TWO IDENTICAL LINKAGE-AND-HYDRAULIC-CYLINDER SYSTEMS CONTROL THE POSITION OF THE FORKS OF A FORK-LIFT TRUCK. THE LOAD SUPPORTED BY THEONE SYSTEM SHOWN IS 6750 N. KNOWING THAT THE THICKNESS OF MEMBER BD IS 16 MM, DETERMINE (A) THE AVERAGE SHEARING STRESS IN 13 MM DIAMETER PIN AT B, (B) THE BEARING STRESS AT B IN MEMBER BD.

TWO IDENTICAL LINKAGE-AND-HYDRAULIC-CYLINDER SYSTEMS CONTROL THE POSITION OF THE FORKS OF A FORK-LIFT TRUCK. THE LOAD SUPPORTED BY THEONE SYSTEM SHOWN IS 6750 N. KNOWING THAT THE THICKNESS OF MEMBER BD IS 16 MM, DETERMINE (A) THE AVERAGE SHEARING STRESS IN 13 MM DIAMETER PIN AT B, (B) THE BEARING STRESS AT B IN MEMBER BD.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please show intermediate steps including free body diagrams, equations used, problem setup etc. so that your approach can be followed
Solve fast please
! Required information Problem 01.061 - A two link assembly with point loads Two horizontal 13-kip forces (P) are applied to pin B of the assembly shown. A 0.8-in. diameter pin is used at each connection. 0.3 in 0.5 in 18 in Problem 01.061.c - Bearing stress in a link Determine the average bearing stress at Bin member BC The average bearing stress at Bin member BC is 24.65 ksi.
Link AC is made of a steel with a 65-ksi ultimate normal stress and has a xin. uniform rectangular cross section. It is connected to a support at A and to member BCD at C by-in.-diameter pins, while member BCD is connected to its support at B by a -in.-diameter pin. All of the pins are made of a steel with a 25-ksi ultimate shearing stress and are in single shear. Knowing that a factor of safety of 3.75 is desired, determine the largest load P that can be applied at D. Note that link AC is not reinforced around the pin holes. 16 IN 8 in 16. ---4 in- The largest load P that can be applied at Dis[ lb.