A 4 − m × 5 − m × 6 − m and room is to be heated by one ton (1000 kg) of liquid water contained in a tank placed in the room. The room is losing heat to the outside at an average rate of 10,000 kJ/h. The room is initially at 20 o C and 100 kPa and is maintained at an average temperature of 20 o C and at all times. If the hot water is to meet the heating requirements of this room for a 24-h period, determine the minimum temperature of the water when it is first brought into the room. Assume constant specific heats for both air and water at room temperature.
A 4 − m × 5 − m × 6 − m and room is to be heated by one ton (1000 kg) of liquid water contained in a tank placed in the room. The room is losing heat to the outside at an average rate of 10,000 kJ/h. The room is initially at 20 o C and 100 kPa and is maintained at an average temperature of 20 o C and at all times. If the hot water is to meet the heating requirements of this room for a 24-h period, determine the minimum temperature of the water when it is first brought into the room. Assume constant specific heats for both air and water at room temperature.
Solution Summary: The author calculates the average rate of heat loss from the room, which is 10000kJ/h.
A
4
−
m
×
5
−
m
×
6
−
m
and room is to be heated by one ton (1000 kg) of liquid water contained in a tank placed in the room. The room is losing heat to the outside at an average rate of 10,000 kJ/h. The room is initially at
20
o
C
and 100 kPa and is maintained at an average temperature of
20
o
C
and at all times. If the hot water is to meet the heating requirements of this room for a 24-h period, determine the minimum temperature of the water when it is first brought into the room. Assume constant specific heats for both air and water at room temperature.
Q.1) Block A is connected to block B by a pulley
system as shown. The weights of blocks A and B
are 100 lbs and 70 lbs, respectively. Assume
negligible friction between the rope and all pulleys
as well as between block B and the incline and
neglect the mass of all pulleys and cables.
Determine the angle 0 required to keep the system
in equilibrium. (At least two FBDs must be drawn
for full credit)
B
Ꮎ
000
pls solve
+1.
0,63 fin
r= 0.051
P
The stepped rod in sketch is subjected to a tensile
force that varies between 4000 and 7000 lb. The
rod has a machined surface finish everywhere except
the shoulder area,
where a grinding operation has
been performed to improve the fatigue resistance
of the rod. Using a 99% probability of survival,
determine the safety factor for infinite life if
the rod is made of AISI 1080 steel, quenched
and tempered at 800°c Use the Goodman line.
Does the part fail at the fillet? Explain
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.