/kg·K) flows through the shell and is cooled from 120°C to 45°C. Determine the overall heat transfer coefficient Ui of this heat exchanger based on the inner surface area of the tubes.arrow_forwardA class of 13 students taking an exam has a power output per student of about 200 W. Assume the initial temperature of the room is 20°C and that its dimensions are 7.0 m by 17.4 m by 3.0 m. What is the temperature of the room at the end of 1.0 h if all the energy remains in the air in the room and none is added by an outside source? The specific heat of air is 1.01 ✕ 103 J/kg · °C, and its density is about 1.2 10-3 g/cm3. Carrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning