For physics lab, two students constructed an RL circuit similar to the one shown in the figure, with & 6.00 V, L 7.80 mH, and R = 7.60 0. = S ww (a) What is the inductive time constant of the circuit (in ms)? ms ele (b) Calculate the current in the circuit (in A) 250 us after the switch is closed. (c) What is the value of the final steady-state current (in A)? A ms EASURE 12 Ron 2200 (d) After what time interval (in ms) does the current reach 80.0% of its maximum value? CORE 40

For physics lab, two students constructed an RL circuit similar to the one shown in the figure, with & 6.00 V, L 7.80 mH, and R = 7.60 0. = S ww (a) What is the inductive time constant of the circuit (in ms)? ms ele (b) Calculate the current in the circuit (in A) 250 us after the switch is closed. (c) What is the value of the final steady-state current (in A)? A ms EASURE 12 Ron 2200 (d) After what time interval (in ms) does the current reach 80.0% of its maximum value? CORE 40

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 66P: The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F ,...

See similar textbooks

Related questions

Q: What percentage of the final current I0 flows through an inductor L in series with a resistor R,

Q: E R M switch In the circuit shown in the figure above a generator supplies a voltage of E(t) = 60…

A: Voltage Inductance Resistance At , current Current after seconds

Q: A 70 μF capacitor with a 13 μC charge is connected across a 18 mH inductor. What is the charge on…

A: a

Q: a. Consider the current configuration shown below. What is the magnitude of the cur- rent in the…

Q: For Transformer winding1 N131000 turns, N2= 200 turns and V1=220 Volts, secondary resistance of 22…

A: Solution:-Given thatFor Primary windings;N1=1000 turnsN2=200 turnsV1=220 voltsFor Secondary…

Q: An RLC circuit has source εo cosωt, where εo= 10.0 V. R = 201ohms and L = 902 mH and C = 2.01 μF.…

A: Given, εo= 10.0 V. R = 201ohms and L = 902 mH and C = 2.01 μF.

Q: Part E Find the reading of the voltmeter (V₁) after the switch has been closed for a very long time.…

Q: Problem 6: An RL circuit is shown on the right. L 2.4 H. R 49 Ω.e 7.5 V Part (a) Switch A is closed…

A: When Switch A is closed and B is open, it is a simple RL circuit with a dc voltage source. Thus, the…

Q: a circuit having an inductance of L=2mH has a current that varies with time as I=t^3e^-t. find the…

A: Emf induced can be given by, ∈=LdIdt where L is inductance and I is current and t is time. To be…

Q: A 506-turn solenoid has a radius of 7.80 mm and an overall length of 12.6 cm. (a) What is its…

A: Given, Number of turns, n=506 radius =7.80 mm length =12.6 cm a. When a coil whose length is much…

Q: inductor: € == dI dt Lenz's Law: The induced EMF will fight the change in current through an - Ld…

A: Since you posted two questions, we will solve only first question and for the solutions of other…

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed…

A: Given data,

Q: This LR circuit has time constant named tau, T, and maximum current, If = V/R . Which one of the…

Q: An inductor L=47 H is connected in series with a resistor R=25 ohms and a voltage source V=12 V and…

A: Inductance,L=47 H Resistance, R=25 ohm Voltage,v=12 volt

Q: If the current in an inductor is doubled, by what factor is the stored energy multiplied?

A: If the current in an inductor is doubled, by what factor is the stored energy multiplied?

Q: In the given circuit an inductor of L = 6.20-mH and a resistor of R = 12.4-2 resistor are connected…

A: Since, Voltage across inductor VL = Ee-Rt/L So voltage across resistance VR = E - Ee-Rt/L

Q: The current in the RL circuit shown below reaches half its maximum value in 1.72 ms after the switch…

A: Time = 1.72 ms L. = 132 mH R =?

Q: J: Refer to figure la 2.0m conductor is shown, that rotates at 1200 rev/min in the radial field B =…

A: The formula to calculate the induced emf of given by the following expression, ε=-AdBdt where B is…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

For physics lab, two students constructed an RL circuit similar to the one shown in the figure, with & = 6.00 V,
L 7.80 mH, and R = 7.60 0.
R
www
Ⓡ
(a) What is the inductive time constant of the circuit (in ms)?
ms
ele
(b) Calculate the current in the circuit (in A) 250 us after the switch is closed.
A
A
(c) What is the value of the final steady-state current (in A)?
A
ms
(d) After what time interval (in ms) does the current reach 80.0% of its maximum value?
40

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given information

VIEW

Step 2: Solution to time constant and current at 250us is given

VIEW

Step 3: Solution toSteady state current and time when 80% of maximum current reach is provided

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
What is the resistance R in the circuit shown below if the amplitude of the ac through the inductor is 4.24 A?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
What is the self-inductance of an LC circuit that oscillates at 60 Hz 1ien the capacitance is 10 F ?
A transformer is used to supply a 12-V model train with power from a 110-V wall plug. The train operates at 50 W of power, (a) What is the rms current in the secondary coil of the transformer? (b) What is me rms current in the primary coil? (c) What is the ratio of the number of primary to secondary turns? (d) What is the resistance of the tram? (e) What is the resistance seen by the 110-V source?
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
The current in the RL circuit shown here increases to 40% of its steady-state value in 2.0 s. What is the time constant of the circuit?
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
A solenoid 50 cm long is wound with 500 turns of wire. The cross-sectional area of the coil is 2.0 cm2. What is the self-inductance of the solenoid?
An ac source of emf delivers 5.0 mW of power at an rms current of 2.0 mA when it is connected to the primary cod of a transformer. The rms voltage across the secondary coil is 20 V. (a) What are die voltage across the primary coil and the current through the secondary coil? (b) What is the ratio of secondary to primary turns for the transformer?