A schematic diagram for the given control system is to be prepared. Also, all the controlled variables, manipulated variables, and disturbance variables should be labeled. Concept introduction: A control system is a system that regulates or monitors the behavior or working of other devices/systems using control loops. It can be used to control single devices or large industrial processes. Schematic representation of this control system using symbols, lines, and all the controlled, manipulated, and disturbance variables are known as control system diagrams. Controlled variables (CVs) are the process variables that can be controlled, and its desired value is known as the set point. Manipulated variables (MVs) are the process variables that are adjusted by the controller to keep its value close to the set point. Disturbance variables (DVs) are the process variablesthat affect the controlled variables. But, it is important to note that they cannot be manipulated and are associated with any changes in the operating environment of the ongoing process.

Question

Please show all work

Answer 1

Question

Chapter 1, Problem 1.2E

Interpretation Introduction

Interpretation:

A schematic diagram for the given control system is to be prepared. Also, all the controlled variables, manipulated variables, and disturbance variables should be labeled.

Concept introduction:

A control system is a system that regulates or monitors the behavior or working of other devices/systems using control loops. It can be used to control single devices or large industrial processes.

Schematic representation of this control system using symbols, lines, and all the controlled, manipulated, and disturbance variables are known as control system diagrams.

Controlled variables (CVs) are the process variables that can be controlled, and its desired value is known as the set point.

Manipulated variables (MVs) are the process variables that are adjusted by the controller to keep its value close to the set point.

Disturbance variables (DVs) are the process variablesthat affect the controlled variables. But, it is important to note that they cannot be manipulated and are associated with any changes in the operating environment of the ongoing process.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

Please show all work

2. A moving bed adsorption column needs to be designed to separate hydrophobic proteins from a fermentation broth. The following adsorption equilibrium data was observed in preliminary isotherm studies. The resin used was activated carbon with a porosity of 0.2. The overall mass transfer coefficient was determined to be 10 h¹, and the ratio of volumetric flow rate of broth to resin is 10. Determine the diameter of the column if the column height is limited to 2.5 m (indoor operation) with a flow rate of 20 m³/h, influent concentration of 7 g/L, and effluent concentration of 0.1 g/L. qi (mg/kg) Ci (g/L) 0.1 4.7 7.5 0.25 10.6 0.5 15.0 1.0 23.7 2.5 33.5 5.0 41.1 7.5

3. You are given a mixture of four proteins, whose properties are listed in the table below. Propose a process to purify each protein so that you end up with four solutions of pure protein. What resin would you use to bind the protein(s)? What changes to the buffer would you make to desorb the protein(s)? Contains an N-terminal His6-tag. Two 50 kDa subunits contain a non-heme Fe2+ in the active site. Protein Size (kDa) pl Specific Properties A 100 6.0 B 40 7.7 C 240 8.3 Ꭰ 225 5.5 Contains FAD redox center and an NADH binding domain. Composed of six 40-kDa subunits, each of which contains a [2Fe-2S] cluster. Composed of three subunits: 100 kDa structural subunit, 75 kDa subunit with a molybdopterin center, and 50 kDa subunit with FAD and an NADH binding domain.