Use the graphic below to answer the following questions regarding gas chromatography:cyclohexane/aceloneAll unit =cm15-a-pinene h-3.81.2air peak10-myrcene h=1.1(R)(+)-limonene h=1.|AA0-100150500.Time (s)(36.1, 5 69)Potential (mV) Which terpene has an area of 1.32cm??Choose...What is the total area of terpene peaks in cm2? Enter 3 significant figures in your answer and nounits.Choose...Which terpene has the shortest retention time?Choose...Which terpene has the highest boiling point?Choose...Which terpene has a percent composition of 35%?Choose...

Note: Since you have posted a question with multiple subparts, we will solve the first three…

Which terpene has an area of 1.32cm2? Choose... What is the total area of terpene peaks in cm2? Enter 3 significant figures in your answer and no units. Choose... Which terpene has the shortest retention time? Choose...

Which terpene has an area of 1.32cm2? Choose... What is the total area of terpene peaks in cm2? Enter 3 significant figures in your answer and no units. Choose... Which terpene has the shortest retention time? Choose...

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: Compare the old (Boot's method) and new (Green) syntheses of Ibuprofen in the light of Green…

A: Let's discuss about the Comparision of Synthesis of ibuprofen by Boot's method and green synthesis .

Q: same Rf

A: Paper chromatography is the simplest technique to separate the colored compounds, polar-non polar…

Q: Which is the more effective extraction technique, single or multiple extractions? Explain.

A: Extraction is a process for separating chemicals based on differences in solubility in two…

Q: magine you were separating acetophenone from hydroquinone. Would you expect acetophenone to be the…

A: We know Acetophenone is less polar than hydroquinone, as a result, acetophenone would be the top…

Q: In Thin Layer Chromatography，why does the least polar of the analytes （biphenyl）have a higher Rf…

Q: If a compound appears single spotted on a TLC, it indicates that the compound is

A: The technique of separating components present in the mixture is termed as chromatography.…

Q: - Suppose you had separated the A and B chains of insulin by disulfide reduction. What…

A: Insulin is an endocrine hormone that control the blood sugar levels. This hormone contains two…

Q: Chemistry 1)Arrange the following in order of increasing Rf in TLC? 3-pentanone, 3-pentanol,…

A: As you post multiple question we are supposed to answer the only one question. Kindly repost…

Q: Every spot on a student's TLC plate has an Rf value from 0.1 to 0.2. The student used a 10% ethyl…

A: Rf factor means retardation factor is defined as : Rf = Distance travelled by component/Distance…

Q: 10. A racemic mixture of (R)- and (S)- citalopram (figure 4) needs to be separated by liquid…

A: I have answered all the questions with proper answers along with explanations. Kindly check it…

Q: She performed a normal phase chromatography to separate the components of an extract. She then…

A: Thin layer chromatography (TLC) and Rf factor

Q: Based on the TLC plate shown below, what was the error made? O The eluent used was too polar The…

A: TLC i.e. thin layer chromatography is used to identify the components of reaction mixture, depending…

Q: 44 R 0.50 R 0.30 No, the Rf values are too close together O No, there should be more lanes on the…

Q: Using chemical structures, illustrate the differences in weak intermolecular interactions that would…

Q: A student runs a TLC plate of a mixture of four compounds. The TLC plate is shown below. How could…

A: Thin layer chromatography is a chromatographic method for the separation of the components in a…

Q: 3. Fill in the quantities of reagents used in this experiment. Compound density, g/mL bromobenzene…

A: Given compound used in experiment Bromobenzene used 0.10 μL with density 1.50 g/mL Diethyl ether…

Q: If the flow rate of the carrier gas in a GC instrument is 60 mL per minute and a compound has a…

Q: acetophenone from hydroquinone. Would you expect acetophenone to be the top or bottom spot on the…

A: We know that tha stronger a compound is bound to adsorbent, the slower it moves up in the TLC plate.…

Q: 1. a. A sample consisting of 1-bromopropane and 1-chloropropane is injected into a gas chromatograph…

A: To answer: 1. a.) A sample consisting of 1-bromopropane and 1-chloropropane is injected into a gas…

Q: 6 The left-hand TLC below was your first attempt to separate two compounds. You picked ethyl…

Q: the solvent system us mn?

A: Chromatography is a technique for the separation of a mixture into its components. In this…

Q: Consider the following errors that could be made when running TLC. Indicate what should be done to…

A: TLC is a useful technique for separating and analyzing mixtures, but it requires careful attention…

Q: Chromatography A student in lab used chromatography to separate the pigments present in an extract…

A: Introduction : We have to calculate retention factor .

Q: Name of experiment : Gas Chromatography (GC);Separation of alcohols Q1:Purpose of experiment…

A: Ans. Gas chromatography: Gas chromatography (GC): Separation of alcohols (1) Purpose of experiment:…

Q: Strength powder contains acetaminophen, aspinn and caffeine as the active in nts. Oketa bel a TLC…

Q: Finally, what if you have a chromatogram of an amine (polar) and an ether (fairly non-polar). Would…

A: As we know, Like dissolves like that means polar compound are soluble in polar solvent while…

Q: In this experiment, you will be performing TLC on your 'crude' and 'recrystallized' biphenyl…

A: In the above experiment, TLC of crude and recrystalline biphenyl Is performed. In crude products…

Q: Compound X was developed on a TLC plate using a given eluent. The compound had a Rf value of 0.93…

A: The retention factor Rf is the distance travelled by the compound from the origin divided by the…

Q: You can perform a TLC experiment even if the solvent level is above the level of the initial spots.…

A: Here I have solved the question

Q: A single analysis using chromatography produced a chromatogram with three peaks. The peak for…

A: Since you have asked a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Did you see any components that didn’t match the reference compounds? How do you know? If you didn’t…

Q: A quick experiment was done in the Essential Oil University Lab, New Albany, IN, to ascertain if the…

A: The significant difference in the odor of each blend can be attributed to the fact that essential…

Q: 6. Which compound has the greater ? (300 nm is a greater than 250 m.) .0 and "NH 10 and b. NH, 01-0…

Q: 6. Which statement is true regarding the Re-value in TLC- Chromatography? a. The more polar the…

A: Basic information regarding TLC chromatography: In TLC, adsorbent used is usually polar (ex silica…

Q: Pretending that you got the following TLC result: A. Which is more polar? SA or C? B. Is the…

A: Given Chromatogram of compound SA and C.

Q: In an experiment of Reverse Phase chromatography using C-18 stationary phase and a mixture of…

Q: . Answer true or false for each statement: a) A TLC analysis is sufficient to characterize the…

A: a) False. TLC analysis can provide some information about the purity of a compound, but it is not…

Q: b. Answer the questions about the compounds below. تھر علم A OH B i) Which compound would have the…

Q: if you wanted to makes the spots travel up the TLC plate further, what solvent ration would you…

A: You know that ethyl acetate is a polar solvent while hexane is a non-polar solvent.

Q: OH OH а з НО.

A: KMnO4 stain is excellent for functional groups which are sensitive to oxidation. Alkenes and alkynes…

Q: n a gas chromatogram, the retention time of compounds A and B are 1.25 min and 1.45 min,…

A: Retention time is described as the time taken by the solute to pass through the chromatography…

Q: A mixture of tert-butylbenzene and acetophenone is adsorbed onto a silica gel chromatography column…

A: Answer is given below

Q: You have 100 mL of solvent available to do an extraction. Which will give a better separation? O A.…

Question

Which terpene has an area of 1.32cm??
Choose...
What is the total area of terpene peaks in cm2? Enter 3 significant figures in your answer and no
units.
Choose...
Which terpene has the shortest retention time?
Choose...
Which terpene has the highest boiling point?
Choose...
Which terpene has a percent composition of 35%?
Choose...

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

what can be used to measure the amount of ascorbic acid in vitamin c? A. mass spectroscopy method. B. UV-Vis method C. paper Chromatography D. gravimetric method
Both melting points and TLC rely on differences in non covalent forces. Explain the role of these non-covalent interactions in the final answer obtained (melting point and Rf value).
The following chromatographic peaks indicate the undesirable interaction and separation that taken place. Explain in detail how these undesirable interaction and separation happen for each chromatographic peak. b с d a
3. Draw a hypothetical TLC plate that has a ketone standard (with 6 carbons), an alcohol standard (with 6 carbons), and an unknown in separate lanes. The unknown is actually the alcohol but it is impure with the ketone.
Put all steps (below) of a TLC analysis in a correct order. Write the two main visualization methods as titles a. Developing the Plate b. Calculating Rf Values c. Spotting the TLC Plate Visualizing the Results e. Preparing the Sample f. Picking a Solvent
If you ran an unknown sample on a TLC using 3-Methyl-Pentane as eluent and observed only one spot with a Rf value -0.05, is it safe to assume that it is a pure compound? If not, how can you check it out using TLC?
1. Why is a calibration curve necessary for this analytical technique? 4
Draw a GC chromatogram for a 50:50 and 25:75 mixtures of hexane (bp 68°C) and toluene (bp 111°C).
Effect of analyte polarity on the Rf of an analyte on silica TLC. a) Which is more polar, benzoic acid or acetanilide? b) What effect does the polarity of the analyte have on the Rf?
Chemistry written by hand.
1. Which property of compounds is responsible for the separation in a TLC? Explain with an example.2. How does the separation occur during a TLC? (Hints: TLC plate and silica layer)
2) Consider the following compounds. Which rankings list these compounds in terms of Rf from lowest to highest using a silica gel thin layer chromatography plate and 1:1 Ethyl Acetate:Hexanes as the developing solvent. (e. g. A