The triple point temperature of bismuth is 544.5 K and the normal boiling point is 1832 K. Imagine that a 1.00 mol sample of bismuth is heated at a constant rate of 1.00 kJ min-1 in an apparatus in which the sample is maintained under a constant pressure of 1 atm. In the manner shown in Figure 12-24 and as much to scale as possible, that is in terms of times and temperatures, sketch the heating curve that would be obtained in heating the sample from 300 K to 2000 K. Use the following data.
Want to see the full answer?
Check out a sample textbook solutionChapter 12 Solutions
General Chemistry: Principles and Modern Applications (11th Edition)
- The vapor pressure of ethanol, C2H5OH, at 50.0 C is 233 mmHg, and its normal boiling point at 1 atm is 78.3 C. Calculate the vapH of ethanol.arrow_forwardDescribe the behavior of a liquid and its vapor in a closed vessel as the temperature increases.arrow_forwardA 1.50-g sample of methanol (CH3OH) is placed in an evacuated 1.00-L container at 30 C. (a) Calculate the pressure in the container if all of the methanol is vaporized. (Assume the ideal gas law, PV = nRT.) (b) The vapor pressure of methanol at 30 C is 158 torr. What mass of methanol actually evaporates? Is liquid in equilibrium with vapor in the vessel?arrow_forward
- Equilibrium vapor pressures of benzene, C6H6, at various temperatures are given in the table. (a) What is the normal boiling point of benzene? (b) Plot these data so that you have a graph resembling the one in Figure 11.12. At what temperature does the liquid have an equilibrium vapor pressure of 250 mm Hg? At what temperature is the vapor pressure 650 mm Hg? (c) Calculate the molar enthalpy of vaporization for benzene using the ClausiusClapeyron equation.arrow_forwardThe heats of vaporization of liquid O2, liquid Ne, and liquid methanol, CH3OH, are 6.8 kJ/moL 1.8 kJ/mol, and 34.5 kJ/mol, respectively. Are the relative values as you would expect? Explain.arrow_forward8.87 Use the vapor pressure curves illustrated here to answer the questions that follow. (a) What is the vapor pressure of ethanol (C2H5OH) at 60°C? (b) Considering only carbon disulfide (CS2) and ethanol, which has the stranger intermolecular forces in the liquid state? (c) At what temperature does heptane (C7H16) have a vapor pressure of 500 mm Hg? (d) What are the approximate normal boiling pains of each of the three substances? (e) At a pressure of 400 mm Hg and a temperature of 70°C, is each substance a liquid, a gas, or a mixture of liquid and gas?arrow_forward
- Use Figure 11.7 to estimate the boiling point of carbon tetrachloride, CCl4, under an external pressure of 250 mmHg.arrow_forwardConsider the following data for the vapor pressure of diethyl ether, a widely used anesthetic in the early days of surgery. Follow the instructions in Question 13 to estimate the heat of vaporization of diethyl ether.arrow_forwardReferring to Figure 9.7, state what phase(s) is/are present at (a) 1 atm, 100C. (b) 0.5 atm, 100C.(c) 0.8 atm. 50C.arrow_forward
- When I mole of benzene is vaporized at a constant pressure of 1.00 atm and at its boiling point of 353.0 K, 30.79 kJ of energy (heat) is absorbed and the volume change is +28.90 L. What are E and H for this process?arrow_forwardChloroform, CHCl3, has a normal boiling point of 61C. Its vapor pressure at 43C is 0.526 atm. What is the concentration (in g/L) of CHCl3 when it saturates the air at 27C?arrow_forwardThe phase diagram for water over a relative narrow pressure and temperature range is given in Figure 9.19. A phase diagram over a considerably wider range of temperature and pressure (kbar) is given nearby. This phase diagram illustrates the polymorphism of ice, the existence of a solid in more than one form. In this case, Roman numerals are used to designate each polymorphic form. For example, Ice I, ordinary ice, is the form that exists under ordinary pressures. The other forms exist only at higher pressures, in some cases extremely high pressure such as Ice VII and Ice VIII. Using the phase diagram, give the approximate P and T conditions at the triple point for Ice III, Ice V, and liquid water. Determine the approximate temperature and pressure for the triple point for Ices VI, VII, and VIII. What is anomalously different about the fusion curves for Ice VI and Ice VII compared to that of Ice I? What phases exist at 8 kbar and 20 °C? At a constant temperature of −10 °C, start at 3 kbar and increase the pressure to 7 kbar. Identify all the phase changes that occur sequentially as these conditions change. Explain why there is no triple point for the combination of Ice VII, Ice VIII, and liquid water.arrow_forward
- Chemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningWorld of Chemistry, 3rd editionChemistryISBN:9781133109655Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCostePublisher:Brooks / Cole / Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage Learning