Water flows through a turbine as shown in figure, where the pipeline upstream of the turbine has a 2 diameter of 1.2m and the downstream pipeline has a diameter of 1.7m. The inflow section of the upstream pipeline is 4 m above the outflow section of the downstream pipeline. When the flow through the turbine is 6 m'/s. the pressure at the inflow section is 450 kPa, the pressure at the outflow section is -30 kPa, and the head loss between these two sections is estimated as 20 m. What is the power being delivered to the turbine?

Q: Pump Horsepower in Brine System. A pump pumps 0.200 ft3/s of brine solution having a density of 1.15…

A: Solution-The given values are as follows Q=0.200ft3/s=200ft3/sDensity ρ=1.15g/cm3∑F=18ft…

Q: Example: A pump take brine solution at a tank and transport it to another in a process plant…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: A large reservoir contains air at a temperature of T = 10 °C and absolute pressure of p= 450 kPa.…

A: Absolute pressure(p)=450 kPa Temperature(T)=10oc Friction factor=0.03 Specific heat ratio(k)=1.40

Q: Benzene at 37.8 °C is pumped through the system of Figure at the rate of 0.1515 m3/min. The…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: A pump delivers water at a flow of 10 cubic feet per second (cfs) from a lower reservoir to an upper…

A: Discharge  Q=10 ft3/s=0.283168 m3/sec     diameter d=16 in=1.33 ftarea A=π4×d2=π4×16122=1.396 ft2…

Q: 1. In figure 3, water at 10°C is flowing from section 1 to section 2. At section 1, which is 25 mm…

A: Given data in question  Diameter  Velocity  Pressure at 1 To find out Pressure at point 2

Q: Friction loss in pumping oil to pressurized tank an oil having a density of 833 kg/m3 and a…

A: Oil density=833 kg/m3 Viscosity=3.3x103 Ns/m2 Steel pipe nominal size=3 inch Pump efficiency=65%

Q: Problem 5 Gasoline having a specific gravity of 0.8 is flowing in the pipe shown at a rate of 5…

A: Given that,Area at section 1 = 0.8 ft^2Area at section 2 = 0.2 ft^2Flow rate Q = 5 ft^3/sHead loss =…

Q: A closed cylindrical tank filled with water has a hemispherical dome and is connected to an inverted…

A:

Q: A pump draws water from reservoir A and lifts it to reservoir B as shown in Figure below. The loss…

A: Output power through the pump will be calculated by applying the energy equation between point A and…

Q: A lubricating oil of specific gravity 0.85 and dynamic viscosity 0.01 kgf-sec/m² is pumped through a…

A:

Q: Three new cast-iron pipes connected in series have diameters of 30 cm, 25 cm, and 20 cm, each being…

A: Given data  Diameter  Discharge  Minor loss To find Total head loss EGL & HGL

Q: At two points 1 and 2 in a pipeline the velocities are V and 2V, respectively. Both the points are…

A:

Q: The pressure in a 3 cm diameter pipe is 400 kPa. What is the velocity of flow in the pipe

A:

Q: A cylindrical tank with its axis horizontal has a length of 6 m and the ends of the tank are…

A:

Q: In a vertical pipe conveying oil of specific gravity 0.8, two pressure gauges have been installed at…

A:

Q: A pressure gage at elevation 12 m at the side of the tank containing liquid reads 100 kPa. Another…

A:

Q: Three pipes of 400 mm, 350 mm and 300 mm diameter are connected in series between two reservoirs…

A: step 1-

Q: Water at 20°C is pumped at a rate of 15 L/s into a reservoir as shown in the Figure below. Between…

A: The rate of flow into the pipe, Q = 15L/sThe diameter of the pipe, D = 100mmThe length of the pipe…

Q: A pump draws water from a 200 mm suction pipe and delivers it to a 150 mm discharge pipe in which…

A:

Q: A valve is suddenly closed in 200 mm diameter pipe. The increase in pressure is 700 kPa. Assuming…

A: d=200mm P=70kPa

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.