In the circuit shown in (Figure 1), the battery and the inductor have no appreciable internal resistance and there is no current in the circuit. Assume that R= 15.5 and L = 12.0 mH. Figure S 25.0 V L elle 1 of 1 Part A Immediately after the switch is closed, find the reading of the ammeter (A). Express your answer in amperes. IVE ΑΣΦ I₁ = Submit Part B V₁ = Request Answer Submit Immediately after the switch is closed, find the reading of the voltmeter (V₁). Express your answer in volts. 15. ΑΣΦ ? Request Answer A ? V

In the circuit shown in (Figure 1), the battery and the inductor have no appreciable internal resistance and there is no current in the circuit. Assume that R= 15.5 and L = 12.0 mH. Figure S 25.0 V L elle 1 of 1 Part A Immediately after the switch is closed, find the reading of the ammeter (A). Express your answer in amperes. IVE ΑΣΦ I₁ = Submit Part B V₁ = Request Answer Submit Immediately after the switch is closed, find the reading of the voltmeter (V₁). Express your answer in volts. 15. ΑΣΦ ? Request Answer A ? V

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 55P: How long after switch S1 is thrown does it take the current in the circuit shown to reach half its...

See similar textbooks

Similar questions

A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
At what time is the voltage across the inductor of the RL circuit of Figure 14.12(b) a maximum?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
A 120-V, series-wound motor has a field resistance of 80 and an armature resistance of 10. When it is operating at full speed, a back emf of 75 V is generated, (a) What is the initial current drawn by the motor? When the motor is operating at full speed, where are (b) the current drawn by the motor, (c) the power output of the source, [ d) the power output of the motor, and (e) the power dissipated in the two resistances?
The current in the RL circuit shown here increases to 40% of its steady-state value in 2.0 s. What is the time constant of the circuit?
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?