When the switch in the figure is closed, the current takes 3.00 ms to reach 98.0% of its final value. If R = 11.50 , what is the inductance?
Q: An LR circuit is hooked up to a battery which the switch initially open. The resistance in the…
A: Formula of current passing through the LR circuit is as follows: I=VsR1-e-tRL…
Q: 7. (a) In the figure, R = 10.00 N, C = 6.66 µF, and L = 52.0 mH, and the ideal battery has emf =…
A:
Q: An emf of 0.80 Vv is induced across a coil when the current through it changes uniformly from 0.30…
A:
Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…
A: Given: V=6.00 vL=4.80 mH =4.80*10-3 HR=2.60 ohm
Q: A circuit is constructed with four resistors, one inductor, one battery and a switch as shown. The…
A:
Q: me h = 0.500 mm, w = 1.00 mm, and e = 3.00 mm. What is the mutual inductance (in pH) for this…
A: Assume h = 0.500 mm, w = 1.00 mm, and = 3.00 mm. Consider a strip at a x distance from the wire…
Q: A 50 m long coaxial cable has an inductance of 32 μH. The coaxial cable is made of insulation of μ =…
A:
Q: What's the self-inductance of a solenoid with 317 loops wrapped around a cylinder. The cylinder has…
A: If L be the self-inductance, A be the area of cross=section. N be the number of turns, l be the…
Q: Problem 4: Suppose a 55 cm long, 12 cm diameter solenoid has 1000 loops. Part (a) Calculate the…
A:
Q: The battery terminal voltage in the figure below is E = 6.60 V and the current I reaches half its…
A:
Q: E R M switch In the circuit shown in the figure above a generator supplies a voltage of E(t) = 60…
A: Voltage Inductance Resistance At , current Current after seconds
Q: switch as shown. The values for the resistors are: R1 = R2 = 39 0, R3 = 62 N and R4 = 126 N. The…
A:
Q: Problem 2: An air-core solenoid has N = 1100 turns, d= 0.85 m length, and cross sectional area A =…
A: We are required to express the inductance of the solenoid, L, in terms of N,d and AHere, N is number…
Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…
A: Introduction: RL circuit is a circuit which consists of Inductors and Resistors combinations and…
Q: Problem 275. Two metal spheres of radius R are placed at a very large distance from each other, and…
A:
Q: When the 20.5 A current through an inductor is turned off in 1.55 ms, an 810 V emf is induced,…
A:
Q: For physics lab, two students constructed an RL circuit similar to the one shown in the figure, with…
A:
Q: In the circuit shown in the figure, the inductor has inductance L = 4.00 H and negligible internal…
A:
Q: The switch in the circuit shown in the figure has been open for a long time. The resistors in the…
A:
Q: 3. Consider the circuit shown below. The switch S is closed for a very long time so that the current…
A:
Q: 7-turn solenoid has a radius of 7.25 mm and an overall length of 15.0 cm. (a) What is its…
A:
Q: 4. A capacitor C is charged to a voltage V and connected to an inductor L as shown in the figure…
A: The voltage across the inductor is given by the formula, VL=LdIdt (1)…
Q: The circuit shown in the diagram has a switch which is turned on at time t = 0, and it is known that…
A: Given, Q0=2.0 μCC=1.0 nFL=10.0 μH
Q: A solenoid having an inductance of 5.00 µH is connected in series with a 1.17 k resistor. (a) If a…
A:
Q: Consider an L-R circuit as shown in the figure. (Figure 1) The battery provides 12.0 V of voltage.…
A: Given- Voltage V= 12.0 V Resistance R = 150 Ω
Q: Consider the circuit shown in the figure below where L = 5.10 mH and R₂ = 410 0. L vor 24.0 V + a S…
A: Given : L=5.10mH R2=410ohm tau=14.9mu.s To find: R1 and I
Q: The self-inductance of the circuit in the figure below is 1.10 x 10-7H. Find the back emf when the…
A: Given: The inductance of the circuit is 1.1x10-7 H. The rate of current increasing at the rate of…
Q: Starting with emf2 = -M ΔI1/ Δt , show that the units of inductance are (V . s)/A = Ω.s .
A: Given: Starting with emf2 = -M ΔI1/ Δt , show that the units of inductance are (V . s)/A = Ω.s
Q: R switch In the circuit shown in the figure above a battery supplies a constant voltage of E=30V,…
A:
Q: A solenoid is 10 cm long and 3 cm in diameter. It consists of 100 turns of wire. What is the…
A:
Q: 4.30 2 3. In the circuit the emf ɛ = 190 volts and the inductance L= 34.6 mH. What will be the…
A:
Q: In an oscillating RLC circuit, R = 5.0ohm, L = 5.0 mH, and C = 500 uF. What is the angular frequency…
A:
Q: Consider the circuit shown in the figure below. Take & = 6.00 V, L = 7.92 mH, and R = 4.40 N. S R…
A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…
Q: A 510-turn solenoid has a radius of 8.00 mm and an overall length of 14.0 cm. What is its…
A: Solution:-Given thatNumber of turns (N)=510Radius (R)=8 mm=0.008 mOverall length (L)=14 cm=0.14 m
Q: In the circuit shown in (Figure 1), the battery and the inductor have no appreciable internal…
A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…
Q: What is the energy stored in the inductor shown in the figure after the switch has been closed for a…
A:
Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…
A: As per guidelines only 3 subparts are solved here.
Q: A 10-turn ideal solenoid has an inductance of (3.9x10^-3) H. To generate an EMF of (1.16x10^0) V…
A: Given , N = 10 L = 3.9 ×10-3 H e (emf ) = 1.16 V Here we have to find rate of change of the…
Q: A circuit consists of a battery with E=50.0 V, two resistors R;=30.02, R;=15.0Q, and an inductor…
A: Given: ε=50.0 V R1=30.0 Ω R2=15.0 Ω L=0.3 H
Q: For L1=19 H, L2=13 H, L3=19 H, L4=32 H, L5-77 H, L6-39 H, L7=12 H & L8=58 H in the circuit shown…
A: Equivalent inductance
Q: Att = 0, the switch K is quickly closed. Calculate the voltage on the inductor at t = 0+. Note that…
A:
Q: time intérval, and zero potential difference is measured across the capacitor. After the switch is…
A:
Q: The closed circuit shown below (same as #1) has a resistor of 5 Ω, an inductor of 6 mH, and a…
A:
Q: Consider the RL circuit shown in the figure, where R = 19.8 Q. The switch S is closed at t = 0. At t…
A: Given, R = 19.8 Ωswitch is closed at t = 0 sec, at t = 3.00 ms I = 96.3% of Io
When the switch in the figure is closed, the current takes 3.00 ms to reach 98.0% of its final value. If R = 11.50 , what is the inductance?
I already solved the question, but I want to know how to get that answer.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps