A closed cylindrical tank filled with water has a hemispherical dome and is connected to an inverted piping system as shown in Figure 5. The liquid in the top part of the piping system has a specific gravity of 0.8, and the remaining parts of the system are filled with water. If the pressure gage reading at A is 60 kPa, determine (a) the pressure in pipe B (b) the pressure head, in millimetres of mercury, at the top of the dome (point C).

Q: Question: The pressure pipe elbow with 30 degree orientation in the vertical plane is 60 cm in…

A: Solution

Q: Calculate the surface tension of the fluid (SG = 8.6) in the capillary tube below: Зтт h = 2mm e =…

A:

Q: Determine the pressure at the center of the pipe from the piezometer shown. 200mm WATER 75mmØPIPE

A: Given:- a piezo meter is attached to the pipe as shosn below

Q: An 8 in diameter (f=0.028) 500 ft long discharge a 3 in diameter water jet into the atmosphere at a…

A: Using the continuity equation calculating the jet velocity: AV=AjVj…

Q: power output of the motor?

A:

Q: The discharge flowing down the pipe is 0.03 m3/s and the pressure at 2 is 20kPa. Assuming the losses…

A:

Q: 11.34. If the pressure at point A in the figure is 300 kPa, compute the volume flow rate of water at…

A: Pressure at Point A =300 kPa

Q: Calculate the X length that can keep the gate closed. The gate is hinged from point A. The pressure…

A:

Q: Q4. The tank is filled with aqueous ammonia (ammonium hydroxide) to a depth of 3 ft. The remaining…

A:

Q: Q2) What is the pressure at point (B)inside the pipe shown in figure below if the water jet velocity…

A: Given data in question  Diameter Velocity  Elevation  To find out  Pressure at B

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

A: Specific gravity of oil in pipe A (S1) = 0.9Specific gravity of oil in pipe B S2 = 1.2Difference in…

Q: 6. Find the capillary rise in the tube for a mercury-air-glass interface with 0 = 130° if the tube…

A:

Q: Water flows from the tank shown in the figure below. At a depth of 1.5 ft the rate of change of…

A:

Q: An open cylindrical tank contains two liquids with a specific gravities and depths as follows:…

A:

Q: D washer (2) n holes of diameter D. To reduce water consumption, a washer is installed in the shower…

A: Velocity in the pipe without reducer at section 1 and at the outlet (considering it as 2):…

Q: A pressure gage at elevation of 12m at the side of the tank containing liquid reads 100 kPa. Another…

A:

Q: Oil of specific gravity 0.82 flows through an orifice at the vertical side of a closed cylindrical…

A:

Q: Water flows steadily downward through the pipe shown in the figure below. Viscous effects are…

A:

Q: EL 7 m (s, -0,75) EL 4.5 m EL 4.35 (s2 - 1.00) EL 2.15 EL 2 m (s3 1.50) EL O

A: The pressure at a different level, P = γH. γ - Unit weight of the fluid.H - Head of the fluid.…

Q: Water 0.4m A 0.8m Mercury

A:

Q: . The value of unknown pressure Pis

A: Given data,  The pressure gauges G1 and G2 installed on the system showpressure of,  PG1=5.00 bar…

Q: (Flow through Single Pipes). Determine the flow in each pipe and the pressure at the junction node,…

A: g= 9.81m/s2 =32.19ft/s2

Q: H.W(2):Water flows steadily from a large tank through a pipe that splits into two smaller pipes as…

A: Given data in question  Water Depths Diameter  To find out  Pressure at point 1 Discharge through…

Q: Water flows from the ground floor to the third floor in a 4-storey building through a pipe 50 mm in…

A: Discharge, Q=2 L/s Diameter of the pipe, D=50 mm Roughness coefficient, k=0.03 mm Opening diameter…

Q: (3) Water jet 0.05 m- (2) 0.8 m •(1) 8X.X kPa 0.1 m Figure Q2 (b) (i) Determine the flow rate at the…

A:

Q: The triangular valve (AB) which weighs 1500 Newtons closed at point A and is free at point B. What…

A: Length of the gate t=2sin50o=2.6108 m Depth of center of gravity from surface of water…

Q: Calculate the X length that can keep the gate closed. The gate is hinged from point A. The pressure…

A:

Q: A pressurized tank discharges its alcohol through a square orifice (c = 0.64, cy = 0.97). If minor…

A: step 1-

Q: 1. For the frictionless syphon shown, determine the discharge and the pressure heads at A and B.…

A:

Q: The fluid in the tank is water. Flow is steady state, incompressible and nonviscid. It is known that…

A: Using the Bernoulli's equation between the tank and the point 1 -  Patmρg + v122g + Z1 = P1ρg +…

Q: Pipe 1 which is 100 mm in diameter and 350 m long is in parallel to pipe 2 which is 300 m long. Pipe…

A:

Q: The ligure shoWs a tank discharging through a pipe with a nozzle at Its end. Find the discharge and…

A:

Q: Q. A fountain consists of a horizontal inlet pipe with a cross-sectional area, A1, which enters a…

A: Figure is as shown

Q: The open tank with piezometers attached on the side, contains two different liquids. Find the…

A: As the liquid in piezometer A and liquid in tank above the installation point of piezometer A is…

Q: A mixture of high pressure water and steam at a rate of 0.5 kgs-¹ flows up a vertical tube with an…

A: A vertical tube is basically used for carrying high-pressure water and steam at a specific pressure…

Q: Q1: A pressure of 10 kPa, gage, is applied to th surface of water in an enclosed tank as showi in…

A: to find actual discharge

Q: The figure shows an inlet and outlet connected to a motor. If the pressure at A is 6.25 MPa and the…

A: step 1-

Q: taining air and water is shown. At the closed end of the manometer the air pressure is 16…

A:

Q: An oil of specific gravity 0.82 is flowing through a horizontal venturimeter fitted to a 278 mm…

A:

Q: the time required for the depth of the liquid in the tank to decrease by 1m.

A: given data volume of tank

Q: An 8 in diameter (f=0.028) 500 ft long discharge a 3 in diameter water jet into the atmosphere at a…

A: Given :

Q: -8.33 -0.12 8.33 (1) 0.12 -L Darcy Experiment A set-up of Darcy Experiment involves measuring the…

A: Given data  Hydraulic head at section-1 (h1) = 66cm  Hydraulic head at section-2 (h2) = 54cm  Length…

Q: Water is pumped up from a reservoir to a smaller holding tank. If the flow rate through the pipe is…

A: NPSH is the net positive suction head, which is measured in the centrifugal pump.If the local…

Q: B: A closed cylindrical tank filled with water has a hemispherical dome and is connected to an…

A: Asked: To determine the pressure in pipe B and the pressure head, in millimeters of mercury, at…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?