The work done for an adiabatic expansion of an ideal gas with number of moles 2.50 mol, initial pressure 2.25 bar, initial and final temperature 450 K and 300 K respectively needs to be determined. The expression for the work done in the isothermal reversible expansion of gas needs to be written at initial pressure 2.25 bar and the value of pressure for the same value of w calculated above needs to be determined. Concept Introduction: In thermodynamics , a reversible process can be defined as the process which can be reversed back to its original state. Hence in reversible processes, both the system and surroundings are returned to their initial states. In general, all reversible processes are ideal processes and cannot occur naturally. On the contrary, an irreversible process cannot come back to its initial condition. All spontaneous processes in nature are irreversible processes. In an adiabatic process, the heat change is zero therefore the work done will be equal to the change in the internal energy.

Question

Want to see the full answer?

Answer 1

Question

Chapter 2, Problem 2.8NP

Interpretation Introduction

Interpretation:The work done for an adiabatic expansion of an ideal gas with number of moles 2.50 mol, initial pressure 2.25 bar, initial and final temperature 450 K and 300 K respectively needs to be determined. The expression for the work done in the isothermal reversible expansion of gas needs to be written at initial pressure 2.25 bar and the value of pressure for the same value of w calculated above needs to be determined.

Concept Introduction: In thermodynamics, a reversible process can be defined as the process which can be reversed back to its original state.

Hence in reversible processes, both the system and surroundings are returned to their initial states. In general, all reversible processes are ideal processes and cannot occur naturally.

On the contrary, an irreversible process cannot come back to its initial condition. All spontaneous processes in nature are irreversible processes.

In an adiabatic process, the heat change is zero therefore the work done will be equal to the change in the internal energy.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

at 32.0 °C? What is the osmotic pressure (in atm) of a 1.46 M aqueous solution of urea [(NH2), CO] at 3 Round your answer to 3 significant digits.

Reagan is doing an atomic absorption experiment that requires a set of zinc standards in the 0.4-1.6 ppm range. A 1000 ppm Zn solution was prepared by dissolving the necessary amount of solid Zn(NO3)2 in water. The standards can be prepared by diluting the 1000 ppm Zn solution. Table 1 shows one possible set of serial dilutions (stepwise dilution of a solution) that Reagan could perform to make the necessary standards. Solution A was prepared by diluting 5.00 ml of the 1000 ppm Zn standard to 50.00 ml. Solutions C-E are called "calibration standards" because they will be used to calibrate the atomic absorption spectrometer. a. Compare the solution concentrations expressed as ppm Zn and ppm Zn(NO3)2. Compare the concentrations expressed as M Zn and M Zn(NO3)2 - Which units allow easy conversion between chemical species (e.g. Zn and Zn(NO3)2)? - Which units express concentrations in numbers with easily expressed magnitudes? - Suppose you have an analyte for which you don't know the molar…

None