Xd=20% XT=8% XL = 15 St OH! **** 100 MVA 1 20/66 kV 20 kV 100 MVA G 2 XT-10% M H 3 20 MW/ 66 kV P.F=0.8 Lag. All Sub transient reactance Xd" are expressed in percentage. The motor is operating at full load with lagging pow 0.8. Assume the a three phase fault occurs through bus 2. calculate the fault current in per unit. Choose 20 kV as the voltage base for generator and 100-MVA base.

Xd=20% XT=8% XL = 15 St OH! **** 100 MVA 1 20/66 kV 20 kV 100 MVA G 2 XT-10% M H 3 20 MW/ 66 kV P.F=0.8 Lag. All Sub transient reactance Xd" are expressed in percentage. The motor is operating at full load with lagging pow 0.8. Assume the a three phase fault occurs through bus 2. calculate the fault current in per unit. Choose 20 kV as the voltage base for generator and 100-MVA base.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Under short circuit, the reactance's of the synchronous generator during the steady state condition are following, Leakage reactance(X)= 0.15 ohm and Armature reactance (Xad) = 0.68 ohm The direct axis synchronous (steady state) reactance (Xa) is
Consider the system shown in the single-line diagram of Figure (3). All reactances are shown in per unit to the same base. Assume that the voltage at both sources is 1 p.u. a Find the fault current due to a bolted- three-phase short circuit at bus 3 b- Find the fault current supplied by each generator and the voltage at each of the buses 1 and 2 under fault conditions 0.06 p.u. 0.2 p.u. 0.04 p.u. 0.25 p.u. 0.2 p.u. 0.2 p.. 0.2 p.u. 0.06 p.u. 0.25 p.u. Figure (3) Single-line diagram ele ver ele 888 ele 0.06 p.u. 0.25 p.u.
-The symmetrical fault occurs in the terminals of the synchronous generator. Find the direct axis transient reactance of the synchronous generator under the transient period for the data given below, Leakage reactance(Xl)= 1.3 ohm, Armature reactance (Xad)= 1.6 ohm and field reactance (Xf)=5.4 ohm. 2.10 2.53 1.23 4.00 -The existing condition of the power system can be determined by _____________ analysis. Short Circuit Stability Power Flow Transient
A 600 KVA generator with X"a = 0.22 per unit is connected to a bus through a circuit breaker, as shown in the following figure. Connected through circuit breakers to the same bus are three synchronous motors rated 200 KVA, 2.5 KV, 1.0 power factor, with X"a = 0.15 per unit. The motors are operating at full load, unity power factor and rated voltage, with the load equally divided among the machines. (a) Find the rated symmetrical short-circuit current in Amperes, which must be interrupting breakers A and B for a fault at point P. Simplify the calculations by neglecting the Prefault current. M. GHA B
Under short circuit, the reactance’s of the synchronous generator during the steady state condition are following, Leakage reactance(Xl)= 0.11 ohm and Armature reactance (Xad)= 0.7 ohm The direct axis synchronous (steady state) reactance (Xd) is
urgent please
A cylindrical rotor generator delivers 0.5 pu power in the steady-state to an infinite bus through a transmission line of reactance 0.5 pu. The generator no-load voltage is 1.5 pu and the infinite bus voltage is 1 pu. The inertia constant of the generator is 5 MW-s/MVA and the generator reactance is 1 pu. The critical clearing angle, in degrees, for a three-phase dead short circuit fault at the generator terminal is
A resistance of 8 Ohms is used to ground a 30-MVA, 11 kV alternator. Its relay is set to operate when a 2.2 A out of balance current occurs. The CTs have a ratio of 1000/6. If we consider the reactance of the alternator to be negligible, how much percentage of the stator winding is protected against earth faults? To make this 95%, what is the minimum value of earthing resistance to be used?
CT - 2 :Solve all parts.
0 A 25 MVA, 11 kV, 3-phase alternator has x = 0.25 pu, Z₂ = 0.3 pu and Zo = 0.2 pu. It's neutral is solidly grounded, A single line to ground fault occurs at the terminals of the alternator. The fault current will be?
Primary protection Determine the suitable unit protection scheme for the following faults/probems: Fault Inter-turn fault in power transformer power transformers Ground fault in the wye-side of delta-wye power transformer Harmonics due to Inrush current in Locked rotor in induction motor Under voltage in induction motor Over speeding in synchro-generator 1 2 3 4 5 6
The figure shows the single line diagram of a single machine infinite bus system. O Infinite bus The inertia constant of the synchronous generator H = 5 MW-s / MVA. Frequency is 50 Hz. Mechanical power is 1 pu. The system is operating at the stable equilibrium point with rotor angle ō equal to 30°. A three phase short circuit fault occurs at a certain location on one of the circuits of the double circuit transmission line. During fault, electrical power in pu is Pmax sin ō. If the values of ō and do / dt at the instant of fault clearing are 45° and 3.762 radian/s respectively, then Pmax (in pu) is_