What is the maximum shear stress? Where or = -140 Mpa, σy = 205 Mpa, Try = 100 Mpa. joy Try 8. THU a) 100 MPa b) 160 MPa c) 200 MPa d) 210 MPa 18 d

Q: Problem 4 The horizontal force of p 85 kN acts at the end of the plate. The plate has a thickness of…

A:

Q: If the output torque on the CD shaft is T ́ = 75 N-m and the motor rotates at 175 rpm, determine the…

A: Given for CD shaft    diameter d2=35 mm, radius of gear R2=125 mmand torque T2=75 N-mfor EA shaft…

Q: The couple M acts in a vertical plane and is applied to a beam oriented as shown. Determine the…

A:

Q: Determine the a) magnitude load P to be applied, and b) the normal stress on plane AB and the…

A:

Q: If a moment, M=10 ft-kips, is applied to the cross-section about its strong axis, what is the…

A: solve question part g and h, all require data such as depth of neutral axix and moment of inertia…

Q: Question 2) In the system given in the figure, a distributed load of w=85 kN/m acts on the rod AB of…

A:

Q: 4Kips 10 KIPS 0.5 in.diam. 1in diam. lokips 8kips 0.75 in diam.

A: for First segment Dia = 0.5 in.     Load = 4kips for Second segment Dia = 1in.    Load = 14 kips…

Q: A solid circular bar is fixed at point A. Thebar is subjected to transverse load V = 70 lb andtorque…

A:

Q: The internal shear force V at a certain section of an aluminum beam is 8.2 kN. If the beam has the…

A:

Q: Part A 0.25 in. 5 in. 1 in. 0.25 in -0.25 in. 2.5 in. Determine the maximum axial force P that can…

A: Thickness =0.25inAllowable stress=22.4 ksi

Q: The couple M = 78 kip-in. is app section shown in a plane formin vertical. Determine the stress at…

A:

Q: Upvote will be given. Please write the solutions legibly. Solve in 2 decimal places. A 10 KN 10 KN…

A: A simply supported beam is loaded as followsmax shear stress=?max flexural stress=?crossection :…

Q: W B P Assume that the Beam is all the same material. Calculate Q (that we use in the shear stress…

A: The answer has been attached in the form of an image as follows:

Q: Find the Normal Stress at points A, B, and C in the Rod below. Dimensions given are diameters. 1 in.…

A:

Q: The principal stresses are incorrect but the maximum shear stress is correct.  What are the two…

A: Compressive stress is the force that deforms the material in a way that reduces the volume of the…

Q: Consider the element in with Tay = 30 MPa. 80 MPa Part A Txy

A:

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.